Ronny Boch
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ronny Boch has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Albrecht Leis
JR-AquaConSol, Steyrergasse 21, 8010 Graz, Austria
2 shared publications - Andre Baldermann
Institute of Applied Geosciences, Graz University of Technology and NAWI Graz Geocenter, Graz, Austria
2 shared publications - Florian Mittermayr
Graz University of Technology
2 shared publications - Martin Dietzel
Institute of Applied Geosciences, Graz University of Technology, Graz, Austria
2 shared publications - Claudia Baldermann
Institute of Technology and Testing of Building Materials (IMBT-TVFA), Graz University of Technology, Inffeldgasse 24, 8010 Graz, Austria
1 shared publication Dorothee Hippler
Institute of Applied Geosciences, Graz University of Technology, Graz, Austria
1 shared publication
Latest Publications
- Open Access
- 17 September 2024
- Published by MDPI AG in Sustainability
- Vol. 16 (18) , 8107
Mechanism of Carbon Monoxide (CO) Generation and Potential Human Health Hazard during Mechanized Tunnel Driving in Organic-Rich Rocks: Field and Laboratory Study
The monitoring of carbon emissions is increasingly becoming a sustainability issue worldwide. Despite being largely unnoticed, the toxic gas carbon monoxide (CO) is ubiquitous in mechanized tunnel driving, but the individual sources, release and enrichment mechanisms are often unknown. In this study, the generation of CO from organic matter containing sedimentary rocks was investigated during mechanized tunnel driving and by reacting claystone and sandstone with 10 mM NaCl solutions for 2 months at 70 °C and 140 °C. The mineralogical and geochemical evolution of the solids and fluids was assessed by CO measurements and the XRD, DTA, TOC, IC and ICP-OES methods. The CO concentration in the atmosphere reached up to 1920 ppm (100 ppm on average) during tunnel driving, which is more than three times higher than the legal daily average dose for tunnellers, thus requiring occupational safety operations. Mineral-specific dissolution processes and the rapid decomposition of labile organic matter upon thermal alteration contributed to the liberation of CO and also carbon dioxide (CO2) from the host rocks. In mechanized tunnel driving, frictional heat and ‘cold’ combustion with temperatures reaching 50–70 °C at the drill head is an important mechanism for increased CO and CO2 generation, especially during drilling in sedimentary rocks containing significant amounts of OM and when the ventilation of the tunnel atmosphere and air mixing are limited. Under such conditions, human health damage due to CO exposure (HHDCO) can be 30 times higher compared to tunnel outlets, where CO is emitted from traffic.
- 17 September 2024
- Published by MDPI AG in Sustainability
- Vol. 16 (18) , 8107
Open AccessMechanism of Carbon Monoxide (CO) Generation and Potential Human Health Hazard during Mechanized Tunnel Driving in Organic-Rich Rocks: Field and Laboratory Study
The monitoring of carbon emissions is increasingly becoming a sustainability issue worldwide. Despite being largely unnoticed, the toxic gas carbon monoxide (CO) is ubiquitous in mechanized tunnel driving, but the individual sources, release and enrichment mechanisms are often unknown. In this study, the generation of CO from organic matter containing sedimentary rocks was investigated during mechanized tunnel driving and by reacting claystone and sandstone with 10 mM NaCl solutions for 2 months at 70 °C and 140 °C. The mineralogical and geochemical evolution of the solids and fluids was assessed by CO measurements and the XRD, DTA, TOC, IC and ICP-OES methods. The CO concentration in the atmosphere reached up to 1920 ppm (100 ppm on average) during tunnel driving, which is more than three times higher than the legal daily average dose for tunnellers, thus requiring occupational safety operations. Mineral-specific dissolution processes and the rapid decomposition of labile organic matter upon thermal alteration contributed to the liberation of CO and also carbon dioxide (CO2) from the host rocks. In mechanized tunnel driving, frictional heat and ‘cold’ combustion with temperatures reaching 50–70 °C at the drill head is an important mechanism for increased CO and CO2 generation, especially during drilling in sedimentary rocks containing significant amounts of OM and when the ventilation of the tunnel atmosphere and air mixing are limited. Under such conditions, human health damage due to CO exposure (HHDCO) can be 30 times higher compared to tunnel outlets, where CO is emitted from traffic.
- Top Cited Papers
- 1 November 2021
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 312, 235-256
Calibration of the dual clumped isotope thermometer for carbonates
- 1 November 2021
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 312, 235-256
Top Cited PapersCalibration of the dual clumped isotope thermometer for carbonates
- Open Access
- 29 May 2018
- Published by Wiley in Sedimentology
- Vol. 66 (2) , 604-635
Aragonite–calcite veins of the ‘Erzberg’ iron ore deposit (Austria): Environmental implications from young fractures
The well‐known Erzberg site represents the largest siderite (FeCO3) deposit in the world. It consists of various carbonates accounting for the formation of prominent CaCO3 (dominantly aragonite) precipitates filling vertical fractures of different width (centimetres to decimetres) and length (tens of metres). These commonly laminated precipitates are known as ‘erzbergite’. This study focuses on the growth dynamics and environmental dependencies of these vein fillings. Samples recovered on‐site and from mineral collections were analyzed, and these analyses were further complemented by modern water analyses from different Erzberg sections. Isotopic signatures support meteoric water infiltration and sulphide oxidation as the principal hydrogeochemical mechanism of (Ca, Mg and Fe) carbonate host rock dissolution, mobilization and vein mineralization. Clumped isotope measurements revealed cool formation temperatures of ca 0 to 10°C for the aragonite, i.e. reflecting the elevated altitude Alpine setting, but unexpectedly low for aragonite nucleation. The 238U–234U–230Th dating yielded ages from 285·1 ± 3·9 to 1·03 ± 0·04 kyr bp and all samples collected on‐site formed after the Last Glacial Maximum. The observed CaCO3 polymorphism is primarily controlled by the high aqueous Mg/Ca ratios resulting from dissolution of Mg‐rich host rocks, with Mg/Ca further evolving during prior CaCO3 precipitation and CO2 outgassing in the fissured aquifer. Aragonite represents the ‘normal’ mode of erzbergite formation and most of the calcite is of diagenetic (replacing aragonite) origin. The characteristic lamination (millimetre‐scale) is an original growth feature and mostly associated with the deposition of stained (Fe‐rich) detrital particle layers. Broader zonations (centimetre‐scale) are commonly of diagenetic origin. Petrographic observations and radiometric dating support an irregular nature for most of the layering. Open fractures resulting from fault tectonics or gravitational mass movements provide water flow routes and fresh chemical reaction surfaces of the host rock carbonates and accessory sulphides. If these prerequisites are considered, including the hydrogeochemical mechanism, modern water compositions, young U‐Th ages and calculated precipitation rates, it seems unlikely that the fractures had stayed open over extended time intervals. Therefore, it is most likely that they are geologically young.
- 29 May 2018
- Published by Wiley in Sedimentology
- Vol. 66 (2) , 604-635
Open AccessAragonite–calcite veins of the ‘Erzberg’ iron ore deposit (Austria): Environmental implications from young fractures
The well‐known Erzberg site represents the largest siderite (FeCO3) deposit in the world. It consists of various carbonates accounting for the formation of prominent CaCO3 (dominantly aragonite) precipitates filling vertical fractures of different width (centimetres to decimetres) and length (tens of metres). These commonly laminated precipitates are known as ‘erzbergite’. This study focuses on the growth dynamics and environmental dependencies of these vein fillings. Samples recovered on‐site and from mineral collections were analyzed, and these analyses were further complemented by modern water analyses from different Erzberg sections. Isotopic signatures support meteoric water infiltration and sulphide oxidation as the principal hydrogeochemical mechanism of (Ca, Mg and Fe) carbonate host rock dissolution, mobilization and vein mineralization. Clumped isotope measurements revealed cool formation temperatures of ca 0 to 10°C for the aragonite, i.e. reflecting the elevated altitude Alpine setting, but unexpectedly low for aragonite nucleation. The 238U–234U–230Th dating yielded ages from 285·1 ± 3·9 to 1·03 ± 0·04 kyr bp and all samples collected on‐site formed after the Last Glacial Maximum. The observed CaCO3 polymorphism is primarily controlled by the high aqueous Mg/Ca ratios resulting from dissolution of Mg‐rich host rocks, with Mg/Ca further evolving during prior CaCO3 precipitation and CO2 outgassing in the fissured aquifer. Aragonite represents the ‘normal’ mode of erzbergite formation and most of the calcite is of diagenetic (replacing aragonite) origin. The characteristic lamination (millimetre‐scale) is an original growth feature and mostly associated with the deposition of stained (Fe‐rich) detrital particle layers. Broader zonations (centimetre‐scale) are commonly of diagenetic origin. Petrographic observations and radiometric dating support an irregular nature for most of the layering. Open fractures resulting from fault tectonics or gravitational mass movements provide water flow routes and fresh chemical reaction surfaces of the host rock carbonates and accessory sulphides. If these prerequisites are considered, including the hydrogeochemical mechanism, modern water compositions, young U‐Th ages and calculated precipitation rates, it seems unlikely that the fractures had stayed open over extended time intervals. Therefore, it is most likely that they are geologically young.
- Open Access
- 22 May 2017
- Published by Springer Nature in Geothermal Energy
- Vol. 5 (1) , 1-19
Scale-fragment formation impairing geothermal energy production: interacting H2S corrosion and CaCO3 crystal growth
- 22 May 2017
- Published by Springer Nature in Geothermal Energy
- Vol. 5 (1) , 1-19
Open AccessScale-fragment formation impairing geothermal energy production: interacting H2S corrosion and CaCO3 crystal growth