Cristian Franzoi Mazzola
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Cristian Franzoi Mazzola has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Jônatas Policarpo Américo
Department of Electrical Engineering, Federal University of TechnologyParan, Pato Branco, Brazil
3 shared publications - Jean Vianei Leite
Department of Electrical and Electronic Engineering, Federal University of Santa Catarina, Florianpolis, Brazil
2 shared publications - Carlos A. C. Wengerkievicz
Federal University of Santa Catarina, Brazil
1 shared publication - Cesar Jose Deschamps
POLO Research Laboratories, Federal University of Santa Catarina, Florianópolis 88040-900, Brazil
1 shared publication - Ernane Silva
POLO Research Laboratories for Emerging Technologies in Cooling and Thermophysics, Federal University of Santa Catarina, CEP, Florianópolis, Brazil
1 shared publication Jean V. Leite
1 shared publication
Latest Publications
- Open Access
- 30 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 2001-2014
A New Model for Inrush Current in Three-Phase Transformers
This study proposes a time-domain analytical–numerical method for accurately evaluating the inrush current in three-phase, three-limb core-type transformers, incorporating the nonlinear magnetic behavior and loss mechanisms of the iron core. The formulation is based on a system of differential equations that describes the dynamic coupling between winding currents and core fluxes. Nonlinear magnetization is modeled through the differential permeability in each core section, defined as the instantaneous slope of the B–H curve, characterizing the flux-density response to incremental magnetic-field variations. The scalar Jiles–Atherton hysteresis model is employed together with eddy-current and excess-loss components to represent the magnetic behavior with physical consistency. The method requires knowledge of the winding turns, which can be readily obtained from auxiliary-coil test, ensuring practical applicability to transformers in service. This modeling approach enables the simulation of transient inrush currents. The simulation results were compared with experimental measurements, showing that the peak inrush current differed by only 1.27% from the highest current amplitude observed in phase C, thus validating the effectiveness of the proposed model for inrush current analysis.
- 30 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 2001-2014
Open AccessA New Model for Inrush Current in Three-Phase Transformers
This study proposes a time-domain analytical–numerical method for accurately evaluating the inrush current in three-phase, three-limb core-type transformers, incorporating the nonlinear magnetic behavior and loss mechanisms of the iron core. The formulation is based on a system of differential equations that describes the dynamic coupling between winding currents and core fluxes. Nonlinear magnetization is modeled through the differential permeability in each core section, defined as the instantaneous slope of the B–H curve, characterizing the flux-density response to incremental magnetic-field variations. The scalar Jiles–Atherton hysteresis model is employed together with eddy-current and excess-loss components to represent the magnetic behavior with physical consistency. The method requires knowledge of the winding turns, which can be readily obtained from auxiliary-coil test, ensuring practical applicability to transformers in service. This modeling approach enables the simulation of transient inrush currents. The simulation results were compared with experimental measurements, showing that the peak inrush current differed by only 1.27% from the highest current amplitude observed in phase C, thus validating the effectiveness of the proposed model for inrush current analysis.
- Open Access
- 27 April 2024
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 58
Enhanced thermal modeling of three-phase dry-type transformers
- 27 April 2024
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 58
Open AccessEnhanced thermal modeling of three-phase dry-type transformers
- Open Access
- 1 March 2023
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 22 (1) , 101-120
A Non-Invasive Methodology for Magnetic Characterization of Transformers and Reactors
- 1 March 2023
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 22 (1) , 101-120
Open AccessA Non-Invasive Methodology for Magnetic Characterization of Transformers and Reactors
- Open Access
- 1 September 2021
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 20 (3) , 658-674
Efficiency Determination of Compressor Embedded Induction Motors
- 1 September 2021
- Published by FapUNIFESP (SciELO) in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
- Vol. 20 (3) , 658-674
Open AccessEfficiency Determination of Compressor Embedded Induction Motors