CFCatherine Faur

Catherine Faur

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Catherine Faur has a total of 14 co-authors. Here are the top co-authors by number of shared publications:

  • Antoine Venault

    R&D Center for Membrane Technology and Department of Chemical Engineering, Chung Yuan Christian University, Chung-Li, Taoyuan 320, Taiwan

    2 shared publications
  • A. Graillot

    IEM (Institut Europeen des Membranes), UMR 5635 (CNRS-ENSCM-UM2), Universite Montpellier 2, Place E.Bataillon, F-34095, Montpellier, France

    1 shared publication
  • Bouyer Denis

    IEM (Institut Europeen des Membranes), UMR 5635 (CNRS-ENSCM-UM2), Universite Montpellier 2, Place E. Bataillon, F-34095, Montpellier, France

    1 shared publication
  • Céline Pochat-Bohatier

    Institut Européen des Membranes, IEM, UMR 5635, Univ. Montpellier, CNRS, ENSCM Place Eugène Bataillon 3 , Montpellier cedex 5 34095

    1 shared publication
  • D. Bouyer

    IEM (Institut Europeen des Membranes), UMR 5635 (CNRS-ENSCM-UM2), Universite Montpellier 2, Place E.Bataillon, F-34095, Montpellier, France

    1 shared publication
  • David Laurent

    Ingénierie des Matériaux Polymères, IMP, UMR CNRS 5223, Laboratoire IMP@Lyon 1, Université Claude Bernard Lyon 1, Université de Lyon, 15 bd A. Latarjet, Bât. Polytech Lyon, 69622 Villeurbanne Cedex, France

    1 shared publication

Latest Publications

  • Removal of metal ions from aqueous effluents involving new thermosensitive polymeric sorbent

    by A. Graillot, S. Djenadi, C. Faur, D. Bouyer, S. Monge, J. J. Robin

    In this work, new thermosensitive copolymers bearing phosphonated groups were synthesized and used to remove metal pollution. Sorption properties are brought by hydrolyzed (dimethoxyphosphoryl)methyl 2-methylacrylate (hMAPC1) monomer. N-n-propylacrylamide (NnPAAm) led to the thermoresponsive properties of the copolymers. Low lower critical solution temperature (LCST) values were observed, ranging between 20 and 25 °C depending on the molar ratio of each monomer in the copolymer. Sorption properties of these copolymers towards nickel ions were evaluated for increasing temperatures (10–40 °C), Ni ion concentrations of 20 mg L−1 and pH values between 3 and 7. Best results were observed for temperatures just lower than the LCST (20 °C), when the copolymer was fully soluble in water solution. For temperature higher than the LCST, phosphonic diacid groups accessibility was considerably reduced by the precipitation of the thermosensitive part of the copolymer leading to lower sorption properties. In these conditions, the highest Ni removal by the copolymer was observed for pH = 7, when there was almost no competition between the sorption of H+ and Ni2+ ions on the phosphonic acid groups. These optimal conditions enabled removal of about 70% of the nickel in the synthetic effluent.


  • Development and characterization of composite chitosan/active carbon hydrogels for a medical application

    by Pochat‐Bohatier Céline, Venault Antoine, Bouyer Denis, Vachoud Laurent, David Laurent, Faur Catherine

    Composite chitosan/active carbon (AC) hydrogels were elaborated by a novel route, consisting in exposing the chitosan solution to ammonia vapors. This vapor‐induced gelation method was compared with the conventional elaboration process, a direct immersion of the chitosan solution in liquid ammonia. The hydrogels were characterized to evaluate their potential application as wound‐dressings, mostly regarding their morphology, mechanical properties, swelling behavior, and sorption capacities for malodorous compounds emitted from wounds as diethylamine (DEA). The influence of elaboration route, chitosan concentration, and AC incorporation was studied. The results show that freeze‐dried hydrogels have a porous asymmetric structure dependent on the chitosan concentration and which promotes exudates drainage. The nanostructure of the parent hydrogel is semi‐crystalline and slightly dependent on the gelation conditions. It confers on hydrogel an acceptable mechanical behavior (compressive modulus up to 1.08·105 Pa). Hydrogels including AC display enhanced sorption kinetics for DEA, with sorption capacities up to 49 mg g−1. © 2012 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2013