Jinbiao Yuan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jinbiao Yuan has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Zhenbao Liu
School of Civil Aviation, Northwestern Polytechnical University, Xi’an 710072, China
4 shared publications - Bin Tian
Institute of Automation, Chinese Academy of Sciences, Beijing 100190, China
1 shared publication - Bodi Ma
School of Aeronautics, Northwestern Polytechnical University, Xi’an 710072, China
1 shared publication - Junwei Han
School of Artificial Intelligence, Chongqing University of Posts and Telecommunications, Chongqing, China
1 shared publication - Leyang Zhao
School of Geodesy and Geomatics, Wuhan University, Wuhan 430079, China
1 shared publication - Li Yan
School of Geodesy and Geomatics, Wuhan University, 129 Luoyu Road, Wuhan 430079, China
1 shared publication
Latest Publications
- 23 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automation Science and Engineering
- Vol. 22 (15455955) , 21811-21830
Second-Order Sliding Mode Control of Flying-Wing Aircraft Based on Feedforward Neural Networks
The flying-wing aircraft control problem is a major concern. In this paper, a new control strategy is introduced. First, a Feedforward neural network (FNN) modeling is introduced. Then, a second-order sliding mode control is applied, with the parameters generated from Deep Deterministic Policy Gradient (DDPG) reinforcement learning. To study the disturbance rejection performance, wind disturbance is applied to the aircraft using a deep neural network as an disturbance observer for different types of winds. Finally, All three simulations: Simulink, Software In The Loop, and Hardware In the Loop are applied to show the effectiveness of the proposed strategy. The simulation results show that the proposed method demonstrates good robustness in various conditions.
- 23 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automation Science and Engineering
- Vol. 22 (15455955) , 21811-21830
Second-Order Sliding Mode Control of Flying-Wing Aircraft Based on Feedforward Neural Networks
The flying-wing aircraft control problem is a major concern. In this paper, a new control strategy is introduced. First, a Feedforward neural network (FNN) modeling is introduced. Then, a second-order sliding mode control is applied, with the parameters generated from Deep Deterministic Policy Gradient (DDPG) reinforcement learning. To study the disturbance rejection performance, wind disturbance is applied to the aircraft using a deep neural network as an disturbance observer for different types of winds. Finally, All three simulations: Simulink, Software In The Loop, and Hardware In the Loop are applied to show the effectiveness of the proposed strategy. The simulation results show that the proposed method demonstrates good robustness in various conditions.
- 22 August 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Intelligent Vehicles
- Vol. 9 (1) , 1189-1203
UAV Path Planning With Terrain Constraints for Aerial Scanning
A global path planning method constrained by dynamics, kinematics, and terrain is proposed for Vertical Takeoff and Landing (VTOL) Unmanned Aerial Vehicles (UAVs). Firstly, new constant-altitude waypoints are interpolated above the terrain based on altitude information and terrain resolution. Account for the coverage of airborne sensors over the surface area, a horizontal waypoint interpolation optimization (HOPT) is performed at positions with excessive bending in the horizontal direction. Secondly, for vertical plane optimization (VOPT), i.e., height optimization, a Soft Actor-Critic-based Particle Swarm Optimization (SAC-PSO) is employed to optimize the convergence speed of the method and achieve terrain following (TF). Thirdly, to evaluate the generated paths, a deep residual network (DRSN) is designed to mitigate the impact of optimization failures during the iteration process and improve the stability of the algorithm. Simulation experiments demonstrate the efficiency and path quality of the proposed method, while real-world tasks validate its practicality.
- 22 August 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Intelligent Vehicles
- Vol. 9 (1) , 1189-1203
UAV Path Planning With Terrain Constraints for Aerial Scanning
A global path planning method constrained by dynamics, kinematics, and terrain is proposed for Vertical Takeoff and Landing (VTOL) Unmanned Aerial Vehicles (UAVs). Firstly, new constant-altitude waypoints are interpolated above the terrain based on altitude information and terrain resolution. Account for the coverage of airborne sensors over the surface area, a horizontal waypoint interpolation optimization (HOPT) is performed at positions with excessive bending in the horizontal direction. Secondly, for vertical plane optimization (VOPT), i.e., height optimization, a Soft Actor-Critic-based Particle Swarm Optimization (SAC-PSO) is employed to optimize the convergence speed of the method and achieve terrain following (TF). Thirdly, to evaluate the generated paths, a deep residual network (DRSN) is designed to mitigate the impact of optimization failures during the iteration process and improve the stability of the algorithm. Simulation experiments demonstrate the efficiency and path quality of the proposed method, while real-world tasks validate its practicality.
- Open Access
Global Optimization of UAV Area Coverage Path Planning Based on Good Point Set and Genetic Algorithm
When performing area coverage tasks in some special scenarios, fixed-wing aircraft conventionally adopt the scan-type of path planning, where the distance between two adjacent tracks is usually less than the minimum turning radius of the aircraft. This results in increased energy consumption during turning between adjacent tracks, which means a reduced task execution efficiency. To address this problem, the current paper proposes an area coverage path planning method for a fixed-wing unmanned aerial vehicle (UAV) based on an improved genetic algorithm. The algorithm improves the primary population generation of the traditional genetic algorithm, with the help of better crossover operator and mutation operator for the genetic operation. More specifically, the good point set algorithm (GPSA) is first used to generate a primary population that has a more uniform distribution than that of the random algorithm. Then, the heuristic crossover operator and the random interval inverse mutation operator are employed to reduce the risk of local optimization. The proposed algorithm is verified in tasks with different numbers of paths. A comparison with the conventional genetic algorithm (GA) shows that our algorithm can converge to a better solution.
Open AccessGlobal Optimization of UAV Area Coverage Path Planning Based on Good Point Set and Genetic Algorithm
When performing area coverage tasks in some special scenarios, fixed-wing aircraft conventionally adopt the scan-type of path planning, where the distance between two adjacent tracks is usually less than the minimum turning radius of the aircraft. This results in increased energy consumption during turning between adjacent tracks, which means a reduced task execution efficiency. To address this problem, the current paper proposes an area coverage path planning method for a fixed-wing unmanned aerial vehicle (UAV) based on an improved genetic algorithm. The algorithm improves the primary population generation of the traditional genetic algorithm, with the help of better crossover operator and mutation operator for the genetic operation. More specifically, the good point set algorithm (GPSA) is first used to generate a primary population that has a more uniform distribution than that of the random algorithm. Then, the heuristic crossover operator and the random interval inverse mutation operator are employed to reduce the risk of local optimization. The proposed algorithm is verified in tasks with different numbers of paths. A comparison with the conventional genetic algorithm (GA) shows that our algorithm can converge to a better solution.
- Open Access
- 22 September 2021
- Published by MDPI AG in ISPRS International Journal of Geo-Information
- Vol. 10 (10) , 631
Efficient and High Path Quality Autonomous Exploration and Trajectory Planning of UAV in an Unknown Environment
The ability of an autonomous Unmanned Aerial Vehicle (UAV) in an unknown environment is a prerequisite for its execution of complex tasks and is the main research direction in related fields. The autonomous navigation of UAVs in unknown environments requires solving the problem of autonomous exploration of the surrounding environment and path planning, which determines whether the drones can complete mission-based flights safely and efficiently. Existing UAV autonomous flight systems hardly perform well in terms of efficient exploration and flight trajectory quality. This paper establishes an integrated solution for autonomous exploration and path planning. In terms of autonomous exploration, frontier-based and sampling-based exploration strategies are integrated to achieve fast and effective exploration performance. In the study of path planning in complex environments, an advanced Rapidly Exploring Random Tree (RRT) algorithm combining the adaptive weights and dynamic step size is proposed, which effectively solves the problem of balancing flight time and trajectory quality. Then, this paper uses the Hermite difference polynomial to optimization the trajectory generated by the RRT algorithm. We named proposed UAV autonomous flight system as Frontier and Sampling-based Exploration and Advanced RRT Planner system (FSEPlanner). Simulation performs in both apartment and maze environment, and results show that the proposed FSEPlanner algorithm achieves greatly improved time consumption and path distances, and the smoothed path is more in line with the actual flight needs of a UAV.
- 22 September 2021
- Published by MDPI AG in ISPRS International Journal of Geo-Information
- Vol. 10 (10) , 631
Open AccessEfficient and High Path Quality Autonomous Exploration and Trajectory Planning of UAV in an Unknown Environment
The ability of an autonomous Unmanned Aerial Vehicle (UAV) in an unknown environment is a prerequisite for its execution of complex tasks and is the main research direction in related fields. The autonomous navigation of UAVs in unknown environments requires solving the problem of autonomous exploration of the surrounding environment and path planning, which determines whether the drones can complete mission-based flights safely and efficiently. Existing UAV autonomous flight systems hardly perform well in terms of efficient exploration and flight trajectory quality. This paper establishes an integrated solution for autonomous exploration and path planning. In terms of autonomous exploration, frontier-based and sampling-based exploration strategies are integrated to achieve fast and effective exploration performance. In the study of path planning in complex environments, an advanced Rapidly Exploring Random Tree (RRT) algorithm combining the adaptive weights and dynamic step size is proposed, which effectively solves the problem of balancing flight time and trajectory quality. Then, this paper uses the Hermite difference polynomial to optimization the trajectory generated by the RRT algorithm. We named proposed UAV autonomous flight system as Frontier and Sampling-based Exploration and Advanced RRT Planner system (FSEPlanner). Simulation performs in both apartment and maze environment, and results show that the proposed FSEPlanner algorithm achieves greatly improved time consumption and path distances, and the smoothed path is more in line with the actual flight needs of a UAV.