Hyeonsu Lim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hyeonsu Lim has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Cheul-Ro Lee
School of Advanced Materials Engineering, Jeonbuk National University, Baekje-daero 567, Jeonju 54896, Korea
2 shared publications - Hyung-Kee Seo
Future Energy Convergence Core Center, School of Chemical Engineering, Jeonbuk National University, Baekje-daero 567, Jeonju 54896, Korea
2 shared publications - Inseok Seo
School of Advanced Materials Engineering, Jeonbuk National University, Jeonju 54896, Republic of Korea
2 shared publications - Baeksang Yoon
School of Advanced Materials Engineering, Jeonbuk National University, Baekje-daero 567, Jeonju 54896, Korea
1 shared publication - Dan Na
School of Advanced Materials Engineering, Research Center for Advanced Materials Development (RCAMD), Jeonbuk National University, Baekje-daero 567, Jeonju 54896, Korea
1 shared publication - Jae-Kwang Kim
Department of Energy Convergence Engineering Cheongju University Cheongju Republic of Korea
1 shared publication
Latest Publications
- Open Access
Photo-Charging of Li(Ni0.65Co0.15Mn0.20)O2 Lithium-Ion Battery Using Silicon Solar Cells
This study reports an integrated device in which a lithium-ion battery (LIB) and Si solar cells are interconnected. The LIB is fabricated using the Li(Ni0.65Co0.15Mn0.20)O2 (NCM622) cathode and the Li4Ti5O12 (LTO) anode. The surface and shape morphologies of the NCM and LTO powders were investigated by field emission scanning electron microscopy (FE-SEM). In addition, the structural properties were thoroughly examined by X-ray diffraction (XRD). Further, their electrochemical characterization was carried out on a potentiostat. The specific discharge capacity of the NCM cathode (half-cell) was 188.09 mAh/g at 0.1 C current density. In further experiments, the NCM-LTO full-cell has also shown an excellent specific capacity of 160 mAh/g at a high current density of 1 C. Additionally, the capacity retention was outstanding, with 99.63% at 1 C after 50 cycles. Moreover, to meet the charging voltage requirements of the NCM-LTO full-cell, six Si solar cells were connected in series. The open-circuit voltage (VOC) and the short-circuit photocurrent density (JSC) for the Si solar cells were 3.37 V and 5.42 mA/cm2. The calculated fill factor (FF) and efficiency for the Si solar cells were 0.796 and 14.54%, respectively. Lastly, the integrated device has delivered a very high-power conversion-storage efficiency of 7.95%.
Open AccessPhoto-Charging of Li(Ni0.65Co0.15Mn0.20)O2 Lithium-Ion Battery Using Silicon Solar Cells
This study reports an integrated device in which a lithium-ion battery (LIB) and Si solar cells are interconnected. The LIB is fabricated using the Li(Ni0.65Co0.15Mn0.20)O2 (NCM622) cathode and the Li4Ti5O12 (LTO) anode. The surface and shape morphologies of the NCM and LTO powders were investigated by field emission scanning electron microscopy (FE-SEM). In addition, the structural properties were thoroughly examined by X-ray diffraction (XRD). Further, their electrochemical characterization was carried out on a potentiostat. The specific discharge capacity of the NCM cathode (half-cell) was 188.09 mAh/g at 0.1 C current density. In further experiments, the NCM-LTO full-cell has also shown an excellent specific capacity of 160 mAh/g at a high current density of 1 C. Additionally, the capacity retention was outstanding, with 99.63% at 1 C after 50 cycles. Moreover, to meet the charging voltage requirements of the NCM-LTO full-cell, six Si solar cells were connected in series. The open-circuit voltage (VOC) and the short-circuit photocurrent density (JSC) for the Si solar cells were 3.37 V and 5.42 mA/cm2. The calculated fill factor (FF) and efficiency for the Si solar cells were 0.796 and 14.54%, respectively. Lastly, the integrated device has delivered a very high-power conversion-storage efficiency of 7.95%.
- Open Access
An Integrated Device of a Lithium-Ion Battery Combined with Silicon Solar Cells
This study reports an integrated device of a lithium-ion battery (LIB) connected with Si solar cells. A Li(Ni0.65Co0.15Mn0.20)O2 (NCM) cathode and a graphite (G) anode were used to fabricate the lithium-ion battery (LIB). The surface and shape morphologies of NCM and graphite powder were characterized by field emission scanning electron microscopy (FE-SEM). The structural properties of NCM and graphite powder were determined by X-ray diffraction (XRD) analysis. XRD patterns of powders were well matched with those of JCPDS data. To investigate the electrochemical characteristics of NCM and graphite, cycling tests were performed after assembling the NCM-Li, the G-Li half-cell, and the NCM-G full-cell. The discharge capacity of the NCM cathode at 0.1C was 189.82 mAh/g−1. The NCM-graphite full-cell showed 98.25% cycle retention at 1C after 50 cycles. To obtain enough charging voltage for the LIB connected with solar cells in an integrated device, eight single Si solar cells were connected in a series. The short-circuit photocurrent density for Si solar cells was 4.124 mA/cm2. The fill factor and the open circuit voltage were 0.78 and 4.5 V, respectively. These Si solar cells showed a power conversion efficiency of 14.45%. The power conversion andstorage efficiency of the integrated device of the NCM battery and Si solar cells was 7.74%. Charging of the integrated device could be as effective as charging with a battery cycler.
Open AccessAn Integrated Device of a Lithium-Ion Battery Combined with Silicon Solar Cells
This study reports an integrated device of a lithium-ion battery (LIB) connected with Si solar cells. A Li(Ni0.65Co0.15Mn0.20)O2 (NCM) cathode and a graphite (G) anode were used to fabricate the lithium-ion battery (LIB). The surface and shape morphologies of NCM and graphite powder were characterized by field emission scanning electron microscopy (FE-SEM). The structural properties of NCM and graphite powder were determined by X-ray diffraction (XRD) analysis. XRD patterns of powders were well matched with those of JCPDS data. To investigate the electrochemical characteristics of NCM and graphite, cycling tests were performed after assembling the NCM-Li, the G-Li half-cell, and the NCM-G full-cell. The discharge capacity of the NCM cathode at 0.1C was 189.82 mAh/g−1. The NCM-graphite full-cell showed 98.25% cycle retention at 1C after 50 cycles. To obtain enough charging voltage for the LIB connected with solar cells in an integrated device, eight single Si solar cells were connected in a series. The short-circuit photocurrent density for Si solar cells was 4.124 mA/cm2. The fill factor and the open circuit voltage were 0.78 and 4.5 V, respectively. These Si solar cells showed a power conversion efficiency of 14.45%. The power conversion andstorage efficiency of the integrated device of the NCM battery and Si solar cells was 7.74%. Charging of the integrated device could be as effective as charging with a battery cycler.