Jyothis Anand
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jyothis Anand has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- David J. Sailor
School of Geographical Science and Urban Planning, Arizona State University, Tempe, USA
4 shared publications - Xiaobing Liu
Oak Ridge National Laboratory (ORNL), Oak Ridge, TN (United States)
3 shared publications - Fady Anees2 shared publications
- Mini Malhotra
Oak Ridge National Laboratory (ORNL), Oak Ridge, TN (United States)
2 shared publications Oak Ridge Oak Ridge National Laboratory (Ornl)
2 shared publications- Piljae Im
Oak Ridge National Laboratory (ORNL), Oak Ridge, TN (United States)
2 shared publications
Latest Publications
- Open Access
- 7 August 2026
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 85
Impact of surface division and zone characteristics on outdoor surface temperature modeling with EnergyPlus
- 7 August 2026
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 85
Open AccessImpact of surface division and zone characteristics on outdoor surface temperature modeling with EnergyPlus
- 1 April 2026
- Published by Office of Scientific and Technical Information (OSTI)
GeoWISE – User Manual 1.0
- 1 April 2026
- Published by Office of Scientific and Technical Information (OSTI)
GeoWISE – User Manual 1.0
- 20 November 2025
- Published by Elsevier in Energy and Buildings
- Vol. 351
Optimizing inner and outer surface radiative properties of exterior walls to minimize building energy use and urban heat release
- 20 November 2025
- Published by Elsevier in Energy and Buildings
- Vol. 351
Optimizing inner and outer surface radiative properties of exterior walls to minimize building energy use and urban heat release
- 12 November 2025
- Published by Elsevier in Energy and Buildings
- Vol. 351
An economic and technical feasibility analysis of a dual-source heat pump using both the air and the ground
- 12 November 2025
- Published by Elsevier in Energy and Buildings
- Vol. 351
An economic and technical feasibility analysis of a dual-source heat pump using both the air and the ground
- Top Cited Papers
Beyond cooling: Radiative thermoregulation in the Earth’s glow with micropatterned directional emitters
- Open Access
- 1 August 2024
- Published by Office of Scientific and Technical Information (OSTI)
Design And Control of Thermal Storage for Ventilative Cooling in Multifamily buildings (Final Report)
The concept of natural ventilation is to provide a heat sink for cooling the building during the occupancy periods at night and improve indoor thermal comfort during the daytime without or with minimal need for mechanical cooling. Commonly, natural ventilation through the window or mechanical circulation of the air through the ventilation ducts are two key methods used to achieve night ventilation. Due to the increasing electric need for space heating and cooling, renewable energies combined with energy storage systems are receiving attention worldwide nowadays. When designed and controlled properly, this strategy can reduce energy use for cooling, reduce the size of mechanical cooling equipment, reduce peak electrical demand for cooling, and better enable demand flexibility for mechanical cooling equipment. In some cases, ventilative cooling can eliminate the need for mechanical cooling altogether. For these reasons, California’s Building Energy Efficiency Standards have recently added prescriptive requirements that all new single‐family residences (in most California climates) must include ventilative cooling systems (aka: “whole house fans”). However, the current standards do not address multifamily buildings because market‐available ventilative cooling products are designed for single-family residences and are physically incompatible with many multifamily building archetypes. The results from the study show that the combination of thermal energy storage on building walls along with nighttime ventilation cooling assisted with nighttime ventilation can save total building energy usage by up to 9% and peak load by 16% in moderate climate zones. The controlled nighttime ventilation cooling (activate ventilation only when outdoor conditions are favorable) can also provide total electricity savings of up to 5% and 7% in hot and cold climates, respectively. In the case of moderate climates, kitchen exhaust-assisted nighttime ventilation cooling can eliminate the need for cooling during overnight hours. This can also significantly assist in reducing carbon emissions.
- 1 August 2024
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessDesign And Control of Thermal Storage for Ventilative Cooling in Multifamily buildings (Final Report)
The concept of natural ventilation is to provide a heat sink for cooling the building during the occupancy periods at night and improve indoor thermal comfort during the daytime without or with minimal need for mechanical cooling. Commonly, natural ventilation through the window or mechanical circulation of the air through the ventilation ducts are two key methods used to achieve night ventilation. Due to the increasing electric need for space heating and cooling, renewable energies combined with energy storage systems are receiving attention worldwide nowadays. When designed and controlled properly, this strategy can reduce energy use for cooling, reduce the size of mechanical cooling equipment, reduce peak electrical demand for cooling, and better enable demand flexibility for mechanical cooling equipment. In some cases, ventilative cooling can eliminate the need for mechanical cooling altogether. For these reasons, California’s Building Energy Efficiency Standards have recently added prescriptive requirements that all new single‐family residences (in most California climates) must include ventilative cooling systems (aka: “whole house fans”). However, the current standards do not address multifamily buildings because market‐available ventilative cooling products are designed for single-family residences and are physically incompatible with many multifamily building archetypes. The results from the study show that the combination of thermal energy storage on building walls along with nighttime ventilation cooling assisted with nighttime ventilation can save total building energy usage by up to 9% and peak load by 16% in moderate climate zones. The controlled nighttime ventilation cooling (activate ventilation only when outdoor conditions are favorable) can also provide total electricity savings of up to 5% and 7% in hot and cold climates, respectively. In the case of moderate climates, kitchen exhaust-assisted nighttime ventilation cooling can eliminate the need for cooling during overnight hours. This can also significantly assist in reducing carbon emissions.
- Open Access
- 28 March 2024
- Published by Elsevier in Energy and Buildings
- Vol. 311
Achieving net negative sensible heat release from buildings
- 28 March 2024
- Published by Elsevier in Energy and Buildings
- Vol. 311
Open AccessAchieving net negative sensible heat release from buildings
- Open Access
- 1 November 2023
- Published by Office of Scientific and Technical Information (OSTI)
Grid Cost and Total Emissions Reductions Through Mass Deployment of Geothermal Heat Pumps for Building Heating and Cooling Electrification in the United States
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 November 2023
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessGrid Cost and Total Emissions Reductions Through Mass Deployment of Geothermal Heat Pumps for Building Heating and Cooling Electrification in the United States
The U.S. Department of Energy's Office of Scientific and Technical Information