Alexander H. Ip
Alexander H. Ip has a total of 58 co-authors. Here are the top co-authors by number of shared publications:
- David Sinton
Department of Mechanical and Industrial Engineering, University of Toronto, Toronto, Ontario, M5S 3G8, Canada
2 shared publications - Edward Hartley Sargent
Department of electrical and computer engineering, University of Toronto, Toronto, Ontario, M5S 3G4, Canada
2 shared publications - Ning Wang
Department of Electrical and Computer Engineering, University of Toronto, 10 King’s College Road, Toronto, Ontario M5S 3G4, Canada
2 shared publications - Sung-Fu Hung
Department of Applied Chemistry and Center for Emergent Functional Matter Science, National Yang Ming Chiao Tung University, Hsinchu, Taiwan
2 shared publications - Adnan Ozden
Department of Mechanical and Nuclear Engineering Khalifa University Abu Dhabi UAE
1 shared publication - Ali Shayesteh
Department of General Surgery, Zucker School of Medicine at Hofstra/Northwell at Lenox Hill Hospital Program, New York, NY, 10021, USA.
1 shared publication
Latest Publications
- 22 December 2023
- Published by The Electrochemical Society in ECS Meeting Abstracts
- Vol. MA2023-02 (47) , 2401
Early Failure Detection for CO2 Reduction Electrolyzers Via in-Line Electrochemical Impedance Spectroscopy
The electrochemical CO2 reduction reaction (CO2RR) presents the opportunity to produce chemical feedstocks and fuels directly from CO2. Recent achievements in energy efficiency and current density are approaching the targets required for commercial viability; however, stability remains more than two orders of magnitude below the required 80,000 h. In CO2RR there is a challenge to distinguish the cause of failure among many possibilities. Failure can result from initial setup (e.g. over or under compression of the membrane and electrodes), gradual degradation of components (e.g. cathode and anode catalyst restructuring and dissolution), accumulation of products or byproducts (e.g. alcohols or salt accumulation), or immediate failures (e.g. a hole in the membrane or a short circuit). These failure modes must be addressed to reach the targeted stability needed for the wide-scale adoption of this technology. Early identification and mitigation of these failures would increase the electrolyzer lifetime and the commercial viability of CO2RR electrolyzers. Current techniques to characterize failures of the electrolyzer rely on post-mortem analysis of cell components. The analysis of individual components after operation may not accurately reflect their state in operando. There are techniques that are capable of analyzing the cell in operation (e.g. XAS, Raman, and TEM), but these typically require modified cell architectures and are operated at lower reaction rates. To effectively diagnose failure, the analysis technique should be applied to electrolyzers operating under realistic conditions. Here we implement an in-line real-time electrochemical impedance spectroscopy (EIS) technique to monitor CO2RR electrolyzers during operation. EIS is a non-destructive technique that can provide continuous information on the performance of specific components within the electrolyzer. We characterize common failure modes, such as poor compression, salt formation, catalyst degradation, and short circuits, and their identifying changes to the EIS response. We extract key electrochemical parameters from the EIS response and use them to develop a framework to identify and prevent the most common failure modes. Among other applications, this framework allowed for the detection of anode catalyst degradation 11 h before other indicators, such as cell voltage or product selectivity. This technique and framework can be applied to monitor CO2 electrolyzers as they are scaled and stacked.
- 22 December 2023
- Published by The Electrochemical Society in ECS Meeting Abstracts
- Vol. MA2023-02 (47) , 2401
Early Failure Detection for CO2 Reduction Electrolyzers Via in-Line Electrochemical Impedance Spectroscopy
The electrochemical CO2 reduction reaction (CO2RR) presents the opportunity to produce chemical feedstocks and fuels directly from CO2. Recent achievements in energy efficiency and current density are approaching the targets required for commercial viability; however, stability remains more than two orders of magnitude below the required 80,000 h. In CO2RR there is a challenge to distinguish the cause of failure among many possibilities. Failure can result from initial setup (e.g. over or under compression of the membrane and electrodes), gradual degradation of components (e.g. cathode and anode catalyst restructuring and dissolution), accumulation of products or byproducts (e.g. alcohols or salt accumulation), or immediate failures (e.g. a hole in the membrane or a short circuit). These failure modes must be addressed to reach the targeted stability needed for the wide-scale adoption of this technology. Early identification and mitigation of these failures would increase the electrolyzer lifetime and the commercial viability of CO2RR electrolyzers. Current techniques to characterize failures of the electrolyzer rely on post-mortem analysis of cell components. The analysis of individual components after operation may not accurately reflect their state in operando. There are techniques that are capable of analyzing the cell in operation (e.g. XAS, Raman, and TEM), but these typically require modified cell architectures and are operated at lower reaction rates. To effectively diagnose failure, the analysis technique should be applied to electrolyzers operating under realistic conditions. Here we implement an in-line real-time electrochemical impedance spectroscopy (EIS) technique to monitor CO2RR electrolyzers during operation. EIS is a non-destructive technique that can provide continuous information on the performance of specific components within the electrolyzer. We characterize common failure modes, such as poor compression, salt formation, catalyst degradation, and short circuits, and their identifying changes to the EIS response. We extract key electrochemical parameters from the EIS response and use them to develop a framework to identify and prevent the most common failure modes. Among other applications, this framework allowed for the detection of anode catalyst degradation 11 h before other indicators, such as cell voltage or product selectivity. This technique and framework can be applied to monitor CO2 electrolyzers as they are scaled and stacked.
- 16 October 2023
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 8 (11) , 4694-4701
Electrified Cement Production via Anion-Mediated Electrochemical Calcium Extraction
- 16 October 2023
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 8 (11) , 4694-4701
Electrified Cement Production via Anion-Mediated Electrochemical Calcium Extraction
- 7 October 2021
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 143 (41) , 17226-17235
Ternary Alloys Enable Efficient Production of Methoxylated Chemicals via Selective Electrocatalytic Hydrogenation of Lignin Monomers
We explore the selective electrocatalytic hydrogenation of lignin monomers to methoxylated chemicals, of particular interest, when powered by renewable electricity. Prior studies, while advancing the field rapidly, have so far lacked the needed selectivity: when hydrogenating lignin-derived methoxylated monomers to methoxylated cyclohexanes, the desired methoxy group (−OCH3) has also been reduced. The ternary PtRhAu electrocatalysts developed herein selectively hydrogenate lignin monomers to methoxylated cyclohexanes—molecules with uses in pharmaceutics. Using X-ray absorption spectroscopy and in situ Raman spectroscopy, we find that Rh and Au modulate the electronic structure of Pt and that this modulating steers intermediate energetics on the electrocatalyst surface to facilitate the hydrogenation of lignin monomers and suppress C–OCH3 bond cleavage. As a result, PtRhAu electrocatalysts achieve a record 58% faradaic efficiency (FE) toward 2-methoxycyclohexanol from the lignin monomer guaiacol at 200 mA cm–2, representing a 1.9× advance in FE and a 4× increase in partial current density compared to the highest productivity prior reports. We demonstrate an integrated lignin biorefinery where wood-derived lignin monomers are selectively hydrogenated and funneled to methoxylated 2-methoxy-4-propylcyclohexanol using PtRhAu electrocatalysts. This work offers an opportunity for the sustainable electrocatalytic synthesis of methoxylated pharmaceuticals from renewable biomass.
- 7 October 2021
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 143 (41) , 17226-17235
Ternary Alloys Enable Efficient Production of Methoxylated Chemicals via Selective Electrocatalytic Hydrogenation of Lignin Monomers
We explore the selective electrocatalytic hydrogenation of lignin monomers to methoxylated chemicals, of particular interest, when powered by renewable electricity. Prior studies, while advancing the field rapidly, have so far lacked the needed selectivity: when hydrogenating lignin-derived methoxylated monomers to methoxylated cyclohexanes, the desired methoxy group (−OCH3) has also been reduced. The ternary PtRhAu electrocatalysts developed herein selectively hydrogenate lignin monomers to methoxylated cyclohexanes—molecules with uses in pharmaceutics. Using X-ray absorption spectroscopy and in situ Raman spectroscopy, we find that Rh and Au modulate the electronic structure of Pt and that this modulating steers intermediate energetics on the electrocatalyst surface to facilitate the hydrogenation of lignin monomers and suppress C–OCH3 bond cleavage. As a result, PtRhAu electrocatalysts achieve a record 58% faradaic efficiency (FE) toward 2-methoxycyclohexanol from the lignin monomer guaiacol at 200 mA cm–2, representing a 1.9× advance in FE and a 4× increase in partial current density compared to the highest productivity prior reports. We demonstrate an integrated lignin biorefinery where wood-derived lignin monomers are selectively hydrogenated and funneled to methoxylated 2-methoxy-4-propylcyclohexanol using PtRhAu electrocatalysts. This work offers an opportunity for the sustainable electrocatalytic synthesis of methoxylated pharmaceuticals from renewable biomass.
- Open Access
- 29 May 2015
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 119 (24) , 13965-13971
Perovskite Quantum Dots Modeled Using ab Initio and Replica Exchange Molecular Dynamics
- 29 May 2015
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 119 (24) , 13965-13971
Open AccessPerovskite Quantum Dots Modeled Using ab Initio and Replica Exchange Molecular Dynamics