Jun-Ichi Yamada
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jun-Ichi Yamada has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Hiroki Akutsu
Department of Chemistry, Graduate School of Science, Osaka University, 1-1 Machikaneyama-cho, Toyonaka, Osaka 560-0043, Japan
3 shared publications - Hiroyuki Anzai
Department of Surgical Oncology, the University of Tokyo, Tokyo, Japan
2 shared publications - Hiroyuki Tajima
Graduate School of Science, University of Hyogo, Ako-gun, Hyogo 678-1297, Japan
2 shared publications Akihiro Kameda
1 shared publication- Aleksei Kovalev
Novosibirsk State University of Economics and Management
1 shared publication Ayumi Kojoh
Graduate School of Material Science, University of Hyogo, 3‐2‐1 Kouto, Kamigori, Hyogo 678‐1297 (Japan), Fax: (+81) 791‐58‐0164
1 shared publication
Latest Publications
- 1 March 2022
- Published by Elsevier in Journal of Luminescence
- Vol. 243
Whispering gallery modes in bowl-shaped stilbene microresonators
- 1 March 2022
- Published by Elsevier in Journal of Luminescence
- Vol. 243
Whispering gallery modes in bowl-shaped stilbene microresonators
- 24 September 2021
- Published by American Physical Society (APS) in Physical Review B
- Vol. 104 (11) , 115152
Ultrafast dynamics of Mott-state quench and formation in strongly correlated BEDT-TTF molecular conductors observed by three-pulse pump probe spectroscopy
We investigate the quench and real-time formation of the Mott state and photoexcited carrier relaxation dynamics in the Mott insulator and the superconductor using three-pulse femtosecond optical spectroscopy, where BEDT-TTF is bis(ethylenedithio)tetrathiafulvalene. In both salts, we find that transient reflectivity amplitude gradually recovers with time after strong near-infrared pulse quench, but its relaxation time is nearly constant throughout. This indicates that in -Cl, the energy gap for charge excitations is filled rather than closed by photoinduced carriers of only % per dimer. The Mott state is re-formed on a few-picosecond timescale with the disappearance of the in-gap photodoping-induced states near the Fermi energy. In -Br, a behavior similar to that in -Cl is observed and attributed to the disorder-induced phase-separated Mott insulating regions.- 24 September 2021
- Published by American Physical Society (APS) in Physical Review B
- Vol. 104 (11) , 115152
Ultrafast dynamics of Mott-state quench and formation in strongly correlated BEDT-TTF molecular conductors observed by three-pulse pump probe spectroscopy
We investigate the quench and real-time formation of the Mott state and photoexcited carrier relaxation dynamics in the Mott insulator and the superconductor using three-pulse femtosecond optical spectroscopy, where BEDT-TTF is bis(ethylenedithio)tetrathiafulvalene. In both salts, we find that transient reflectivity amplitude gradually recovers with time after strong near-infrared pulse quench, but its relaxation time is nearly constant throughout. This indicates that in -Cl, the energy gap for charge excitations is filled rather than closed by photoinduced carriers of only % per dimer. The Mott state is re-formed on a few-picosecond timescale with the disappearance of the in-gap photodoping-induced states near the Fermi energy. In -Br, a behavior similar to that in -Cl is observed and attributed to the disorder-induced phase-separated Mott insulating regions.- 1 December 2017
- Published by Elsevier in Organic Electronics
- Vol. 51, 162-167
Estimation of hole injection barrier at the poly-3(hexylthiophene)/metal interface using accumulated charge measurement
- 1 December 2017
- Published by Elsevier in Organic Electronics
- Vol. 51, 162-167
Estimation of hole injection barrier at the poly-3(hexylthiophene)/metal interface using accumulated charge measurement
- Open Access
- 8 February 2013
- Published by Wiley in Asian Journal of Organic Chemistry
- Vol. 2 (2) , 101
Cover Picture: Self‐Assembling Aryl‐Naphthalendiimide Derivatives with a Nitroxide Radical (Asian J. Org. Chem. 2/2013)
- 8 February 2013
- Published by Wiley in Asian Journal of Organic Chemistry
- Vol. 2 (2) , 101
Open AccessCover Picture: Self‐Assembling Aryl‐Naphthalendiimide Derivatives with a Nitroxide Radical (Asian J. Org. Chem. 2/2013)
- Open Access
- 1 January 2010
- Published by Japan Society of Mechanical Engineers in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
- Vol. 76 (769) , 1147-1152
Estimation of Inelastic Behavior for a Tapered Nozzle in Vessel due to Thermal Transient Load Using Stress Redistribution Locus Method
Simplified inelastic design procedures for elevated temperature components have been required to reduce simulation cost and to shorten a period of time for developing new projects. Stress redistribution locus (SRL) method has been proposed to provide a reasonable estimate employing both the elastic FEM analysis and a unique hyperbolic curve: ε^^〜={1/σ^^〜+(κ-1)σ^^〜}/κ, where ε^^〜 and σ^^〜 show dimensionless strain and stress normalized by corresponding elastic ones, respectively. This method is based on a fact that stress distribution in well deformed or high temperature components would change with deformation or time, and that the relation between the dimensionless stress and strain traces a kind of the elastic follow-up locus in spite of the constitutive equation of material and loading modes. In this paper, FEM analyses incorporating plasticity and creep in were performed for a tapered nozzle in reactor vessel under some thermal transient loads through the nozzle thickness. The normalized stress and strain was compared with the proposed SRL curve. Calculation results revealed that a critical point in the tapered nozzle due to the thermal transient load depended on a descending rate of temperature from the higher temperature in the operation cycle. Since the inelastic behavior in the nozzle resulted in a restricted area, the relationship between the normalized stress and strain was depicted inside the proposed SRL curve: Coefficient κ of the SRL in analyses is greater than the proposed one, and the present criterion guarantees robust structures for complicated components involving inelastic deformation.
- 1 January 2010
- Published by Japan Society of Mechanical Engineers in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
- Vol. 76 (769) , 1147-1152
Open AccessEstimation of Inelastic Behavior for a Tapered Nozzle in Vessel due to Thermal Transient Load Using Stress Redistribution Locus Method
Simplified inelastic design procedures for elevated temperature components have been required to reduce simulation cost and to shorten a period of time for developing new projects. Stress redistribution locus (SRL) method has been proposed to provide a reasonable estimate employing both the elastic FEM analysis and a unique hyperbolic curve: ε^^〜={1/σ^^〜+(κ-1)σ^^〜}/κ, where ε^^〜 and σ^^〜 show dimensionless strain and stress normalized by corresponding elastic ones, respectively. This method is based on a fact that stress distribution in well deformed or high temperature components would change with deformation or time, and that the relation between the dimensionless stress and strain traces a kind of the elastic follow-up locus in spite of the constitutive equation of material and loading modes. In this paper, FEM analyses incorporating plasticity and creep in were performed for a tapered nozzle in reactor vessel under some thermal transient loads through the nozzle thickness. The normalized stress and strain was compared with the proposed SRL curve. Calculation results revealed that a critical point in the tapered nozzle due to the thermal transient load depended on a descending rate of temperature from the higher temperature in the operation cycle. Since the inelastic behavior in the nozzle resulted in a restricted area, the relationship between the normalized stress and strain was depicted inside the proposed SRL curve: Coefficient κ of the SRL in analyses is greater than the proposed one, and the present criterion guarantees robust structures for complicated components involving inelastic deformation.
- 6 October 2009
- Published by Elsevier in Synthetic Metals
- Vol. 159 (21-22) , 2394-2396
Quantum critical behavior in the organic conductor κ-(DHDA-TTP)2SbF6
- 6 October 2009
- Published by Elsevier in Synthetic Metals
- Vol. 159 (21-22) , 2394-2396
Quantum critical behavior in the organic conductor κ-(DHDA-TTP)2SbF6
- 1 June 2007
- Published by Elsevier in Polyhedron
- Vol. 26 (9-11) , 2287-2290
Radical salts derived from TEMPO-substituted 2,4,6-triphenylpyridinium
- 1 June 2007
- Published by Elsevier in Polyhedron
- Vol. 26 (9-11) , 2287-2290
Radical salts derived from TEMPO-substituted 2,4,6-triphenylpyridinium
- 1 June 2001
- Published by Pleiades Publishing Ltd in Journal of Experimental and Theoretical Physics
- Vol. 92 (6) , 1035-1037
The anisotropic low-temperature specific heat of organic superconductor κ-(BEDT-TTF)2CU(NCS)2 in magnetic field
We measured the low-temperature specific heat of the layered organic superconductor κ-(BEDT-TTF)2Cu(NCS)2 for the magnetic field directed along and across the conducting plane and found a difference b
- 1 June 2001
- Published by Pleiades Publishing Ltd in Journal of Experimental and Theoretical Physics
- Vol. 92 (6) , 1035-1037
The anisotropic low-temperature specific heat of organic superconductor κ-(BEDT-TTF)2CU(NCS)2 in magnetic field
We measured the low-temperature specific heat of the layered organic superconductor κ-(BEDT-TTF)2Cu(NCS)2 for the magnetic field directed along and across the conducting plane and found a difference b
- 12 March 1999
- Published by Wiley in Angewandte Chemie
- Vol. 111 (6) , 841-843
BDH-TTP, ein Isomer von BEDT-TTF, und sein zweidimensional geschichtetes Hexafluorophosphatsalz
- 12 March 1999
- Published by Wiley in Angewandte Chemie
- Vol. 111 (6) , 841-843
BDH-TTP, ein Isomer von BEDT-TTF, und sein zweidimensional geschichtetes Hexafluorophosphatsalz