Linda A. Domeier
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Linda A. Domeier has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
A. M. Morales
Sandia National Laboratories Livermore, CA 94551, USA
1 shared publicationApril Nissen
Sandia National Laboratories, Livermore, California 94550
1 shared publicationJ. Hachman
Sandia National Laboratories Livermore, CA 94551, USA
1 shared publicationJ. M. Hruby
Sandia National Laboratories Livermore, CA 94551, USA
1 shared publicationJames McElhanon
Sandia National Laboratories, Livermore, California 94550
1 shared publicationLeRoy Whinnery
Sandia National Laboratories, Livermore, California 94550
1 shared publication
Latest Publications
- 3 November 2009
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 115 (6) , 3217-3229
Thermomechanical characterization of thermoset urethane shape‐memory polymer foams
- 3 November 2009
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 115 (6) , 3217-3229
Thermomechanical characterization of thermoset urethane shape‐memory polymer foams
- 19 September 2008
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 110 (6) , 3973-3984
Material morphology and electrical resistivity differences in EPDM rubbers
Electrical resistance anomalies noted in EPDM gaskets have been attributed to zinc‐enriched surface sublayers, about 10‐μm thick, in the sulfur cured rubber material. Gasket over‐compression provided the necessary connector pin contact and was also found to cause surprising morphological changes on the gasket surfaces. These included distributions of zinc oxide whiskers in high pressure gasket areas and cone‐shaped features rich in zinc, oxygen, and sulfur primarily in low pressure protruding gasket areas. Such whiskers and cones were only found on the pin side of the gaskets in contact with a molded plastic surface and not on the back side in contact with an aluminum surface. The mechanisms by which such features are formed have not yet been defined. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008
- 19 September 2008
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 110 (6) , 3973-3984
Material morphology and electrical resistivity differences in EPDM rubbers
Electrical resistance anomalies noted in EPDM gaskets have been attributed to zinc‐enriched surface sublayers, about 10‐μm thick, in the sulfur cured rubber material. Gasket over‐compression provided the necessary connector pin contact and was also found to cause surprising morphological changes on the gasket surfaces. These included distributions of zinc oxide whiskers in high pressure gasket areas and cone‐shaped features rich in zinc, oxygen, and sulfur primarily in low pressure protruding gasket areas. Such whiskers and cones were only found on the pin side of the gaskets in contact with a molded plastic surface and not on the back side in contact with an aluminum surface. The mechanisms by which such features are formed have not yet been defined. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008
- 1 May 2002
- Published by Springer Nature in Microsystem Technologies
- Vol. 8 (2-3) , 78-82
Microscreen-based replication of electroforming micromolds
- 1 May 2002
- Published by Springer Nature in Microsystem Technologies
- Vol. 8 (2-3) , 78-82
Microscreen-based replication of electroforming micromolds