Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Srinivas Gandrothula has a total of 86 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Improved optical characteristics of deep-ridge III-nitride laser diodes using chemical treatment and sidewall passivation

    by Matthew S. Wong, Stephen Gee, Ryan M. Anderson, Hsun-Ming Chang, Emily S. Trageser, Jiaao Zhang, Srinivas Gandrothula, Alanna Fernandes, Josh Brown, Jim Haden, et al.

    The effects of potassium hydroxide (KOH) chemical treatment and dielectric sidewall passivation using atomic layer deposition on deep-ridge III-nitride laser diodes are investigated. Blue edge-emitting laser diodes were fabricated on a 2 inch c -plane freestanding GaN substrate with a ridge width of 8 μm and cavity lengths of 900, 1200, 1500, and 1800 μm. The optical and electrical characteristics under continuous-wave operation are compared between conventional shallow-ridge lasers and the deep-ridge lasers with sidewall treatments. The deep-ridge lasers exhibited lower threshold current density, higher slope efficiency, reduced transparency current density, and improved injection efficiency. These results indicate that the combination of chemical treatment and dielectric passivation effectively suppresses etch-induced nonradiative recombination and enables the intrinsic advantages of deep-ridge laser geometries.

  • Open Access

    Improved efficiency of semipolar micro-LEDs enabled by epitaxial lateral overgrowth

    by Stephen Gee, Srinivas Gandrothula, Xianqing Li, Nathan Palmquist, Matthew Wong, Jiaao Zhang, Tanay Tak, Alejandro Quevedo, Kittamet Chanchaiworawit, Steven P DenBaars, et al.

    Semipolar epitaxial lateral overgrowth (ELO) is a promising technique to reduce crystalline defects and enhance the performance of micro-light-emitting diodes ( μ LEDs). In this work, we demonstrate that semipolar ELO μ LEDs outperform their planar counterparts in multiple key performance metrics, including external quantum efficiency (EQE), light output power, and leakage current. Through a combination of cathodoluminescence imaging, L – I – V characterization, and EQE measurements, we show that the substantial reduction in threading dislocation density in ELO structures directly translates into enhanced optical and electrical performance. These enhancements position ELO μ LEDs as strong candidates for high efficiency microdisplays and visible light communication platforms, with further performance gains expected through sidewall passivation and process refinement.

  • Open Access

    Characterization of long-cavity GaN vertical-cavity surface-emitting lasers with a topside dielectric lens

    by Nathan C. Palmquist, Stephen Gee, Srinivas Gandrothula, Xianqing Li, Hsun Ming Chang, Steven P. Denbaars, Shuji Nakamura

    We present a high-performance GaN-based vertical-cavity surface-emitting laser with a long cavity (70λ), nanoporous GaN distributed Bragg reflector (DBR), and topside dielectric lens, achieving room-temperature continuous-wave operation up to thermal rollover at 34 kA cm−2 and a peak output power of 2.7 mW. Process optimizations significantly improved the lens surface quality, reducing optical losses. The long cavity improved thermal management, leading to a measured thermal impedance of 607 K W−1, the lowest reported for GaN vertical-cavity surface-emitting lasers (VCSELs) with a nanoporous DBR. Spatial mode analysis revealed structured Laguerre–Gaussian-like patterns, with evidence of coherent speckle. These results demonstrate the viability of long-cavity designs for high-power GaN VCSELs.


  • Quantitative analysis of leakage current in III-nitride micro-light-emitting diodes

    by Matthew S. Wong, Tanay Tak, Andrea Y. Ni, Kent Nitta, Srinivas Gandrothula, JaeKwon Kim, NamGoo Cha, Umesh K. Mishra, James S. Speck, Steven P. DenBaars

    The electrical characteristics under forward- and reverse-bias conditions of III-nitride blue and green micro-light-emitting diodes (μLEDs) are analyzed. A fitting model is proposed to determine the contributions of reverse leakage current and the effectiveness of sidewall treatments. Moreover, the forward-bias currents of the μLEDs are examined using the extracted ideality factor to examine the impacts of sidewall defects. The results show that sidewall treatments are highly effective for suppression of leakage currents. From the efficiency perspective, higher wall-plug efficiency (WPE) than external quantum efficiency (EQE) is observed when the operating voltage is lower than the photon voltage in both blue and green 20 × 20 μm2 devices. This enhancement of the WPE over the EQE is due to the suppression of Shockley–Read–Hall (SRH) nonradiative recombination. These observations indicate that μLEDs with sidewall treatments not only improve optical performance but also further enhance the electrical performance of devices by suppressing the leakage current paths due to SRH nonradiative recombination processes.


  • Open Access

    InGaN/GaN edge emitting laser diodes using an epitaxial lateral overgrowth with a low-defect density area of more than 75%

    by Hsun-Ming Chang, Srinivas Gandrothula, Stephen Gee, Tanay Tak, Matthew S. Wong, Nathan Palmquist, Jiaao Zhang, Emily Trageser, Xianqing Li, Alejandro Quevedo, et al.

    We have successfully demonstrated InGaN/GaN edge-emitting laser diodes (EELDs) on a fully coalesced epitaxial lateral overgrown film from a c-plane GaN substrate. We achieve a high aspect ratio, and low defect density wing region covering 75%–88% of the substrates’ surface, which is amongst the largest reported areas in the literature. The devices at the wing region exhibit a threshold current density of 3.63 kA cm−2 at 408 nm, and an improved laser performance compared to the high defect density region is confirmed. Based on this work, it is promising that high performance, cost-efficient c-plane InGaN/GaN EELDs can be realized.


  • Open Access

    Advances in InGaN-based RGB micro-light-emitting diodes for AR applications: Status and perspective

    by Panpan Li, Jacob Ewing, Matthew S. Wong, Yifan Yao, Hongjian Li, Srinivas Gandrothula, Jordan M. Smith, Mike Iza, Shuji Nakamura, Steven P. DenBaars

    Micro-light-emitting diodes (µLEDs) are gathering significant interest as a technology for emerging micro-displays. However, µLEDs encounter numerous obstacles, including size-dependent efficiency loss, poor efficiency of red µLEDs, and challenges associated with the mass transfer and integration of full-color µLEDs. These issues become more acute in ultra-small µLEDs (<5 µm), which were required by the augmented reality (AR) displays. Here, we discuss the principal challenges faced by µLEDs and explore the possible solutions. We highlight recent advances in InGaN-based RGB µLEDs tailored for AR displays. In particular, we discuss the advancements in ultra-small InGaN µLEDs scaled down to 1 µm, the developments in InGaN red µLEDs, and the implementation of tunnel junction-based cascaded InGaN µLEDs for monolithic integration.


  • Dislocation half-loop control for optimal V-defect density in GaN-based light emitting diodes

    by Alejandro Quevedo, Feng Wu, Tsung-Yin Tsai, Jacob J. Ewing, Tanay Tak, Srinivas Gandrothula, Stephen Gee, Xianqing Li, Shuji Nakamura, Steven P. DenBaars, et al.

    V-defects are morphological defects that typically form on threading dislocations during epitaxial growth of (0001)-oriented GaN layers. A V-defect is a hexagonal pyramid-shaped depression with six {101¯1}-oriented sidewalls. These semipolar sidewalls have a lower polarization barrier than the polarization barriers present between the polar c-plane quantum wells and quantum barriers and can laterally inject carriers directly into quantum wells in GaN-based light emitting diodes (LEDs). This is especially important, as the high polarization field in c-plane GaN is a significant factor in the high forward voltage of GaN LEDs. The optimal V-defect density for efficient lateral carrier injection in a GaN LED (∼109 cm−2) is typically an order of magnitude higher than the threading dislocation density of GaN grown on patterned sapphire substrates (∼108 cm−2). Pure-edge dislocation loops have been known to exist in GaN, and their formation into large V-defects via low-temperature growth with high Si-doping has recently been studied. Here, we develop a method for pure-edge threading dislocation half-loop formation and density control via disilane flow, growth temperature, and thickness of the half-loop generation layer. We also develop a method of forming the threading dislocation half-loops into V-defects of comparable size to those originating from substrate threading dislocations.


  • Open Access

    Erratum: “Planarization of p-GaN surfaces on MOCVD grown V-defect engineered GaN-based LEDs” [Appl. Phys. Lett. 124, 172102 (2024)]

    by Tanay Tak, Alejandro Quevedo, Feng Wu, Srinivas Gandrothula, Jacob J. Ewing, Stephen Gee, Shuji Nakamura, Steven P. DenBaars, James S. Speck

    The original article's Fig. 5(e)1 did not display the dashed lines as intended, and there were a few typographical errors in the caption of Fig. 5. The original article's Fig. 5(e)1 did not display the dashed lines as intended, and there were a few typographical errors in the caption of Fig. 5.

  • Planarization of p-GaN surfaces on MOCVD grown V-defect engineered GaN-based LEDs

    by Tanay Tak, Alejandro Quevedo, Feng Wu, Srinivas Gandrothula, Jacob J. Ewing, Stephen Gee, Shuji Nakamura, Steven P. DenBaars, James S. Speck

    The large polarization barriers between the quantum wells and quantum barriers in long-wavelength GaN-based light-emitting diodes (LEDs) inhibit their performance by requiring excess driving voltages to reach standard operating current densities. Lateral injection of carriers directly into quantum wells is required to circumvent this issue. V-defects are naturally occurring inverted hexagonal defects with semipolar 101¯1-plane sidewalls generated on surface depressions from threading dislocations. LEDs engineered to intentionally generate V-defects below the active region of the LED can achieve lateral carrier injection through the V-defect sidewalls and have already been able to demonstrate world record wall-plug efficiencies for LEDs in the green-red wavelengths. V-defects can be enlarged during kinetically limited growth where the growth rate of the c-plane GaN is faster than that of their sidewalls, leaving them unfilled. We report on the metal organic chemical vapor deposition growth conditions required to fill in V-defects with p-GaN during epitaxial growth of the LED post the active region. Circular transmission length measurements of Pd/Au contacts processed on p-GaN surfaces with various amounts of unfilled V-defects showed no significant difference in their sheet resistance and specific contact resistance. J–V measurements of LEDs grown with varying unfilled V-defect densities showed no significant difference in the forward bias regime. However, in the reverse bias regime, catastrophic breakdown occurred at markedly lower voltages for samples with larger unfilled V-defect densities. This suggests that unfilled V-defects may act as hotspots for device failure, and planarizing LED surfaces may help prevent early degradation of LED devices.


  • Optical analysis of III-nitride micro-light-emitting diodes with different sidewall treatments at low current density operation

    by Matthew S. Wong, Stephen Gee, Tanay Tak, Srinivas Gandrothula, Steve Rebollo, NamGoo Cha, James S. Speck, Steven P. DenBaars

    In this work, the optical efficiency of III-nitride blue micro-LEDs (μLEDs) ranged from 5 × 5 to 60 × 60 μm2 with different sidewall treatments at low current density range was investigated. The results showed dielectric sidewall passivation using atomic layer deposition (ALD) has superior optical enhancement compared to conventional RF sputtering, where most of the enhancement occurred at low current density range. Additionally, the use of ALD sidewall passivation and chemical treatment offered significant efficiency improvement for different sizes of μLEDs at operating less than 1 A cm−2 and the devices without sidewall treatments did not emit light. The effect of sidewall treatments to the effective Shockley–Read–Hall (SRH) nonradiative recombination coefficient, or the effective A coefficient from the ABC model, was estimated. The effective SRH nonradiative recombination coefficient was suppressed by two orders of magnitude for devices with sidewall treatments compared to devices without sidewall passivation.