Yingyue Zhu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yingyue Zhu has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
Lingling Guo
State Key Laboratory of Food Science and Resources, Jiangnan University, Wuxi, Jiangsu, 214122, China; International Joint Research Laboratory for Biointerface and Biodetection, and School of Food Science and Technology, Jiangnan University, Wuxi, Jiangsu, 214122, China
3 shared publicationsLiqiang Liu
State Key Laboratory of Food Science and Technology, Jiangnan University, Wuxi, Jiangsu, 214122, People's Republic of China
3 shared publicationsShanshan Song
State Key Laboratory of Food Science and Technology, Jiangnan University, Wuxi, Jiangsu, 214122, People's Republic of China
3 shared publicationsChuanlai Xu
State Key Laboratory of Food Science and Resources, Jiangnan University, Wuxi, Jiangsu, 214122, China; International Joint Research Laboratory for Biointerface and Biodetection, and School of Food Science and Technology, Jiangnan University, Wuxi, Jiangsu, 214122, China
2 shared publications- Chuanlai Xu
Jiangnan University
2 shared publications Hua Kuang
State Key Laboratory of Food Science and Resources, Jiangnan University, Wuxi, Jiangsu, 214122, China; International Joint Research Laboratory for Biointerface and Biodetection, and School of Food Science and Technology, Jiangnan University, Wuxi, Jiangsu, 214122, China
2 shared publications
Latest Publications
- 10 January 2023
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 148 (4) , 780-786
Rapid and sensitive detection of chlordimeform in cucumber and tomato samples using an immunochromatographic assay
Chlordimeform (CDM) is a broad-spectrum and highly effective insecticide and acaricide used to control pests in agriculture. We produced two monoclonal antibodies (mAbs) against CDM and developed an immunochromatographic assay to screen CDM in cucumbers and tomatoes. MAb 4A3 had high sensitivity with a 50% inhibitory concentration of 0.287 ng mL−1. The assay had a cut-off value of 25 μg kg−1 and a visual limit of detection (vLOD) of 1 μg kg−1 in cucumbers and a cut off value of 50 μg kg−1 and a vLOD of 2.5 μg kg−1 in tomatoes. The calculated limit of detection (cLOD) in cucumbers and tomatoes was 0.115 μg kg−1 and 0.215 μg kg−1, respectively. The recovery rates were 97.9% to 106.9% for cucumbers and 97.8% to 107.4% for tomatoes, consistent with the results obtained from indirect competitive ELISA. Our findings showed that the immunochromatographic assay is an efficient and accurate method for CDM detection in cucumbers and tomatoes.
- 10 January 2023
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 148 (4) , 780-786
Rapid and sensitive detection of chlordimeform in cucumber and tomato samples using an immunochromatographic assay
Chlordimeform (CDM) is a broad-spectrum and highly effective insecticide and acaricide used to control pests in agriculture. We produced two monoclonal antibodies (mAbs) against CDM and developed an immunochromatographic assay to screen CDM in cucumbers and tomatoes. MAb 4A3 had high sensitivity with a 50% inhibitory concentration of 0.287 ng mL−1. The assay had a cut-off value of 25 μg kg−1 and a visual limit of detection (vLOD) of 1 μg kg−1 in cucumbers and a cut off value of 50 μg kg−1 and a vLOD of 2.5 μg kg−1 in tomatoes. The calculated limit of detection (cLOD) in cucumbers and tomatoes was 0.115 μg kg−1 and 0.215 μg kg−1, respectively. The recovery rates were 97.9% to 106.9% for cucumbers and 97.8% to 107.4% for tomatoes, consistent with the results obtained from indirect competitive ELISA. Our findings showed that the immunochromatographic assay is an efficient and accurate method for CDM detection in cucumbers and tomatoes.
- 9 July 2022
- Published by Elsevier in Food Chemistry
- Vol. 396, 133660
Ultrasensitive paper sensor for simultaneous detection of alpha-amanitin and beta-amanitin by the production of monoclonal antibodies
- 9 July 2022
- Published by Elsevier in Food Chemistry
- Vol. 396, 133660
Ultrasensitive paper sensor for simultaneous detection of alpha-amanitin and beta-amanitin by the production of monoclonal antibodies
- 2 June 2022
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 147 (15) , 3478-3485
Immunological quantitative detection of dicofol in medicinal materials
A quantitative immunochromatographic strip assay was developed for the rapid detection of dicofol in medicinal materials.
- 2 June 2022
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 147 (15) , 3478-3485
Immunological quantitative detection of dicofol in medicinal materials
A quantitative immunochromatographic strip assay was developed for the rapid detection of dicofol in medicinal materials.
- Open Access
- 1 January 2018
- Published by Taylor & Francis in Food and Agricultural Immunology
- Vol. 29 (1) , 1106-1115
Ultrasensitive detection of Bisphenol A based on an aptasensor with DNA amplification
An ultrasensitive and selective method for Bisphenol A (BPA) detection using aptamer-BPA and real-time quantitative polymerase chain reaction (RT-qPCR) technology is reported, in which biotin-modified aptamer DNA (BPA) is fixed on the inner wall of a streptavidin-coated PCR tube via biotin–avidin interactions and the template is fixed through the complementary base pairing with aptamer DNA. Upon the addition of BPA, the template DNA could be off from the inner wall of PCR tube, which results from aptamer DNA interacted specifically with BPA. Thus, the number of template DNA change result from the BPA concentration is readily seen by cycle threshold (Ct) values. The sensor exhibited an excellent linear response between Ct values and BPA concentration in the range of 1–500 nM and the detection limit of this method for aqueous BPA was as low as 0.7 nM. In addition, this method showed good selectivity for BPA over its analogues.
- 1 January 2018
- Published by Taylor & Francis in Food and Agricultural Immunology
- Vol. 29 (1) , 1106-1115
Open AccessUltrasensitive detection of Bisphenol A based on an aptasensor with DNA amplification
An ultrasensitive and selective method for Bisphenol A (BPA) detection using aptamer-BPA and real-time quantitative polymerase chain reaction (RT-qPCR) technology is reported, in which biotin-modified aptamer DNA (BPA) is fixed on the inner wall of a streptavidin-coated PCR tube via biotin–avidin interactions and the template is fixed through the complementary base pairing with aptamer DNA. Upon the addition of BPA, the template DNA could be off from the inner wall of PCR tube, which results from aptamer DNA interacted specifically with BPA. Thus, the number of template DNA change result from the BPA concentration is readily seen by cycle threshold (Ct) values. The sensor exhibited an excellent linear response between Ct values and BPA concentration in the range of 1–500 nM and the detection limit of this method for aqueous BPA was as low as 0.7 nM. In addition, this method showed good selectivity for BPA over its analogues.
- 4 February 2015
- Published by Springer Nature in Biotechnology Letters
- Vol. 37 (6) , 1233-1241
Enhancement of phenyllactic acid biosynthesis by recognition site replacement of D-lactate dehydrogenase from Lactobacillus pentosus
The Tyr52 residue of d-lactate dehydrogenase (d-LDH) from Lactobacillus pentosus was replaced with small hydrophobic residues and overexpressed in E. coli BL21 (DE3) to enhance 3-phenyllactic acid (PLA) synthesis by whole-cell catalyst. Escherichia coli pET-28a-d-ldh produced 12.2 g PLA l−1 in 3 h, with a molar conversion rate of 61 %, while E. coli pET-28a-d-ldh Y52V produced 15.6 g PLA l−1, with a molar conversion rate of 77 %. This study demonstrates the feasibility of using engineered E. coli for PLA production from phenylpyruvate (PPA) and showed that site-directed mutagenesis of d-ldh markedly improved PLA yield and substrate conversion rate. This biocatalytic system is a promising platform for PLA production from PPA.
- 4 February 2015
- Published by Springer Nature in Biotechnology Letters
- Vol. 37 (6) , 1233-1241
Enhancement of phenyllactic acid biosynthesis by recognition site replacement of D-lactate dehydrogenase from Lactobacillus pentosus
The Tyr52 residue of d-lactate dehydrogenase (d-LDH) from Lactobacillus pentosus was replaced with small hydrophobic residues and overexpressed in E. coli BL21 (DE3) to enhance 3-phenyllactic acid (PLA) synthesis by whole-cell catalyst. Escherichia coli pET-28a-d-ldh produced 12.2 g PLA l−1 in 3 h, with a molar conversion rate of 61 %, while E. coli pET-28a-d-ldh Y52V produced 15.6 g PLA l−1, with a molar conversion rate of 77 %. This study demonstrates the feasibility of using engineered E. coli for PLA production from phenylpyruvate (PPA) and showed that site-directed mutagenesis of d-ldh markedly improved PLA yield and substrate conversion rate. This biocatalytic system is a promising platform for PLA production from PPA.