Doina Toma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Doina Toma has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
Adrian Salistean
National Research & Development Institute for Textiles and Leather, 16 Lucretiu Patrascanu Street, 030508, Sector 3, Bucharest, Romania
2 shared publicationsAlina Popescu
National Research & Development Institute for Textiles and Leather, 16 Lucretiu Patrascanu Street, 030508, Sector 3, Bucharest, Romania
2 shared publications- Alina Popescu
National Research and Development Institute for Textiles and Leather—INCDTP, 16 Lucrețiu Pătrășcanu, 030508 Bucharest, Romania
2 shared publications - Laura Chirila
National Research and Development Institute for Textiles and Leather—INCDTP, 16 Lucrețiu Pătrășcanu, 030508 Bucharest, Romania
2 shared publications - Alexandru Carâp
General Surgery Department, Faculty of Medicine, “Carol Davila” University of Medicine and Pharmacy, 37 Dionisie Lupu Str., 030167 Bucharest, Romania
1 shared publication - Ana-Maria Pleava
CAMPUS Research Institute, National University of Science and Technology Politehnica Bucharest, 060042 Bucharest, Romania
1 shared publication
Latest Publications
- Open Access
- 16 November 2026
- Published by MDPI AG in Microplastics
- Vol. 5 (4) , 232
Evaluation of the Released Fiber Fragments from Commercial Synthetic Sportswear During Washing
The widespread use of synthetic materials in sportswear has raised concerns regarding the release of fiber fragments during laundering and their contribution to environmental plastic pollution. This study investigated the release of fiber fragments during washing of various synthetic sportswear items such as polyester (PET), recycled polyester (rPET), polyamide/elastane (PA/EL), recycled polyamide/elastane (rPA/EL), as well as prewashed PA/EL samples. The processing of aqueous effluents consisted of filtering the entire washing solution (150 mL) and rinsing water (200 mL) using different filters for fraction separation. The higher release of fiber fragments observed by optical microscopy is supported by the PA/EL (204 fiber fragments/g of textile material), while the rPET shed 88 fiber fragments/g of textile material. Furthermore, the long washing cycles led to a reduced number of fiber fragments (about 57 fiber fragments/g of textile material for the PA/EL-W50 sample). Also, the perforated fabric structure promoted the release of 153 fiber fragments/g of textile sample. The PA/EL and PA/EL/P-W50 samples shed a high abundance of fiber fragments smaller than 500 µm after washing.
- 16 November 2026
- Published by MDPI AG in Microplastics
- Vol. 5 (4) , 232
Open AccessEvaluation of the Released Fiber Fragments from Commercial Synthetic Sportswear During Washing
The widespread use of synthetic materials in sportswear has raised concerns regarding the release of fiber fragments during laundering and their contribution to environmental plastic pollution. This study investigated the release of fiber fragments during washing of various synthetic sportswear items such as polyester (PET), recycled polyester (rPET), polyamide/elastane (PA/EL), recycled polyamide/elastane (rPA/EL), as well as prewashed PA/EL samples. The processing of aqueous effluents consisted of filtering the entire washing solution (150 mL) and rinsing water (200 mL) using different filters for fraction separation. The higher release of fiber fragments observed by optical microscopy is supported by the PA/EL (204 fiber fragments/g of textile material), while the rPET shed 88 fiber fragments/g of textile material. Furthermore, the long washing cycles led to a reduced number of fiber fragments (about 57 fiber fragments/g of textile material for the PA/EL-W50 sample). Also, the perforated fabric structure promoted the release of 153 fiber fragments/g of textile sample. The PA/EL and PA/EL/P-W50 samples shed a high abundance of fiber fragments smaller than 500 µm after washing.
- Open Access
- 5 November 2026
- Published by MDPI AG in Pharmaceutics
- Vol. 18 (11) , 1434
Minocycline–Collagen Coatings on Textile Surgical Mesh
Background/Objectives: Synthetic mesh repair of abdominal wall hernias can be complicated by infection, often requiring mesh removal. Bioactive coatings may enable local antimicrobial delivery while preserving mesh properties. This study developed a synthetic surgical mesh coated with a minocycline hydrochloride (MH)-loaded type I fibrillar collagen gel, evaluated MH concentration and coating layer effects, optimized the formulation, and assessed preliminary in vivo tolerability and wound healing. Methods: Collagen gel containing MH was applied to meshes by repeated immersion/drying (1–3 layers) using a Mitchell-Bayne 32 design. Meshes were characterized by optical microscopy, SEM, contact angle, enzymatic degradation, and MH release, and in vivo clinical trials were conducted in 20 Wistar rats using superficial excisional and thermal injury models. Results: SEM proved collagen/MH deposition. The meshes with 0.6% MH showed the highest enzymatic resistance. Release was rapid in the first 60 min and then gradual; the Power law model fitted best (R2 > 0.97), indicating non-Fickian release. The mesh coated with two layers of collagen consisting of 0.6% MH promoted faster wound closure than controls: complete re-epithelialization by day 5 for superficial wounds, and complete thermal wound healing by day 10. No macroscopic local intolerance or systemic adverse reactions occurred. Conclusions: The MH-loaded collagen-coated textile mesh provided controlled local drug delivery, enzymatic stability, and preliminary wound-healing benefits with good local tolerability.
- 5 November 2026
- Published by MDPI AG in Pharmaceutics
- Vol. 18 (11) , 1434
Open AccessMinocycline–Collagen Coatings on Textile Surgical Mesh
Background/Objectives: Synthetic mesh repair of abdominal wall hernias can be complicated by infection, often requiring mesh removal. Bioactive coatings may enable local antimicrobial delivery while preserving mesh properties. This study developed a synthetic surgical mesh coated with a minocycline hydrochloride (MH)-loaded type I fibrillar collagen gel, evaluated MH concentration and coating layer effects, optimized the formulation, and assessed preliminary in vivo tolerability and wound healing. Methods: Collagen gel containing MH was applied to meshes by repeated immersion/drying (1–3 layers) using a Mitchell-Bayne 32 design. Meshes were characterized by optical microscopy, SEM, contact angle, enzymatic degradation, and MH release, and in vivo clinical trials were conducted in 20 Wistar rats using superficial excisional and thermal injury models. Results: SEM proved collagen/MH deposition. The meshes with 0.6% MH showed the highest enzymatic resistance. Release was rapid in the first 60 min and then gradual; the Power law model fitted best (R2 > 0.97), indicating non-Fickian release. The mesh coated with two layers of collagen consisting of 0.6% MH promoted faster wound closure than controls: complete re-epithelialization by day 5 for superficial wounds, and complete thermal wound healing by day 10. No macroscopic local intolerance or systemic adverse reactions occurred. Conclusions: The MH-loaded collagen-coated textile mesh provided controlled local drug delivery, enzymatic stability, and preliminary wound-healing benefits with good local tolerability.
- Open Access
Novel Collagen-Based Emulsions Embedded with Palmarosa Essential Oil, and Chamomile and Calendula Tinctures, for Skin-Friendly Textile Materials
Skin-friendly textile materials were obtained by applying oil-in-water emulsions based on palmarosa essential oil, chamomile, and calendula tinctures onto cotton fabrics. Different formulations based on these bioactive principles incorporated in collagen as polymeric matrices were prepared and immobilized on a plain weave textile structure from 100% cotton. The functionalized textile materials were characterized in terms of physicochemical, mechanical, antibacterial, and biocompatibility points of view. The pH values of the prepared emulsions were in the range of 4.81–5.23 and showed no significant differences after 4 h of storage. Moreover, the addition of a higher quantity of active principles (palmarosa essential oil and plant tinctures) caused slightly lower values of acidic pH. The electrical conductivity of the obtained emulsions increased with the decrease in the oil phases in the system. The highest values were obtained for the emulsion developed with the smallest volume fraction of active principle—palmarosa essential oil and plant tinctures. The emulsion that contained the least amount of collagen and the highest number of active principles exhibited the lowest stability. The textile materials treated with synthesized emulsions exerted antibacterial effects against S. aureus and E. coli strains and did not affect keratinocyte growth, spreading, and organization, highlighting the biocompatibility of these developed skin-friendly textiles.
Open AccessNovel Collagen-Based Emulsions Embedded with Palmarosa Essential Oil, and Chamomile and Calendula Tinctures, for Skin-Friendly Textile Materials
Skin-friendly textile materials were obtained by applying oil-in-water emulsions based on palmarosa essential oil, chamomile, and calendula tinctures onto cotton fabrics. Different formulations based on these bioactive principles incorporated in collagen as polymeric matrices were prepared and immobilized on a plain weave textile structure from 100% cotton. The functionalized textile materials were characterized in terms of physicochemical, mechanical, antibacterial, and biocompatibility points of view. The pH values of the prepared emulsions were in the range of 4.81–5.23 and showed no significant differences after 4 h of storage. Moreover, the addition of a higher quantity of active principles (palmarosa essential oil and plant tinctures) caused slightly lower values of acidic pH. The electrical conductivity of the obtained emulsions increased with the decrease in the oil phases in the system. The highest values were obtained for the emulsion developed with the smallest volume fraction of active principle—palmarosa essential oil and plant tinctures. The emulsion that contained the least amount of collagen and the highest number of active principles exhibited the lowest stability. The textile materials treated with synthesized emulsions exerted antibacterial effects against S. aureus and E. coli strains and did not affect keratinocyte growth, spreading, and organization, highlighting the biocompatibility of these developed skin-friendly textiles.
- 22 December 2023
- Published by The National Research and Development Institute for Textiles and Leather in Industria Textila
- Vol. 74 (06) , 753-759
Evaluation of the comfort properties of functional knitted fabrics for people with special needs
In this study, several comfort properties of knitted fabrics were investigated. Seven types of knitted fabrics made of combinations of natural fibres (e.g., cotton, wool, and bamboo), artificial fibres (e.g., modal) and synthetic fibres (e.g., polyester and acrylic) were produced. The knitted samples were subjected to several comfort tests, including air permeability, thermal resistance and water vapour resistance assessments. To determine the correlations among the comfort properties of the fabric, fabric structural properties, such as fabric weight and fabric thickness, were considered. Moreover, statistically significant differences were found in terms of dry thermal resistance, water vapour resistance and air permeability depending on the structural parameters of the fabric.
- 22 December 2023
- Published by The National Research and Development Institute for Textiles and Leather in Industria Textila
- Vol. 74 (06) , 753-759
Evaluation of the comfort properties of functional knitted fabrics for people with special needs
In this study, several comfort properties of knitted fabrics were investigated. Seven types of knitted fabrics made of combinations of natural fibres (e.g., cotton, wool, and bamboo), artificial fibres (e.g., modal) and synthetic fibres (e.g., polyester and acrylic) were produced. The knitted samples were subjected to several comfort tests, including air permeability, thermal resistance and water vapour resistance assessments. To determine the correlations among the comfort properties of the fabric, fabric structural properties, such as fabric weight and fabric thickness, were considered. Moreover, statistically significant differences were found in terms of dry thermal resistance, water vapour resistance and air permeability depending on the structural parameters of the fabric.
- 1 January 2023
- Published by The National Research and Development Institute for Textiles and Leather in Industria Textila
- Vol. 74 (1) , 121-129
Protective clothing system for interventions in emergency situations
- 1 January 2023
- Published by The National Research and Development Institute for Textiles and Leather in Industria Textila
- Vol. 74 (1) , 121-129
Protective clothing system for interventions in emergency situations
- Open Access
Multivariate Correlation Analysis of the Electroconductive Textiles Obtained Using Functionalization by Radio-Frequency Oxygen Plasma Treatments
This paper presents a study concerning the preliminary treatments in radiofrequency (RF)oxygen (O2) plasma used to obtain a hydrophilic effect on raw cotton fabrics followed by electroconductive thin film deposition to obtain electroconductive textile surfaces. In addition, this study presents a multivariate correlation analysis of experimental parameters. The treatment using RF plasma O2 aimed to increase the hydrophilic character of the raw fabric and adherence of paste-based polymeric on polyvinyl alcohol (PVA) matrix and nickel (Ni), silver (Ag) or copper (Cu) microparticles. The purpose of the research was to develop electroconductive textiles for flexible electrodes, smart materials using a clean technology such as radiofrequency (RF) plasma O2 to obtain a hydrophilic surface with zero wastewater and reduced chemicals and carbon footprint. To achieve the foreseen results, we used advanced functionalization technologies such as RF plasma O2, followed by scraping a thin film of conductive paste-based Ni, Ag or Cu microparticles, and multivariate correlation methods to observe the dependence between parameters involved (dependent and independent variables). Overall, the fabrics treated in plasma with O2 using a kHz or MHz generator and power 100–200 W present an excellent hydrophilic character obtained in 3 min. After RF O2 plasma functionalization, a thin film based on polymeric matrix PVA and Ni microparticles have been deposited on the fabric surface to obtain electroconductive materials.
Open AccessMultivariate Correlation Analysis of the Electroconductive Textiles Obtained Using Functionalization by Radio-Frequency Oxygen Plasma Treatments
This paper presents a study concerning the preliminary treatments in radiofrequency (RF)oxygen (O2) plasma used to obtain a hydrophilic effect on raw cotton fabrics followed by electroconductive thin film deposition to obtain electroconductive textile surfaces. In addition, this study presents a multivariate correlation analysis of experimental parameters. The treatment using RF plasma O2 aimed to increase the hydrophilic character of the raw fabric and adherence of paste-based polymeric on polyvinyl alcohol (PVA) matrix and nickel (Ni), silver (Ag) or copper (Cu) microparticles. The purpose of the research was to develop electroconductive textiles for flexible electrodes, smart materials using a clean technology such as radiofrequency (RF) plasma O2 to obtain a hydrophilic surface with zero wastewater and reduced chemicals and carbon footprint. To achieve the foreseen results, we used advanced functionalization technologies such as RF plasma O2, followed by scraping a thin film of conductive paste-based Ni, Ag or Cu microparticles, and multivariate correlation methods to observe the dependence between parameters involved (dependent and independent variables). Overall, the fabrics treated in plasma with O2 using a kHz or MHz generator and power 100–200 W present an excellent hydrophilic character obtained in 3 min. After RF O2 plasma functionalization, a thin film based on polymeric matrix PVA and Ni microparticles have been deposited on the fabric surface to obtain electroconductive materials.