ALAndrei Lyamzin

Andrei Lyamzin

*This is an algorithmically generated author record based on publicly available information.

Andrei Lyamzin has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    УДОСКОНАЛЕННЯ НАУКОВОГО ПІДХОДУ ДО ПРОГНОЗУВАННЯ ТА ПОБУДОВИ МОДЕЛЕЙ ТРАНСПОРТНИХ ПОТОКІВ

    by Сергій Турпак, Андрій Лямзін, Олена Острогляд, Лариса Васильєва, Олена Олениця

    При дослідженні транспортних потоків спостерігаються коливання вантажопотоків, які найчастіше зумовлені сезонністю перевезень. При аналізі таких коливань для наочності застосовують графіки та діаграми, що характеризують зміни обсягів перевезень протягом певного періоду. Таким змінам притаманна календарна циклічність. Сезонні варіації змін обсягів перевезень характеризуються відносно стабільною формою, яка має річну циклічність. Такі зміни можуть бути наслідками впливу природних умов або повторенням календарно залежних подій в різних країнах. Але на коливання інтенсивності вантажопотоків впливають не тільки сезонність, а й різні зовнішні чинники як то квотування, падіння попиту, торговельні й політичні конфлікти тощо. В роботі розглядаються методи дослідження сезонних коливань інтенсивності вантажопотоків на прикладі відвантаження експортного металопрокату. Державні структури, які постійно аналізують сезонні коливання, використовують програмні продукти ЄС з урахуванням різних коригуючих коефіцієнтів. Для більш точних показників коливання вантажопотоків виконують аналіз середньодобових показників, але вони не завжди дозволяють масштабно сприйняти матеріал досліджень. Запропоновано для дослідження інтенсивності коливань вантажопотоків використовувати коефіцієнт, який враховує фактичні дані з виконаних перевезень, кількість календарних днів і за рік і за місяць. Для обробки даних застосовано метод календарного дефлятування, який дозволяє наочно побачити коливання середньодобових обсягів відвантаження експортної металопродукції протягом року. Для досліджень транспортних потоків пропонується двоетапна модель календарної дефляції та поліноміальної апроксимації, яку можна використовувати для планування оперативної роботи, визначення потрібної кількості вагонів для організації перевезень та коригування планів регламентних робіт із рухомим складом. При математичному дефлятуванні часових рядів можливо трансформувати аналітичні дані у предиктивну модель логістики, що дозволить підвищити точність планування на 9% та запобігти дефіциту потужностей у пікові періоди. Запропонована на основі полінома 5-го ступеня модель не статична, а є базовим профілем, який легко адаптувати до прогнозних річних обсягів через коефіцієнти масштабування. У виробничій діяльності це дозволить диспетчерським службам оперативно розраховувати добову потребу в рухомому складі, зберігаючи виявлену структуру сезонного попиту.

  • Open Access

    Mathematical Model of Decision Making during Search and Rescue Operations at Sea

    by Andrii Liamzin, Serhii Hodovaniuk, Iryna Borets, Viktoriia Klymenko

    The article considers the issue of increasing the efficiency of search and rescue operations management at sea by applying the provisions of the queuing theory. A mathematical model of decision support in the system of coordination of rescue units is proposed, which takes into account the stochastic nature of the receipt of applications and the limited bandwidth of service channels. Examples of calculations of the system functioning efficiency indicators are given, which confirm the feasibility of using intelligent decision support technologies (IQ technologies) to increase the efficiency of the response of search and rescue services. The practical significance of the use of mathematical modeling for reducing the time of information processing, making management decisions and transmitting commands to executors in difficult sea conditions is substantiated.

  • Open Access

    SYNERGY OF TRANSPORT SPACE AS A SOURCE DEVELOPMENT OF THE SECURE WAREHOUSE MANAGEMENT SYSTEM OF INDUSTRIAL ZONES

    by A. Liamzin, Ye. Ukrainskyi, A. Maslak, M. Mnatsakanian

    The synergistic features of the transport space are considered as sources, the resources of which are directed to the development of the system for ensuring the safety of the components of the chain: «the emergence of the need for products - the provision of transport services - production - the qualitative and quantitative level of mastering by consumers of cargo flows in the conditions of the existing limitations of the geographical space of industrial zones». The basic components of the chain are: the supplier, the manufacturer and the transport company. The state of the system was considered according to the Kurno equilibrium criterion. The synergistic effect of the system in the conditions of the existing spectrum of restrictions characteristic of the environment of the industrial zone, which arises during the integration of its components into a single security architecture, is determined.

  • Open Access

    Optimizing unbalanced freight deliveries in transportation networks

    by Georgii Prokudin, Alexey Chupaylenko, Tetiana Khobotnia, Inna Remekh, Andrei Lyamzin, Marina Kovalenko

    This paper reports a comparative analysis of the known methods for reducing open transportation problems to a balanced form in order to further optimize freight traffic based on them. A series of significant shortcomings have been revealed that largely narrow the scope of their application. A new method has been proposed, termed the method of proportional redistribution of cargo transportation volumes among participants in the transportation process, devoid of the identified shortcomings. The transportation problem is a special case of the general linear programming problem, to which one of the methods for solving it, namely the simplex one, can be applied. A procedure to construct a simplex table based on the data from the transport table has been described, as well as the algorithm of subsequent simplex transformations. A transportation problem is often stated in the form of a map of the location of transport hubs of cargo dispatch and destination. A matrix-network model has been proposed, which makes it possible to reduce the network representation to a matrix form with the subsequent finding of the optimal plan for cargo transportation. In order to identify the priority of methods for reducing open transportation problems to a balanced form, 100 transportation problems that are unbalanced in terms of the volume of cargo transportation were solved. That was done with the help of a designed decision support system for the management of freight transport. As a criterion, the best freight transportation plan was chosen. As a result, the simplex method proved the best in 48 cases, the coefficient method ‒ in 27, the dummy node method ‒ in 16, and the difference method ‒ in 9 cases. The use of a decision support system for the management of freight transport has increased its efficiency by an average of 25 %


  • Open Access

    SIMPLIFIED APPROACH OF DETERMINATION OF THE MEASURE TO INCREASE THE EFFICIENCY OF RAILWAY TRANSPORT OF THE METALLURGICAL PLANT

    by Elena Kiritseva, Olha Kletska, Andrey Lyamzin, Anatoliy Falendysh

    The article proposes the approach for determining the measure to increase the efficiency of railway transport of the metallurgical plant. The analysis of scientific and normative works on the efficiency of railway transport at industrial enterprises showed that this issue is not fully covered and requires more detailed study. The work of the railway shop of the metallurgical enterprise is considered, namely, the turnover off right cars of different owners and the time of their stay on the factory tracks are determined. An analysis of statistical data was made, which showed that the time difference between the standard set at the enterprise and the actual time of stay of the freight car at the planthas a large discrepancy. This requires spending additional funds for the use of cars of different owners. For this purpose, a model for determining measures to minimize costs at the metallurgical enterprise was developed. The algorithm for its solution involves five stages of calculations. It is based on the model of managements science, which is presented as the approach of linear programming to determine the optimal means of allocating scarce resources in the presence of competing needs. Calculations were made, thanks to which the first stage of development of the model for determining the measure to improve the performance of railway transport was performed and the indicators that characterize it were determined. The total time of rolling stock at the enterprise is determined. Based on this, it is established that it is necessary to separate from the total time the time spent at each station according to the operations performed with the cars. Costs are determined operationally due to the received analysis of the stay and turnover of the freight car at the metallurgical enterprise. Installed stations, which are the most time-consuming freight cars, is there is an excess of payment for the down time of cars at these stations. Based on this, it was decided that it is necessary to study in more detail the operations performed with cars at theses stations and to identify "weaknesses" in the turnover of the freight car at the metallurgical enterprise.