Si-Dong Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Si-Dong Li has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
Kui Xu
Agriculture Ministry Key Laboratory of Natural Rubber Processing, South China Tropical Agricultural Product Processing Research Institute, P.O. Box 318, Zhanjiang 524001, PR China
3 shared publicationsChen Wang
Agricultural Ministry Key Laboratory of Natural Rubber Processing, P.O. Box 318, Zhanjiang 524001, China
2 shared publicationsJie-Ping Zhong
Agriculture Ministry Key Laboratory of Natural Rubber Processing, South China Tropical Agricultural Product Processing Research Institute, P.O. Box 318, Zhanjiang 524001, PR China
2 shared publicationsDan Yang
Basic Science Department, Zhanjiang Ocean University, Zhanjiang 524088, China
1 shared publicationDe-Min Jia
1 shared publicationGuang Lu
Agriculture Ministry Key Laboratory of Natural Rubber Processing, South China Tropical Agricultural Product Processing Research Institute, P.O. Box 318, Zhanjiang 524001, People's Republic of China
1 shared publication
Latest Publications
- 9 February 2004
- Published by Elsevier in Thermochimica Acta
- Vol. 410 (1-2) , 119-124
Studies of thermooxidative degradation process of chlorinated natural rubber from latex
- 9 February 2004
- Published by Elsevier in Thermochimica Acta
- Vol. 410 (1-2) , 119-124
Studies of thermooxidative degradation process of chlorinated natural rubber from latex
- 27 August 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 90 (5) , 1227-1232
Thermooxidative degradation of methyl methacrylate-graft-natural rubber
- 27 August 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 90 (5) , 1227-1232
Thermooxidative degradation of methyl methacrylate-graft-natural rubber
- 3 December 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 87 (6) , 982-985
Reinforcement of natural rubber latex film by ultrafine calcium carbonate
Using ultrafine calcium carbonate to reinforce natural rubber latex film, the effect of its content on latex properties such as surface tension, viscosity, mechanical stability, and heat stability and the physical properties of latex film before and after aging such as tear strength, modulus, and tensile strength were investigated. The results showed that the surface tension of natural rubber latex reinforced by ultrafine calcium carbonate only changed slightly; when the content of calcium carbonate was less than 20%, the change of viscosity was not obvious, but when the content was greater than 20%, the viscosity significantly lowered. Ultrafine calcium carbonate could effectively improve the tear strength, tensile strength, and modulus of the natural rubber latex film. The modulus increased with the increment of the calcium carbonate. When the content of calcium carbonate was less than 15%, the tear strength and tensile strength increased with the increments of calcium carbonate, but when the content was greater than 15%, the above‐mentioned properties decreased with the increment of calcium carbonate. By comprehensive consideration, the best reinforcing effect was obtained at a content of 15% ultrafine calcium carbonate. The particle diameters of calcium carbonate and their distribution in the calcium carbonate emulsion and in the rubber film were analyzed with SEM and a laser particle size tester, which showed that the distribution of calcium carbonate in the latex film was even and that it could effectively reinforce natural rubber latex film. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 87: 982–985, 2003
- 3 December 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 87 (6) , 982-985
Reinforcement of natural rubber latex film by ultrafine calcium carbonate
Using ultrafine calcium carbonate to reinforce natural rubber latex film, the effect of its content on latex properties such as surface tension, viscosity, mechanical stability, and heat stability and the physical properties of latex film before and after aging such as tear strength, modulus, and tensile strength were investigated. The results showed that the surface tension of natural rubber latex reinforced by ultrafine calcium carbonate only changed slightly; when the content of calcium carbonate was less than 20%, the change of viscosity was not obvious, but when the content was greater than 20%, the viscosity significantly lowered. Ultrafine calcium carbonate could effectively improve the tear strength, tensile strength, and modulus of the natural rubber latex film. The modulus increased with the increment of the calcium carbonate. When the content of calcium carbonate was less than 15%, the tear strength and tensile strength increased with the increments of calcium carbonate, but when the content was greater than 15%, the above‐mentioned properties decreased with the increment of calcium carbonate. By comprehensive consideration, the best reinforcing effect was obtained at a content of 15% ultrafine calcium carbonate. The particle diameters of calcium carbonate and their distribution in the calcium carbonate emulsion and in the rubber film were analyzed with SEM and a laser particle size tester, which showed that the distribution of calcium carbonate in the latex film was even and that it could effectively reinforce natural rubber latex film. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 87: 982–985, 2003
- 5 November 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 87 (2) , 199-204
Pyrolysis GC-MS of chlorinated natural rubber
- 5 November 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 87 (2) , 199-204
Pyrolysis GC-MS of chlorinated natural rubber
- 18 July 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 85 (14) , 2952-2955
Thermogravimetric analysis of methyl methacrylate‐graft‐natural rubber
The thermal degradations of methyl methacrylate‐graft‐natural rubber (MG) at different heating rates (B) in nitrogen were studied by thermogravimetric analysis. The results indicate that the thermal degradation of MG in nitrogen is a one‐step reaction. The degradation temperatures increase along with the increment of heating rates. The temperature of initial degradation (T0) is 0.448B + 362.4°C, the temperature at maximum degradation rate, that is, the peak temperature on a differential thermogravimetric curve (Tp) is 0.545B + 380.7°C, and the temperature of final degradation (Tf) is 0.476B + 409.4°C. The degradation rate at Tp is not affected by B, and its average value is 48.9%; the degradation rate at Tf is not affected by B either, and its average value is 99.3%. The reaction order (n) is 2.1 and is not affected by B. The reaction activation energy (E) and the frequency factor (A) increase along with B, and the apparent reaction activation energy (E0) is 254.6 kJ/mol. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 2952–2955, 2002
- 18 July 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 85 (14) , 2952-2955
Thermogravimetric analysis of methyl methacrylate‐graft‐natural rubber
The thermal degradations of methyl methacrylate‐graft‐natural rubber (MG) at different heating rates (B) in nitrogen were studied by thermogravimetric analysis. The results indicate that the thermal degradation of MG in nitrogen is a one‐step reaction. The degradation temperatures increase along with the increment of heating rates. The temperature of initial degradation (T0) is 0.448B + 362.4°C, the temperature at maximum degradation rate, that is, the peak temperature on a differential thermogravimetric curve (Tp) is 0.545B + 380.7°C, and the temperature of final degradation (Tf) is 0.476B + 409.4°C. The degradation rate at Tp is not affected by B, and its average value is 48.9%; the degradation rate at Tf is not affected by B either, and its average value is 99.3%. The reaction order (n) is 2.1 and is not affected by B. The reaction activation energy (E) and the frequency factor (A) increase along with B, and the apparent reaction activation energy (E0) is 254.6 kJ/mol. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 2952–2955, 2002
- 7 June 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 85 (8) , 1736-1741
Blends of natural rubber latex and methyl methacrylate‐grafted rubber latex
- 7 June 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 85 (8) , 1736-1741
Blends of natural rubber latex and methyl methacrylate‐grafted rubber latex