Haneol Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Haneol Kim has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Jongkyu Kim
Renewable Heat Integration Laboratory, New and Renewable Energy Institute, Korea Institute of Energy Research, Daejeon 34129, Korea
2 shared publications - Hak Joo Kim
Korea Institute of Energy Research
1 shared publication - Sangnam Lee
Renewable Heat Integration Laboratory, New and Renewable Energy Institute, Korea Institute of Energy Research, Daejeon 34129, Korea
1 shared publication - Sungeun Kim
Carbon Conversion Research Laboratory, Climate Change Research Division, Korea Institute of Energy Research, Daejeon 34129, Korea
1 shared publication
Latest Publications
- Open Access
- 3 November 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (21) , 10333
Hydrogen Production in Methane Decomposition Reactor Using Solar Thermal Energy
This study investigates the decomposition of methane using solar thermal energy as a heat source. Instead of the direct thermal decomposition of the methane at a temperature of 1200 °C or higher, a catalyst coated with carbon black on a metal foam was used to lower the temperature and activation energy required for the reaction, and to increase the yield. To supply solar heat during the reaction, a reactor suitable for a solar concentrating system was developed. In this process, a direct heating type reactor with quartz was initially applied, and a number of problems were identified. An indirect heating type reactor with an insulated cavity and a rotating part was subsequently developed, followed by a thermal barrier coating application. Methane decomposition experiments were conducted in a 40 kW solar furnace at the Korea Institute of Energy Research. Conversion rates of 96.7% and 82.6% were achieved when the methane flow rate was 20 L/min and 40 L/min, respectively.
- 3 November 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (21) , 10333
Open AccessHydrogen Production in Methane Decomposition Reactor Using Solar Thermal Energy
This study investigates the decomposition of methane using solar thermal energy as a heat source. Instead of the direct thermal decomposition of the methane at a temperature of 1200 °C or higher, a catalyst coated with carbon black on a metal foam was used to lower the temperature and activation energy required for the reaction, and to increase the yield. To supply solar heat during the reaction, a reactor suitable for a solar concentrating system was developed. In this process, a direct heating type reactor with quartz was initially applied, and a number of problems were identified. An indirect heating type reactor with an insulated cavity and a rotating part was subsequently developed, followed by a thermal barrier coating application. Methane decomposition experiments were conducted in a 40 kW solar furnace at the Korea Institute of Energy Research. Conversion rates of 96.7% and 82.6% were achieved when the methane flow rate was 20 L/min and 40 L/min, respectively.
- Open Access
Numerical Study on Optics and Heat Transfer of Solar Reactor for Methane Thermal Decomposition
This study aims to reduce greenhouse gas emissions to the atmosphere and effectively utilize wasted resources by converting methane, the main component of biogas, into hydrogen. Therefore, a reactor was developed to decompose methane into carbon and hydrogen using solar thermal sources instead of traditional energy sources, such as coal and petroleum. The optical distributions were analyzed using TracePro, a Monte Carlo ray-tracing-based program. In addition, Fluent, a computational fluid dynamics program, was used for the heat and mass transfer, and chemical reaction. The cylindrical indirect heating reactor rotates at a constant speed to prevent damage by the heat source concentrated at the solar furnace. The inside of the reactor was filled with a porous catalyst for methane decomposition, and the outside was surrounded by insulation to reduce heat loss. The performance of the reactor, according to the cavity model, was calculated when solar heat was concentrated on the reactor surface and methane was supplied into the reactor in an environment with a solar irradiance of 700 W/m2, wind speed of 1 m/s, and outdoor temperature of 25 °C. As a result, temperature, methane mass fraction distribution, and heat loss amounts for the two cavities were obtained, and it was found that the effect on the conversion rate was largely dependent on a temperature over 1000 °C in the reactor. Moreover, the heat loss of the full-cavity model decreased by 12.5% and the methane conversion rate increased by 33.5%, compared to the semi-cavity model. In conclusion, the high-temperature environment of the reactor has a significant effect on the increase in conversion rate, with an additional effect of reducing heat loss.
Open AccessNumerical Study on Optics and Heat Transfer of Solar Reactor for Methane Thermal Decomposition
This study aims to reduce greenhouse gas emissions to the atmosphere and effectively utilize wasted resources by converting methane, the main component of biogas, into hydrogen. Therefore, a reactor was developed to decompose methane into carbon and hydrogen using solar thermal sources instead of traditional energy sources, such as coal and petroleum. The optical distributions were analyzed using TracePro, a Monte Carlo ray-tracing-based program. In addition, Fluent, a computational fluid dynamics program, was used for the heat and mass transfer, and chemical reaction. The cylindrical indirect heating reactor rotates at a constant speed to prevent damage by the heat source concentrated at the solar furnace. The inside of the reactor was filled with a porous catalyst for methane decomposition, and the outside was surrounded by insulation to reduce heat loss. The performance of the reactor, according to the cavity model, was calculated when solar heat was concentrated on the reactor surface and methane was supplied into the reactor in an environment with a solar irradiance of 700 W/m2, wind speed of 1 m/s, and outdoor temperature of 25 °C. As a result, temperature, methane mass fraction distribution, and heat loss amounts for the two cavities were obtained, and it was found that the effect on the conversion rate was largely dependent on a temperature over 1000 °C in the reactor. Moreover, the heat loss of the full-cavity model decreased by 12.5% and the methane conversion rate increased by 33.5%, compared to the semi-cavity model. In conclusion, the high-temperature environment of the reactor has a significant effect on the increase in conversion rate, with an additional effect of reducing heat loss.