Qin Qin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Qin Qin has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Philip Rubini
School of Engineering, University of Hull, Hull HU6 7RX, UK
3 shared publications - James Naylor
The Acoustics Research Centre, The University of Hull, Hull HU6 7RX, UK
2 shared publications - Simeon D. Stoyanov
Unilever R&D Vlaardingen, Olivier van Noortlaan 120, Vlaardingen, The Netherlands
2 shared publications - Vesselin N. Paunov
Department of Chemistry, School of Sciences and Humanities, Nazarbayev University, Kabanbay Batyr Avenue 53, Astana, 010000, Kazakhstan
2 shared publications - Benjamin Chalk
The University of Hull
1 shared publication - Benjamin R. Thompson
Department of Chemical and Biomolecular Engineering, Center for Neutron Science, University of Delaware, Newark, DE 19716, Delaware, USA
1 shared publication
Latest Publications
- Open Access
Reflection of Wind Turbine Noise from Rough Ground Using 3D Multiple Scattering Theory
Ground roughness is investigated for its influence on the propagation of wind turbine noise by using a proposed multiple scattering theory to predict the reflection of sound waves from a deterministic distribution of hemispheres. By using a distribution of hemispheres as an approximation for a realistic rough ground, a semi-analytical formulation for the reflected sound pressure is possible. Experiments are conducted within the University of Hull’s anechoic chamber and the results are compared against predictions from the proposed theory. Good agreement between the results is shown. The proposed multiple scattering theory also gives results consistent with a three-dimensional boundary element method, while having significantly shorter computation times and smaller memory requirements. Furthermore, results remain accurate up to the point where the radii of the hemispheres are comparable to the wavelengths of interest, which means that the scattering effect can be investigated more completely. When the proposed theory was applied to the unique source–receiver geometry of a wind turbine and a human height receiver, the excess attenuation calculated over an array of receivers showed significant fluctuations in sound pressure which were attributed to the ground roughness. Further works aim to incorporate weak refraction effects and ground absorption to analyze the relative influence of different parameters.
Open AccessReflection of Wind Turbine Noise from Rough Ground Using 3D Multiple Scattering Theory
Ground roughness is investigated for its influence on the propagation of wind turbine noise by using a proposed multiple scattering theory to predict the reflection of sound waves from a deterministic distribution of hemispheres. By using a distribution of hemispheres as an approximation for a realistic rough ground, a semi-analytical formulation for the reflected sound pressure is possible. Experiments are conducted within the University of Hull’s anechoic chamber and the results are compared against predictions from the proposed theory. Good agreement between the results is shown. The proposed multiple scattering theory also gives results consistent with a three-dimensional boundary element method, while having significantly shorter computation times and smaller memory requirements. Furthermore, results remain accurate up to the point where the radii of the hemispheres are comparable to the wavelengths of interest, which means that the scattering effect can be investigated more completely. When the proposed theory was applied to the unique source–receiver geometry of a wind turbine and a human height receiver, the excess attenuation calculated over an array of receivers showed significant fluctuations in sound pressure which were attributed to the ground roughness. Further works aim to incorporate weak refraction effects and ground absorption to analyze the relative influence of different parameters.
- Open Access
Laboratory Validation of 3D Model and Investigating Its Application to Wind Turbine Noise Propagation over Rough Ground
In an investigation into how wind turbine noise interacts with the surrounding terrain, its propagation over rough ground is simulated using a parabolic equation code using a modified effective impedance model, which characterizes the effects of a three-dimensional, rigid roughness within a relatively long wavelength limit (). The model is validated by comparison to experiments conducted within an anechoic chamber wherein different source–receiver geometries are considered. The relative sound pressure level spectra from the parabolic equation code using the modified effective impedance model highlight a sensitivity to the roughness parameters. At a low frequency and far distance, the relative sound pressure level decreased as the roughness coverage increased. A difference of 4.9 dB has been reported. The simulations highlight how the roughness shifts the ground effect dips, resulting in the sound level at the distance of 2 km being altered. However, only the monochromatic wave has been discussed. Further work on broadband noise is desirable. Furthermore, due to the long wavelength limit, only a portion of audible wind turbine noise can be investigated.Open AccessLaboratory Validation of 3D Model and Investigating Its Application to Wind Turbine Noise Propagation over Rough Ground
In an investigation into how wind turbine noise interacts with the surrounding terrain, its propagation over rough ground is simulated using a parabolic equation code using a modified effective impedance model, which characterizes the effects of a three-dimensional, rigid roughness within a relatively long wavelength limit (). The model is validated by comparison to experiments conducted within an anechoic chamber wherein different source–receiver geometries are considered. The relative sound pressure level spectra from the parabolic equation code using the modified effective impedance model highlight a sensitivity to the roughness parameters. At a low frequency and far distance, the relative sound pressure level decreased as the roughness coverage increased. A difference of 4.9 dB has been reported. The simulations highlight how the roughness shifts the ground effect dips, resulting in the sound level at the distance of 2 km being altered. However, only the monochromatic wave has been discussed. Further work on broadband noise is desirable. Furthermore, due to the long wavelength limit, only a portion of audible wind turbine noise can be investigated. - Open Access
- 20 May 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (10) , 4677
A Porous Media Model for the Numerical Simulation of Acoustic Attenuation by Perforated Liners in the Presence of Grazing Flows
In this paper, a novel model is proposed for the numerical simulation of noise-attenuating perforated liners. Effusion cooling liners offer the potential of being able to attenuate combustion instabilities in gas turbine engines. However, the acoustic attenuation of a perforated liner is a combination of a number of interacting factors, resulting in the traditional approach of designing perforated combustor liners relying heavily on combustor rig tests. On the other hand, direct computation of thousands of small-scale holes is too expensive to be employed as an engineering design tool. In recognition of this, a novel physical velocity porous media (PVPM) model was recently proposed by the authors as a computationally less demanding approach to represent the acoustic attenuation of perforated liners. The model was previously validated for the normal incidence of a sound wave by comparison with experimental data from impedance tubes. In this paper, the model is further developed for configurations where the noise signal propagates in parallel with the perforated liners, both in the presence and absence of a mean flow. The model is significantly improved and successfully validated within coexisting grazing and bias flow scenarios, with reference to a series of well-recognized experimental data.
- 20 May 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (10) , 4677
Open AccessA Porous Media Model for the Numerical Simulation of Acoustic Attenuation by Perforated Liners in the Presence of Grazing Flows
In this paper, a novel model is proposed for the numerical simulation of noise-attenuating perforated liners. Effusion cooling liners offer the potential of being able to attenuate combustion instabilities in gas turbine engines. However, the acoustic attenuation of a perforated liner is a combination of a number of interacting factors, resulting in the traditional approach of designing perforated combustor liners relying heavily on combustor rig tests. On the other hand, direct computation of thousands of small-scale holes is too expensive to be employed as an engineering design tool. In recognition of this, a novel physical velocity porous media (PVPM) model was recently proposed by the authors as a computationally less demanding approach to represent the acoustic attenuation of perforated liners. The model was previously validated for the normal incidence of a sound wave by comparison with experimental data from impedance tubes. In this paper, the model is further developed for configurations where the noise signal propagates in parallel with the perforated liners, both in the presence and absence of a mean flow. The model is significantly improved and successfully validated within coexisting grazing and bias flow scenarios, with reference to a series of well-recognized experimental data.
- Open Access
- 1 June 2020
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1549 (3) , 032028
Characteristics of Splash Formed by the Impact of Liquid Jet on a Thin Liquid Film
For rotary cup granulation, the splash may occur during liquid slag falls onto the cup, which increases the risk of operation. By performing experiments for three liquids with different properties, including water, 95% ethanol and 30% glycerol-water solution, the characteristics of splash formed by the impact of liquid jet on a thin liquid film were studied. The experimental results showed that increasing the impact velocity and diameter leaded to intense splash, while increasing the viscosity and the surface tension reduced the scale of the splash.
- 1 June 2020
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1549 (3) , 032028
Open AccessCharacteristics of Splash Formed by the Impact of Liquid Jet on a Thin Liquid Film
For rotary cup granulation, the splash may occur during liquid slag falls onto the cup, which increases the risk of operation. By performing experiments for three liquids with different properties, including water, 95% ethanol and 30% glycerol-water solution, the characteristics of splash formed by the impact of liquid jet on a thin liquid film were studied. The experimental results showed that increasing the impact velocity and diameter leaded to intense splash, while increasing the viscosity and the surface tension reduced the scale of the splash.
- Open Access
- 4 April 2019
- Published by MDPI AG in Applied Sciences
- Vol. 9 (7) , 1419
A Model to Predict Acoustic Resonant Frequencies of Distributed Helmholtz Resonators on Gas Turbine Engines
Helmholtz resonators, traditionally designed as a narrow neck backed by a cavity, are widely applied to attenuate combustion instabilities in gas turbine engines. The use of multiple small holes with an equivalent open area to that of a single neck has been found to be able to significantly improve the noise damping bandwidth. This type of resonator is often referred to as “distributed Helmholtz resonator”. When multiple holes are employed, interactions between acoustic radiations from neighboring holes changes the resonance frequency of the resonator. In this work, the resonance frequencies from a series of distributed Helmholtz resonators were obtained via a series of highly resolved computational fluid dynamics simulations. A regression analysis of the resulting response surface was undertaken and validated by comparison with experimental results for a series of eighteen absorbers with geometries typically employed in gas turbine combustors. The resulting model demonstrates that the acoustic end correction length for perforations is closely related to the effective porosity of the perforated plate and will be obviously enhanced by acoustic radiation effect from the perforation area as a whole. This model is easily applicable for engineers in the design of practical distributed Helmholtz resonators.
- 4 April 2019
- Published by MDPI AG in Applied Sciences
- Vol. 9 (7) , 1419
Open AccessA Model to Predict Acoustic Resonant Frequencies of Distributed Helmholtz Resonators on Gas Turbine Engines
Helmholtz resonators, traditionally designed as a narrow neck backed by a cavity, are widely applied to attenuate combustion instabilities in gas turbine engines. The use of multiple small holes with an equivalent open area to that of a single neck has been found to be able to significantly improve the noise damping bandwidth. This type of resonator is often referred to as “distributed Helmholtz resonator”. When multiple holes are employed, interactions between acoustic radiations from neighboring holes changes the resonance frequency of the resonator. In this work, the resonance frequencies from a series of distributed Helmholtz resonators were obtained via a series of highly resolved computational fluid dynamics simulations. A regression analysis of the resulting response surface was undertaken and validated by comparison with experimental results for a series of eighteen absorbers with geometries typically employed in gas turbine combustors. The resulting model demonstrates that the acoustic end correction length for perforations is closely related to the effective porosity of the perforated plate and will be obviously enhanced by acoustic radiation effect from the perforation area as a whole. This model is easily applicable for engineers in the design of practical distributed Helmholtz resonators.
- 20 October 2017
- Published by Royal Society of Chemistry (RSC) in Materials Chemistry Frontiers
- Vol. 1 (12) , 2627-2637
Sound transmission loss of hierarchically porous composites produced by hydrogel templating and viscous trapping techniques
We produced hierarchically porous materials using hydrogel templating and viscous trapping techniques and studied how their sound insulating properties depend on the pore size and porosity.
- 20 October 2017
- Published by Royal Society of Chemistry (RSC) in Materials Chemistry Frontiers
- Vol. 1 (12) , 2627-2637
Sound transmission loss of hierarchically porous composites produced by hydrogel templating and viscous trapping techniques
We produced hierarchically porous materials using hydrogel templating and viscous trapping techniques and studied how their sound insulating properties depend on the pore size and porosity.
- 21 February 2015
- Published by Springer Nature in Journal of Materials Science
- Vol. 50 (9) , 3495-3503
Sound absorption of porous cement composites: effects of the porosity and the pore size
- 21 February 2015
- Published by Springer Nature in Journal of Materials Science
- Vol. 50 (9) , 3495-3503
Sound absorption of porous cement composites: effects of the porosity and the pore size