CLChunguang Li

Chunguang Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Chunguang Li has a total of 26 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Suppression of Vortex-Induced Vibration of Π-Type Girder Cable-Stayed Bridges Using Active Suction/Blowing Jets

    by Chunguang Li, Binglan Gao, Yan Han, Guochao Dong, Kai Li

    Due to its bluff body characteristics, the [ ]-shaped girder section of cable-stayed bridges is highly prone to vortex-induced vibrations (VIV). To achieve active flow control for VIV mitigation of girders, this study investigates suction and blowing jet flow control of VIV on a [ ]-shaped girder, based on sectional model wind tunnel tests and numerical simulations using dynamic mesh methods. The mechanisms of the two VIV regions in the [ ]-shaped girder are analyzed through vorticity contours. Eight suction/blowing configurations were systematically designed. The effectiveness of each control scheme was evaluated by comparing vertical displacement responses, aerodynamic parameters, and flow field characteristics. Results indicate two distinct VIV regions in the [ ]-shaped girder. The first region results from periodic simultaneous vortex shedding in the wake, whereas the second stems from alternating shedding of vortices convected from front to rear. Among the eight control schemes, the upstream I-girder lower flange bottom forward suction schemes (S-I, S-II, S-III) and a combined scheme with forward suction upstream and backward blowing downstream (SB-II) significantly reduce the root mean square lift coefficient. The former slightly increases the mean drag coefficient, while the latter shows a non-monotonic trend: first decreasing, then increasing. At a dimensionless control flow rate of [ ], the upstream I-girder lower flange horizontal forward suction scheme (S-II) achieves optimal suppression of the second VIV region while showing no significant effect on the first VIV region. In contrast, the combined upstream I-girder lower flange horizontal forward suction with downstream I-girder lower flange backward blowing scheme (SB-II) demonstrates complete suppression of both VIV regions. At [ ], the downstream I-girder lower flange backward-facing suction scheme (S-II-R) achieves complete suppression of the first VIV region while exhibiting an amplifying effect on vibration amplitudes within the second VIV region. With proper pipe placement and control parameter tuning, VIV under reduced velocity [ ] can be fully suppressed at [ ].

  • Open Access

    Galloping Performance of Transmission Line System Aeroelastic Model with Rime Through Wind-Tunnel Tests

    by Mingguan Zhao, Meng Li, Shenglong Li, Yuanhao Wan, Yang Hai, Chunguang Li

    This study presents an experimental investigation for the galloping performance of the transmission line system with rime under wind excitation. A full aeroelastic model wind-tunnel test is conducted to investigate the dynamic response of a two-bundled transmission line system with rime under different conditions. The time histories of the displacement of the conductor and the acceleration of the tower are measured in detail to analyze the characteristic of the wind-induced response. A comprehensive parametric experiment is performed to explore the effects of wind speed, wind direction, the number of conductor spans and the coupling between the conductor and the tower on the galloping performance of the transmission line system with rime. The results showed that the wind speed, wind direction and the number of conductor spans have significant influence on the galloping performance of conductor. The zero-degree wind direction is the most dangerous direction for the conductor. The multi-span conductor has different galloping initiation wind speed and vibration characteristics compared to the single-span conductor. The coupling effect between the conductor and the tower has trivial influence on the response of tower. This study uses 3D-printing models to simulate the aerodynamic shape of ice-covered wires with different thicknesses for wind-tunnel tests and obtains the influence of a series of parameters on the galloping vibration of transmission tower line systems.


  • Open Access

    Short-Term Probabilistic Wind Speed Predictions Integrating Multivariate Linear Regression and Generative Adversarial Network Methods

    by Yingfei Dong, Chunguang Li, Hongke Shi, Pinhan Zhou

    The precise forecasting of wind speeds is critical to lessen the harmful impacts of wind fluctuations on power networks and aid in merging wind energy into the grid system. However, prior research has predominantly focused on point forecasts, often overlooking the uncertainties inherent in the prediction accuracy. For this research, we suggest a new approach for forecasting wind speed intervals (PI). Specifically, the actual wind speed series are initially procured, and the complete ensemble empirical mode decomposition coupled with adaptive noise (CEEMDAN) method decomposes the actual wind speed series into constituent numerous mode functions. Furthermore, a generative adversarial network (GAN) is utilized to achieve the wind speed PI in conjunction with the multivariate linear regression method. To confirm the effectiveness of the suggested model, four datasets are selected. The validation results suggest that this suggested model attains a superior PI accuracy compared with those of numerous benchmark techniques. In the context of PI of dataset 4, the PINAW values show improvements of 68.06% and 32.35% over the CEEMDAN-CNN and VMD-GRU values in single-step forecasting, respectively. In conclusion, the proposed model excels over the counterpart models by exhibiting diminished a PINAW and CWC, while maintaining a similar PICP.


  • Nonlinear dynamic analysis of galloping of a single iced conductor with four degrees of freedom based on curved beam theory

    by Yan Han, Zihang Zhang, Chunguang Li, Guogang Sheng, Cs Cai

    Based on the nonlinear strain-displacement relationship of spatial curved beam theory, a finite element model for galloping analysis of iced transmission lines is established, which involves three translational degrees of freedom (DOF) and one rotational degree of freedom for each node. Considering the aerodynamic nonlinearity and the geometric nonlinearity of large amplitude motions of the iced transmission line, the nonlinear dynamic finite element equation is presented by using the virtual work principle. The equation is transformed into the sub-space according to the mode superposition method and a time integration algorithm is also performed in the sub-space. Then, the element independence and modal convergence are researched. Finally, the influence of aerodynamic forces on structural frequency is analyzed. The numerical results show that aerodynamic forces will greatly affect the torsional frequency of the transmission line, which accurately reflects the dynamic characteristics of transmission lines. Furthermore, the galloping calculation of the transmission line has reliable accuracy by using 4-DOF (per node) elements for the iced conductor. On the other hand, the model can predict the actual galloping response of the transmission line, which is convenient for the implementation of subsequent control design.


  • Open Access

    Experimental Study on the Spanwise Correlation of Vortex‐Induced Force Using Large‐Scale Section Model

    by Chunguang Li, Yu Mao, Yan Han, Kai Li, C.S. Cai

    To investigate the spanwise correlation of vortex‐induced forces (VIF) of a typical section of a streamlined box girder, wind tunnel tests of simultaneous measurement of force and displacement responses of a sectional model were conducted in a smooth flow. The spanwise correlation of VIF and pressure coefficients on the measurement points of an oscillating main deck were analyzed in both the time domain and frequency domain, respectively. The research results indicated that the spanwise correlation of VIF and pressure coefficients on the measurement points were related to the amplitudes of vortex‐induced vibration (VIV), both of them weakened with the increase of spanwise distance; the maximum value of spanwise correlation coefficient is situated at the ascending stage of the lock‐in region, rather than at the extreme amplitude point. The amplitudes of VIV showed different impacts on the spanwise correlation of pressure coefficients on the measurement points of the upper and lower surfaces, for which the maximum value of the spanwise correlation coefficients is located at the extreme amplitude point and the ascending stage of the lock‐in region, respectively. Furthermore, the spanwise correlation of the pressure coefficients decreases continually from the upstream to downstream of the main deck; large coherence of vortex‐induced forces and pressure appears around the frequency of vortex shedding, and the coherence of VIF and pressure becomes smaller with the increase in the spanwise distance.


  • Wind Tunnel Tests on Wind Pressure Characteristics of Sawtooth Roofs

    by Chunguang Li, Yan Han, Ji Zhang, Shuqian Liu, C. S. Cai

    Wind tunnel tests were conducted to investigate the wind pressure characteristics of sawtooth roofs in a simulated open country wind field with relatively low turbulence intensity. Models of monosloped and sawtooth roof (two to four spans) buildings that were 1∶200 scale were constructed with intense pressure taps installed on the 15° sloped roofs. Both local and area-average pressure coefficients were determined under different wind directions. Preliminary results indicated that the local peak negative pressure coefficients were slightly lower than the literature results. The increase of roof slope led to higher peak design pressure coefficients for sawtooth roofs, especially in the interior and edge regions of roofs. The peak values of negative pressure captured in high corner regions of monosloped roofs were similar to the corresponding data measured on the windward span of sawtooth roofs, which indicated that the American standard provisions for wind pressure design of monosloped roof structures and the Chinese local wind pressure provisions for sawtooth roofs may underestimate the critical wind suction on high corner regions of monosloped roofs. Generally, the area-average pressures heavily depend on the size of tributary area and the region concerned, and higher roof slope led to faster reduction.