Kaiyuan Zheng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kaiyuan Zheng has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Long Jing
National Active Distribution Network Technology Research Center, Beijing Jiaotong University, Beijing, China
2 shared publications - Weige Zhang
National Active Distribution Network Technology Research Center (NANTEC), Beijing Jiaotong University, Beijing 100044, China
2 shared publications - Xuezhi Wu
Beijing Jiaotong University
2 shared publications Haichuan Zhao
School of Electrical Engineering, Beijing Jiaotong University, Beijing, China
1 shared publication
Latest Publications
- 12 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 71 (5) , 4742-4752
Partial-Power Conversion for Increased Energy Storage Capability of Li-Ion Battery Energy Storage System
Full-power converters are used in battery energy storage systems (BESS) because of their simple structure, high efficiency and relatively low cost. However, cell-to-cell variation, including capacity, state of charge (SOC), and internal resistance, will decrease the available capacity of serially connected battery packs, thereby negatively affecting the energy utilization rate (EUTR) of BESS. This article proposes a novel BESS scheme that combines a modular converter with partial power conversion architecture to make a modular partial power converter (MPPC) that addresses the issue. The MPPC consists of input-serial and output-paralleled (ISOP) isolated phase-shift full-bridge (PSFB) sub-modules. It processes only the serial compensation power, about 1/3 of the full power. Consequently, the MPPC shrinks the converter capacity, which can reduce the cost and power loss. Furthermore, this article develops a BESS model considering cell-to-cell variations to analyze the energy storage capability of the MPPC-BESS compared with the existing full-power BESS. To test the model, we run a simulation using parameter values from 100 real retired batteries. Our simulation results show that the MPPC can significantly alleviate the reduction of EUTR as the voltage level increase. Finally, we construct a 36V/720W MPPC-BESS prototype with two battery packs and PSFB sub-modules to verify the bidirectional operating stability and energy storage capability.
- 12 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 71 (5) , 4742-4752
Partial-Power Conversion for Increased Energy Storage Capability of Li-Ion Battery Energy Storage System
Full-power converters are used in battery energy storage systems (BESS) because of their simple structure, high efficiency and relatively low cost. However, cell-to-cell variation, including capacity, state of charge (SOC), and internal resistance, will decrease the available capacity of serially connected battery packs, thereby negatively affecting the energy utilization rate (EUTR) of BESS. This article proposes a novel BESS scheme that combines a modular converter with partial power conversion architecture to make a modular partial power converter (MPPC) that addresses the issue. The MPPC consists of input-serial and output-paralleled (ISOP) isolated phase-shift full-bridge (PSFB) sub-modules. It processes only the serial compensation power, about 1/3 of the full power. Consequently, the MPPC shrinks the converter capacity, which can reduce the cost and power loss. Furthermore, this article develops a BESS model considering cell-to-cell variations to analyze the energy storage capability of the MPPC-BESS compared with the existing full-power BESS. To test the model, we run a simulation using parameter values from 100 real retired batteries. Our simulation results show that the MPPC can significantly alleviate the reduction of EUTR as the voltage level increase. Finally, we construct a 36V/720W MPPC-BESS prototype with two battery packs and PSFB sub-modules to verify the bidirectional operating stability and energy storage capability.
- Open Access
- 27 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 133376-133386
Optimal Control Method and Design for Modular Battery Energy Storage System Based on Partial Power Conversion
This article addresses a bidirectional low power loss series-parallel partial-power modular converter (SPPC) suitable for series-connected high voltage large power battery energy storage system (BESS). A specific capacitor is placed on the top of the series battery packs, which voltage can be adjusted by the SPPC to compensate for the voltage fluctuation of the battery packs and the DC power line. The power loss and cost of the SPPC are relatively low since its rated power is reduced to about 22%–48% of the full-power converter. A 3 level distributed control method is proposed to achieve the fast transient response of the DC power line current and deal with the series inconsistency of battery packs during discharging and charging, further improving the total energy utilization efficiency (EUE) of the BESS. The critical design considerations for SPPC-BESS are analyzed. A bidirectional 800W phase-shift full-bridge (PSFB) converter hardware prototype along with the Gallium Nitride (GaN) devices is provided to verify the high efficiency of DC-DC sub-module. Then a simulation model of a 6.6kW SPPC-BESS with 3 sub-modules to verify the feasibility of the control method. Theoretical analysis proves that the total power loss of the SPPC is lower than the existing types of modular converters. The EUE of the SPPC-BESS is 1.7% higher than the conventional BESS when the average maximum available capacities of batteries attenuate to 80% of the initial maximum available capacity.
- 27 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 133376-133386
Open AccessOptimal Control Method and Design for Modular Battery Energy Storage System Based on Partial Power Conversion
This article addresses a bidirectional low power loss series-parallel partial-power modular converter (SPPC) suitable for series-connected high voltage large power battery energy storage system (BESS). A specific capacitor is placed on the top of the series battery packs, which voltage can be adjusted by the SPPC to compensate for the voltage fluctuation of the battery packs and the DC power line. The power loss and cost of the SPPC are relatively low since its rated power is reduced to about 22%–48% of the full-power converter. A 3 level distributed control method is proposed to achieve the fast transient response of the DC power line current and deal with the series inconsistency of battery packs during discharging and charging, further improving the total energy utilization efficiency (EUE) of the BESS. The critical design considerations for SPPC-BESS are analyzed. A bidirectional 800W phase-shift full-bridge (PSFB) converter hardware prototype along with the Gallium Nitride (GaN) devices is provided to verify the high efficiency of DC-DC sub-module. Then a simulation model of a 6.6kW SPPC-BESS with 3 sub-modules to verify the feasibility of the control method. Theoretical analysis proves that the total power loss of the SPPC is lower than the existing types of modular converters. The EUE of the SPPC-BESS is 1.7% higher than the conventional BESS when the average maximum available capacities of batteries attenuate to 80% of the initial maximum available capacity.