Michael Hess
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Michael Hess has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Byung-Wook Jo
Department of Polymer Engineering and Science and Department of New Materials in Biology, Chosun University, 375, Seosok-dong, Dong-gu, KwangJu, 501-759, South Korea
5 shared publications Jung-Sun Sohn
Department of Polymer Engineering and Science, and Department of New Materials in Biology, Chosun University, 375, Seosok-dong, Dong-gu, KwangJu, 501-759, South Korea
4 shared publicationsManfred Zähres
Department of Physical Chemistry, University Duisburg-Essen, Campus Duisburg, 47048 Duisburg, Germany
3 shared publications- Betty Lucy López
Grupo Ciencia de los Materiales, Instituto de Química, Universidad de Antioquia, A.A: 1226, Medellín, Colombia; Fax 57-4-2330120
2 shared publications Kirsten Schwark
Department of Physical Chemistry, University Duisburg-Essen, Campus Duisburg, 47048 Duisburg, Germany
2 shared publications- Soo-Kyung Choi
School of Medicine, Chosun University Medical School, Gwangju 61452, Republic of Korea
2 shared publications
Latest Publications
- Open Access
- 1 December 2005
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 5 (1)
Calorimetric investigation of the phase behaviour of the binary system 7-mPEG 5000-succinyloxymethyloxycarbonyl- Paclitaxel (PP7)/water
Paclitaxel is an antineoplastic agent derived from the bark of the Pacific Yew Tree ( Taxus brevifolia ). Oral administration of the pure drug is problematic as it has a poor absorption due to its poor solubility in aqueous media. A specific water-soluble prodrug - PP7 - has been introduced by coupling the drug with a water-soluble polymer. For any kind of medical application and administration, knowledge of the binary isobaric phase-diagram is important since it gives information about solubility, phase transitions and the corresponding compositions. The system PP7 + H 2 O was studied calorimetrically from -20°C and shows the typical behaviour of an eutectic system. The properties of the phase diagram are discussed in view of other solution properties of the system presented earlier.
- 1 December 2005
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 5 (1)
Open AccessCalorimetric investigation of the phase behaviour of the binary system 7-mPEG 5000-succinyloxymethyloxycarbonyl- Paclitaxel (PP7)/water
Paclitaxel is an antineoplastic agent derived from the bark of the Pacific Yew Tree ( Taxus brevifolia ). Oral administration of the pure drug is problematic as it has a poor absorption due to its poor solubility in aqueous media. A specific water-soluble prodrug - PP7 - has been introduced by coupling the drug with a water-soluble polymer. For any kind of medical application and administration, knowledge of the binary isobaric phase-diagram is important since it gives information about solubility, phase transitions and the corresponding compositions. The system PP7 + H 2 O was studied calorimetrically from -20°C and shows the typical behaviour of an eutectic system. The properties of the phase diagram are discussed in view of other solution properties of the system presented earlier.
- 1 May 2005
- Published by Wiley in Macromolecular Symposia
- Vol. 225 (1) , 31-42
Effects of Polymer Modification of an Anti-Cancer Drug with Poly(ethylene oxide)
- 1 May 2005
- Published by Wiley in Macromolecular Symposia
- Vol. 225 (1) , 31-42
Effects of Polymer Modification of an Anti-Cancer Drug with Poly(ethylene oxide)
- 1 March 2005
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 9 (1) , 13-14
Polymer Modification Of An Anti-Cancer Drug: Effects Of Hydrophilization
- 1 March 2005
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 9 (1) , 13-14
Polymer Modification Of An Anti-Cancer Drug: Effects Of Hydrophilization
- Open Access
- 1 December 2004
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 4 (1) , 248-254
Room temperature Monte Carlo study of the mechanical properties of thermoplastic polymers
The effect of the tensile test rate upon the mechanical properties of semicrystalline high-density polyethylene (HDPE) is studied by the Monte Carlo method. A two-dimensional lattice model is used, which considers first and second neighbour's interactions between CH 2-CH 2 groups. Metropolis dynamics is implemented as energy minimization tool. Results reveal the existence of two distinguishable regions in the stress-strain curves. One of them is characterized by an elastic and linear behaviour below 0.27% of deformation where the elastic modulus is practically insensitive to the number of Monte Carlo steps, whereas at higher deformation the system exhibits a non-linear behaviour ascribed to the viscoelastic character of the material endorsed by a clear dependence of the relaxation modulus as a function of the strain rate. The relaxation behaviour of HDPE obtained in our simulation shows an exponential decrease of the stress as time increases, which agrees with experimental data.
- 1 December 2004
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 4 (1) , 248-254
Open AccessRoom temperature Monte Carlo study of the mechanical properties of thermoplastic polymers
The effect of the tensile test rate upon the mechanical properties of semicrystalline high-density polyethylene (HDPE) is studied by the Monte Carlo method. A two-dimensional lattice model is used, which considers first and second neighbour's interactions between CH 2-CH 2 groups. Metropolis dynamics is implemented as energy minimization tool. Results reveal the existence of two distinguishable regions in the stress-strain curves. One of them is characterized by an elastic and linear behaviour below 0.27% of deformation where the elastic modulus is practically insensitive to the number of Monte Carlo steps, whereas at higher deformation the system exhibits a non-linear behaviour ascribed to the viscoelastic character of the material endorsed by a clear dependence of the relaxation modulus as a function of the strain rate. The relaxation behaviour of HDPE obtained in our simulation shows an exponential decrease of the stress as time increases, which agrees with experimental data.
- Open Access
- 1 December 2004
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 4 (1) , 288-297
Synthesis and characterization of a pressure-sensitive adhesive based on an isobutyl acrylate / 2-ethylhexyl acrylate copolymer
A removable pressure-sensitive adhesive was obtained by free-radical emulsion polymerization. The product is a low-viscosity copolymer from different polar and apolar acrylic monomers consisting of microspheres of about 1 µm diameter. 2-Ethylhexyl acrylate and isobutyl acrylate were used as non-polar constituents while acrylic acid and acrylamide provided the more polar constituents to regulate the cohesive force of the adhesive. The amounts of initiator, water and emulsifier (nonylphenol) were varied to obtain the best adhesive properties at the given copolymer composition. The resulting adhesive showed the desired balance of low tack and good adhesive strength in combination with a wide variety of substrates, which made it useful as a removable adhesive for many applications. The product was characterised by viscometry, measurements of tack and peel strength, FTIR, DSC, and microscopy.
- 1 December 2004
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 4 (1) , 288-297
Open AccessSynthesis and characterization of a pressure-sensitive adhesive based on an isobutyl acrylate / 2-ethylhexyl acrylate copolymer
A removable pressure-sensitive adhesive was obtained by free-radical emulsion polymerization. The product is a low-viscosity copolymer from different polar and apolar acrylic monomers consisting of microspheres of about 1 µm diameter. 2-Ethylhexyl acrylate and isobutyl acrylate were used as non-polar constituents while acrylic acid and acrylamide provided the more polar constituents to regulate the cohesive force of the adhesive. The amounts of initiator, water and emulsifier (nonylphenol) were varied to obtain the best adhesive properties at the given copolymer composition. The resulting adhesive showed the desired balance of low tack and good adhesive strength in combination with a wide variety of substrates, which made it useful as a removable adhesive for many applications. The product was characterised by viscometry, measurements of tack and peel strength, FTIR, DSC, and microscopy.
- 20 October 2003
- Published by Wiley in Macromolecular Symposia
- Vol. 201 (1) , 163-170
Polymer-modification of an anti-cancer drug: effects on hydrodynamic properties
- 20 October 2003
- Published by Wiley in Macromolecular Symposia
- Vol. 201 (1) , 163-170
Polymer-modification of an anti-cancer drug: effects on hydrodynamic properties
- 1 June 2003
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 7 (3) , 178-182
Self-diffusion of poly (ethylene oxide)—modified paclitaxel in dilute aqueous solutions
- 1 June 2003
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 7 (3) , 178-182
Self-diffusion of poly (ethylene oxide)—modified paclitaxel in dilute aqueous solutions
- 1 September 2002
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 6 (2) , 51-54
Thermodynamic properties of a series of semi-rigid polyesters
The thermodynamic properties of a series of poly[oxy(2,2′ dialkylpropane-1,3-diyl) carboxybisphenyl- 4,4′-dicarbonyl] have been investigated by P-V-T-measurements as a function of the length of one side-chain at the 2′-position. The pressure-and temperature dependence of the specific volume was recorded from room temperature to 300 °C and from ambient pressure to 200 MPa. Depending on the chemical constitution glass-transitions, enantiotropic and monotropic mesophase transitions were identified. A pressure-induced transition in the glass was observed in one case and unusual behaviour of the volume for a first order mesophase transition in another case.
- 1 September 2002
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 6 (2) , 51-54
Thermodynamic properties of a series of semi-rigid polyesters
The thermodynamic properties of a series of poly[oxy(2,2′ dialkylpropane-1,3-diyl) carboxybisphenyl- 4,4′-dicarbonyl] have been investigated by P-V-T-measurements as a function of the length of one side-chain at the 2′-position. The pressure-and temperature dependence of the specific volume was recorded from room temperature to 300 °C and from ambient pressure to 200 MPa. Depending on the chemical constitution glass-transitions, enantiotropic and monotropic mesophase transitions were identified. A pressure-induced transition in the glass was observed in one case and unusual behaviour of the volume for a first order mesophase transition in another case.