Woojung Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Woojung Kim has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Myunghee Lee
Sapien Semiconductors Inc., Seoul, South Korea
2 shared publications - Jae Joon Kim
Department of Electrical Engineering, Ulsan National Institute of Science and Technology, Ulsan, South Korea
1 shared publication - Woojin Hong
Department of Electrical Engineering, Ulsan National Institute of Science and Technology, Ulsan, South Korea
1 shared publication
Latest Publications
- 27 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 31 (6) , 851-860
A 5.4-Gb/s, 0.57-pJ/bit, Single-Loop Referenceless CDR With an Unlimited Bilateral Frequency Detection Scheme
This article proposes a single-loop referenceless clock and data recovery (CDR) with a bilateral bang-bang phase and frequency detector (BBPFD). The CDR achieves an unlimited frequency acquisition range in both directions of the lock frequency. The proposed BBPFD tracks the frequency by using the asymmetry of UP/DN output probability of the bang-bang phase detector (BBPD). A seamless transition between frequency acquisition and phase tracking is possible through a simple modification of the existing BBPD. The CDR has a locking time of $3 \mu \text{s}$ under the PRBS7 pattern. The test chip was fabricated in a 28-nm CMOS process. It supports a 5.4-Gb/s link rate, making it compatible with the embedded DisplayPort (eDP) standard v1.2. The total power consumption is 3.04 mW at a speed of 5.4 Gb/s/lane. The power efficiency is 0.57-pJ/bit at a supply voltage of 0.9 V.
- 27 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 31 (6) , 851-860
A 5.4-Gb/s, 0.57-pJ/bit, Single-Loop Referenceless CDR With an Unlimited Bilateral Frequency Detection Scheme
This article proposes a single-loop referenceless clock and data recovery (CDR) with a bilateral bang-bang phase and frequency detector (BBPFD). The CDR achieves an unlimited frequency acquisition range in both directions of the lock frequency. The proposed BBPFD tracks the frequency by using the asymmetry of UP/DN output probability of the bang-bang phase detector (BBPD). A seamless transition between frequency acquisition and phase tracking is possible through a simple modification of the existing BBPD. The CDR has a locking time of $3 \mu \text{s}$ under the PRBS7 pattern. The test chip was fabricated in a 28-nm CMOS process. It supports a 5.4-Gb/s link rate, making it compatible with the embedded DisplayPort (eDP) standard v1.2. The total power consumption is 3.04 mW at a speed of 5.4 Gb/s/lane. The power efficiency is 0.57-pJ/bit at a supply voltage of 0.9 V.
- 21 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 68 (10) , 3219-3223
A 92-μW/Gbps Self-Biased SLVS Receiver for MIPI D-PHY Applications
This brief introduces a self-biased Scalable Low-Voltage Signaling (SLVS) receiver circuit in order to minimize the power dissipation on D-PHY layer of the Mobile Industry Processor Interface (MIPI). This design does not require any static bias circuitry. It can also support an input common-mode voltage of the receiver as low as 50 mV. This allows D-PHY transmitter to use lower common-mode voltage further reducing the power dissipation of the transceiver pair of D-PHY layer. It is fabricated in a 180-nm CMOS process. The test results show that it operates up to 2 Gbps at 1.2 V power supply in High Speed-mode (HS-mode) of MIPI D-PHY standard. The power efficiency is 92 μW /Gbps or 77 μA/Gbps.
- 21 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 68 (10) , 3219-3223
A 92-μW/Gbps Self-Biased SLVS Receiver for MIPI D-PHY Applications
This brief introduces a self-biased Scalable Low-Voltage Signaling (SLVS) receiver circuit in order to minimize the power dissipation on D-PHY layer of the Mobile Industry Processor Interface (MIPI). This design does not require any static bias circuitry. It can also support an input common-mode voltage of the receiver as low as 50 mV. This allows D-PHY transmitter to use lower common-mode voltage further reducing the power dissipation of the transceiver pair of D-PHY layer. It is fabricated in a 180-nm CMOS process. The test results show that it operates up to 2 Gbps at 1.2 V power supply in High Speed-mode (HS-mode) of MIPI D-PHY standard. The power efficiency is 92 μW /Gbps or 77 μA/Gbps.