YTYi Tang

Yi Tang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yi Tang has a total of 16 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Study on methodology and efficiency of microbially induced carbonate precipitation on improvement of marine silty sand

    by Yi Tang, Shixing Cai

    The demand for ground improvement of marine sediments has been risen in construction of offshore infrastructures, including wharves, embankments and breakwaters. In recent years, microbially induced carbonate precipitation (MICP) has developed rapidly and become an alternative technology for increasing soil strength and limiting soil erosion. Silty sand is widely distributed in offshore areas throughout the world. The high salinity of seawater may have an impact on the bacterial activity, while the fine particles in silty sand would affect the transportation of cementation solution and the formation of carbonate precipitation. In this study, attentions are paid to the application of MICP on improvement of marine silty sand properties, as well as the factors influencing the hydraulic conductivity and strength of the bio-cemented soil. Multi-gradient domestication tests on Sporosacina pasteurii were carried out to ensure the bacterial and urease activities in seawater environment. It was found that the bacterial concentration and urease activity after five-gradient domestication in seawater reached 98.5% and 92.8% of those in the deionized water environment, respectively. The permeability, unconfined compressive strength (UCS) and content of carbonate precipitation of bio-cemented specimens were measured. The MICP treatment on silty sand with seawater resulted in an increase of UCS to 700 kPa and a reduction of permeability by an order of magnitude, corresponding to a carbonate content of 8%. X-ray diffraction (XRD) and scanning electron microscopy (SEM) were performed to investigate the types and distributions of carbonate crystals. The results indicated the formation of calcium carbonate and magnesium carbonate crystals due to the interaction between carbonate ions and calcium and magnesium ions in seawater. The precipitations were distributed on the surfaces of soil particles and near particle contact points, affecting the soil microstructure and thus the strength and permeability. The influences of concentration and injection rate of cementation solution on the efficiency of MICP were demonstrated and the recommended values were given. This study may provide a possible solution for improvement of engineering properties of marine silty sand foundations.

  • Open Access

    Permeability Estimation of Engineering-Adapted Clay–Gravel Mixture Based on Binary Granular Fabric

    by Wenbin Huang, Chenghao Chen, Shengshui Chen, Hua Ling, Shiang Mei, Yi Tang

    Clay–gravel mixture is an increasingly popular material used in geotechnical engineering for its engineering adaptability and easy accessibility. Among various granulometric factors, gravel content plays a critical role in the alteration of mixture microstructure. Its influence on mechanical behavior has been comprehensively investigated, yet the hydraulic models accounting for the paired impact of clay and gravel particles are seldomly discussed. In an effort to enhance the permeability prediction capability of this soil, a generalized binary model derived from a theoretical hydraulic conductivity expression is proposed, with the participation of two fundamental compound seepage models. High accuracy between test and calculation results indicates the reliability of this model, as well as its supremacy over conventional models. The parameter sensitivity analysis demonstrates that the proposed model, being of convincing parametric stability regardless of variant particle size distribution characteristics, has the potential to be applicable to a wide range of engineering-adapted CGMs. The predictive formula for cohesive fraction and the anomaly coefficient, as is integrated into the binary model, are explicitly discussed. Suitable for clay–gravel materials under a transitional soil state for engineering applications, this model provides a quantitative and reasonable evaluation of hydraulic conductivity with high practicality. The above findings might work as a perspective for the credible assessment of structure seepage safety behavior, as well as a quantitative evaluation method regarding the mixing quality of CGMs.


  • Open Access

    Plate Load Tests on an Unsaturated Sand–Kaolin Mixture with Varying Water Table

    by Yi Tang, Chenghao Chen, Bin Qian, Jie Ren, Yunfei Guan

    Clayey sand is widely distributed and commonly encountered in geotechnical engineering practice. To understand its bearing capacity behavior under unsaturated conditions, plate load tests are performed on sand–kaolin mixture samples with varying water tables. The distributions of suction and volumetric water content with depth are measured by vibrating wire piezometers and soil moisture sensors, respectively. It is shown by the test results that the bearing capacity increases when the water table in the soil sample drops. The influence of suction on the bearing capacity is found to be dependent on the height of the water table and the hydraulic loading history of the soil sample. The plate load test results are interpreted using bearing capacity equations. Good agreement is obtained between measured and calculated bearing capacities. This study provides a simple method to estimate the bearing capacity of in situ unsaturated soil foundations.


  • Study on the mechanical properties of coral sands with different particle gradations

    by Yuan-Yi Chen, Yi Tang, Yun-Fei Guan, Rui-Ming Liu, Xun Han, Xian-Qiang Zhao

    The properties of coral sands are significantly affected by the gradation changes caused by the particle breakage. In this paper, a series of triaxial consolidated drained (CD) shear tests were carried out to investigate the influence of gradation on the particle breakage and mechanical properties of coral sands. The results showed that the softening and dilatancy during shearing are more significant for coral sands with smaller average particle sizes under low confining pressure. The peak friction angle decreases with the confining pressure and can be fitted by a power function for different gradations. The particle size distribution of the “hyperbolic” or “straight” curve has a trend to transform into a “sigmoidal” type after shearing; and the variation is affected by the confining pressure and the initial gradation. The critical state lines of the coral sands with different gradations are parallel straight lines on the e−(p′/pa)ξ plane. In addition, the relative breakage of coral sand particles increases with the confining pressure and the mean particle size. Based on the triaxial compression test results, the expressions relating relative breakages to the confining pressure and the gradation parameters were proposed.


  • Open Access

    An Improved Large-Scale Stress-Controlled Apparatus for Long-Term Seepage Study of Coarse-Grained Cohesive Soils

    by Chenghao Chen, Shengshui Chen, Shiang Mei, Shaoyang Han, Xian Zhang, Yi Tang

    Clay–gravel mixture has been widely used in high embankment dams and understanding its seepage characteristics is critical to dam safety. From the instrumental perspective, the realization of continuous pressurized water supply becomes a key technical challenge, significantly restricting the working conditions replicated in previous seepage apparatuses. To this end, a novel water provision system, relying on parallel-disposed sensor-based pressure devices, was introduced, so that the application of an existing large-scale stress-controlled apparatus can be expanded to long-term seepage tests regarding coarse-grained cohesive soils. Constant-head permeability tests were conducted on original-graded clay–gravel mixtures to investigate their hydraulic properties, incorporating the influence of stress relaxation. Test results show that with 35% gravel content, the clay–gravel mixture is suitable for dam construction as the core material. The stress relaxation holds a marginal effect on the hydraulic conductivity of soil. The functionality of this improved apparatus is verified, especially under long-term seepage conditions.