DWDaniel Wendler

Daniel Wendler

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Daniel Wendler has a total of 73 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Two-dimensional dynamics of divertor detachment at ASDEX Upgrade

    by S Hörmann, M Cavedon, M Griener, D Wendler, D Brida, E Wolfrum, U Stroth, the ASDEX Upgrade Team

    A newly installed thermal helium beam diagnostic in the outer divertor of ASDEX Upgrade (Hörmann et al 2024 Rev. Sci. Instrum. 95 113507) was used for the first time to analyse two-dimensional (2D) electron temperature, density and pressure profiles. This diagnostic measures profiles with unprecedented spatial and temporal resolution, enabling the analysis of detachment transitions from onset state to fluctuating state in L-mode, including smooth transitions, detachment cliffs, and self-sustained divertor oscillations (SSDOs). This is a novelty for detachment studies, as such high-resolution 2D measurements have been lacking up to now, especially during the transitions between different divertor states. We focus on the pressure conservation and the behaviour of n e and T e along and perpendicular to the flux surfaces in the different phases of the transition. In addition, the propagation direction and velocity of the temperature collapse during SSDOs are investigated for the first time. They travel in the direction from the near scrape-off layer towards the far scrape-off layer and from the target towards the X-point at a velocity of a few tens of meters per second in the poloidal plane. This measurement is compared with the current models of SSDOs and detachment cliff generation.


  • Open Access

    Thermal helium beam diagnostic for 2D profile measurements in the divertor of ASDEX Upgrade

    by S. Hörmann, M. Cavedon, M. Griener, D. Wendler, R. Dux, K. Schmid, A. Kappatou, M. Wischmeier, D. J. Cruz-Zabala, E. Viezzer, et al.

    A new thermal helium beam diagnostic has been implemented in the outer lower divertor of the ASDEX Upgrade tokamak. The purpose of this diagnostic is to measure two-dimensional profiles of electron density (ne) and temperature (Te) with high temporal and spatial resolution. The geometry of the lines of sight is chosen to avoid the influence of prompt recycling and to optimize the resolution without significantly impacting the divertor structure. Moreover, the effect of long-term helium recycling has been analyzed, and its amplitude compared to the active signal is negligible. Finally, the reconstruction of ne and Te is done via a collisional radiative model, while a static and a dynamic model were implemented and compared with SOLPS simulations as well as divertor Thomson scattering data. Furthermore, a new 2D parameterization of the outer divertor volume, which is required for the dynamic model, was developed. Due to its fast and local ne and Te profile measurements, the diagnostic is suitable for investigating fast processes such as divertor transitions and filaments.


  • Open Access

    Observation of magnetic islands in tokamak plasmas during the suppression of edge-localized modes

    by Matthias Willensdorfer, Verena Mitterauer, Matthias Hoelzl, Wolfgang Suttrop, Mark Cianciosa, Mike Dunne, Rainer Fischer, Nils Leuthold, Jonas Puchmayr, Oleg Samoylov, et al.

    In tokamaks, a leading platform for fusion energy, periodic filamentary plasma eruptions known as edge-localized modes occur in plasmas with high-energy confinement and steep pressure profiles at the plasma edge. These edge-localized modes could damage the tokamak wall but can be suppressed using small three-dimensional magnetic perturbations. Here we demonstrate that these magnetic perturbations can change the magnetic topology just inside the steep gradient region of the plasma edge. We identify signatures of a magnetic island, and their observation is linked to the suppression of edge-localized modes. We compare high-resolution measurements of perturbed magnetic surfaces with predictions from ideal magnetohydrodynamic theory where the magnetic topology is preserved. Although ideal magnetohydrodynamics adequately describes the measurements in plasmas exhibiting edge-localized modes, it proves insufficient for plasmas where these modes are suppressed. Nonlinear resistive magnetohydrodynamic modelling supports this observation. Our study experimentally confirms the predicted role of magnetic islands in inhibiting the occurrence of edge-localized modes. This will be beneficial for physics-based predictions in future fusion devices to control these modes.


  • Open Access

    Effect of local wall clearance on scrape-off layer electron density profiles in ASDEX Upgrade

    by B. Tal, E. Wolfrum, M. Bernert, G. Birkenmeier, D. Brida, R. Fischer, G. Grenfell, M. Griener, O. Grover, J. Hobirk, et al.

    The plasma electron density is measured with multiple diagnostics in the scrape-off layer of the ASDEX Upgrade tokamak. The recorded values are typically in good agreement in the case of exponentially decaying profiles at low densities, but they become inconsistent as soon as a density shoulder is formed, and up to a factor of 3 deviation is experienced at high densities. An idea is put forward; namely, that the local plasma-wall proximity has an influence on the local density and thus the measurement results depend on the local limiter-plasma and limiter-diagnostic distances at the same time. The effect of local wall clearance dependence is demonstrated by creating a plasma having an extremely high scrape-off layer density ( n e > 3 ⋅ 10 19 m − 3 ) after the H-L back transition and varying the position of the separatrix in different directions. As a possible physical process, neutral recycling at the plasma facing components is identified. Similar behaviour is also observed in the QCE regime, where the appearance of small ELMs barely impacts the scrape-off layer profiles. There are also indications that the local wall clearance does have an impact on the density profile not only in the scrape-off layer, but also in the confined region.


  • Open Access

    Experimental evidence for the drift wave nature of the weakly coherent mode in ASDEX Upgrade I-mode plasmas

    by M. Herschel, T. Happel, D. Wendler, M. Griener, J. Kalis, R. Fischer, P. Manz, U. Stroth, the ASDEX Upgrade Team

    The improved energy confinement mode (I-mode) is a potential candidate for future fusion power plants, as it combines ELM-free operation with good confinement. The unusual edge transport and turbulence in this regime is still not fully understood. This study analyzes the turbulent structure of the weakly coherent mode (WCM) in ASDEX Upgrade. Measurements from Doppler back-scattering and a thermal helium beam diagnostic are used to determine velocities of the background plasma and the WCM over multiple discharges. A phase velocity of the WCM of the order of 2–5 km s−1 in the electron diamagnetic drift direction is found, quantitatively close to a drift wave assuming negligible temperature fluctuations. A good agreement with a previously proposed mechanism behind the I-mode regime is observed. This marks the first experimental verification of a specific understanding of the WCM and the I-mode regime.


  • Open Access

    Experimental characterization of the quasi-coherent mode in EDA H-Mode and QCE scenarios at ASDEX Upgrade

    by Joey Kalis, Joey Kalis, Gregor Birkenmeier, Gregor Birkenmeier, Peter Manz, Peter Manz, Thomas Eich, Thomas Eich, Michael Griener, Michael Griener, et al.

    The quasi-coherent mode (QCM), appearing in enhanced D α high confinement mode (EDA H-mode) and quasi-continuous exhaust (QCE) plasmas has been analysed in detail at ASDEX Upgrade via thermal helium beam spectroscopy under various discharge parameters. In both scenarios the QCM appears to be localized close to the separatrix and to propagate in ion diamagnetic direction in the plasma frame. The poloidal wavenumber of the QCM is about 0.025 < k θ ρ s < 0.075 and the radial wavenumber is k r ≈ 0   cm − 1 . It was found that the plasmas are generally below the ideal MHD limit at the separatrix. All the properties are consistent with ideal, resistive or kinetic ballooning modes. Simultaneous to the appearance of the QCM, higher harmonic modes can be observed in EDA H-modes, which are exclusively visible in magnetic pick-up coils and have toroidal mode numbers of up to n = 10. By performing a bicoherence analysis it was found that the higher harmonic modes and the QCM are coupling, but are disjoint phenomena. Qualitatively, the bandwidth of the QCM serves as a promising distinctive feature between QCE plasmas and EDA H-modes.


  • Open Access

    Structure of the electron temperature profile around the separatrix

    by Sofía Díaz Esteban, Michael Griener, Elisabeth Wolfrum, Rainer Fischer, Daniel Wendler, Dirk Stieglitz, Christian U Schuster, Davide Silvagni, Wladimir Zholobenko, Karl Lackner, et al.

    The temperature decay length ( λ T e ) in the near scrape-off layer (SOL) reflects the ratio between the transport parallel to the magnetic field lines via Spitzer–Härm electron conduction and the perpendicular mechanisms involving neoclassical and anomalous transport. The implementation of the thermal helium beam diagnostic on ASDEX Upgrade has enabled an excellent spatiotemporal study of the structure of the electron temperature profile ( T e ) around the separatrix and the derivation of the near SOL decay lengths. From the analysis of the T e profile structure of attached H- and L-mode discharges, a self-consistent correspondence between the extrema of the electron temperature curvature profile ( ∂ R 2 T e ) and the position of the separatrix ( R s e p ) is revealed. A 1.5 D model for the power balance from closed to open field lines, including the escaping heat flux from the confined region and the parallel losses to the divertor, as well as results from the plasma edge code GRILLIX, support these experimental results. The evaluation shows that the temperature decay length is not constant over the plasma edge and SOL region, so that the absolute value of λ T e strongly depends on the analyzed region. Independent of the exact location and in agreement with edge Thomson scattering evaluations, the decay lengths show the known inverse relation to the plasma current ( I p ).


  • Open Access

    Two-dimensional reconstruction of filament temperatures and densities with the thermal helium beam at ASDEX Upgrade

    by D. Wendler, G. Birkenmeier, M. Griener, R. Dux, R. Fischer, D. Stieglitz, E. Wolfrum, U. Stroth, Asdex Upgrade Team

    In the scrape-off layer (SOL) of fusion plasmas, radial particle and energy transport is mainly carried by plasma filaments. The plasma parameters of such filaments can be measured by the thermal helium beam diagnostic (THB). By means of an extended collisional radiative model (CRM) used for the evaluation of the diagnostic data, the light intensity response of neutral helium transitions from filaments is studied, which depends on the parameters of the filament and the background. The electron density of the filament is found to be the dominant parameter impacting the line intensities. By applying a numerical reconstruction algorithm based on the CRM, electron temperatures and densities as well as the sizes of experimentally measured filaments are obtained. This method allows for the first time measurements of the temporal decay rates of filament density and temperature in the co-moving frame of the filament and its radial propagation velocity.


  • Open Access

    Compensation of plasma fluctuation induced shadowing effects in gas puff imaging data

    by M. Griener, J. Kalis, D. Wendler, G. Birkenmeier, E. Wolfrum, R.M. McDermott, U. Stroth


  • Open Access

    Characterizing the flow and turbulence structure near the last closed flux surface in L-mode plasmas of ASDEX Upgrade

    by T. Nishizawa, P. Manz, G. Grenfell, M. Griener, D. Wendler, D. Brida, D. M. Kriete, R. Dux, T. Kobayashi, M. Sasaki, et al.

    Since high density operation is advantageous for building an efficient fusion reactor, understanding the density limit in tokamaks has been seen as one of the most important issues. This paper reports a series of measurements around the last-closed flux surface (LCFS) in L-mode plasmas by using a thermal helium beam diagnostic. Fluctuation analysis has been employed to characterize the poloidal flow and the turbulence structure. A reversal of the poloidal flow in the scrape-off layer and concomitant cooling of the outer divertor plasma are observed as the density is raised. While, in the confined region, the change in the density barely affects the poloidal flow, a higher density shifts the fluctuation power spectral densities toward lower frequencies and wave numbers. The eddy tilting of this region is consistent with what is expected from the magnetic shear effect. A radially coherent low frequency mode appears in the case of the highest density investigated in this study (n¯e/ne,GW = 0.51), and higher frequencies near the LCFS are modulated by this mode.