Ayahisa Okawa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ayahisa Okawa has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
- Shu Yin
Institute of Multidisciplinary Research for Advanced Material (IMRAM), Tohoku University, 2-1-1 Katahira, Aoba-ku, Sendai, Miyagi 980-8577, Japan
13 shared publications Takuya Hasegawa
8 shared publications- Tohru Sekino
SANKEN, The University of Osaka, 8-1 Mihogaoka, Ibaraki, Osaka, 567-0047, Japan
6 shared publications - Qiuyu Cheng
Institute of Multidisciplinary Research for Advanced Material (IMRAM) Tohoku University Sendai Japan
5 shared publications - Takuya Hasegawa
Institute of Multidisciplinary Research for Advanced Material (IMRAM), Tohoku University, 2-1-1 Katahira, Aoba-ku, Sendai, Miyagi 980-8577, Japan
5 shared publications Qiuyu Jin
4 shared publications
Latest Publications
- Open Access
- 7 October 2026
- Published by Elsevier in Materials Research Bulletin
- Vol. 207
Synthesis of Ag3PO4/WX2 (X = S, Se) layered heterojunctions for enhanced photocatalytic performance
- 7 October 2026
- Published by Elsevier in Materials Research Bulletin
- Vol. 207
Open AccessSynthesis of Ag3PO4/WX2 (X = S, Se) layered heterojunctions for enhanced photocatalytic performance
- Open Access
- 6 October 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1082
Magnesiothermic reduction–nitridation synthesis of Zr1-xHfxN solid-solution nanoparticles and their composition-tunable LSPR properties for photothermal nanofluids
- 6 October 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1082
Open AccessMagnesiothermic reduction–nitridation synthesis of Zr1-xHfxN solid-solution nanoparticles and their composition-tunable LSPR properties for photothermal nanofluids
- Open Access
- 1 October 2026
- Published by Elsevier in Applied Surface Science Advances
- Vol. 35
MxWO3/g-C3N4/BP (M = K, Rb, NH4) nanocomposites: Synergistic near-infrared shielding and photocatalytic purification
- 1 October 2026
- Published by Elsevier in Applied Surface Science Advances
- Vol. 35
Open AccessMxWO3/g-C3N4/BP (M = K, Rb, NH4) nanocomposites: Synergistic near-infrared shielding and photocatalytic purification
- Open Access
- 22 September 2026
- Published by Wiley in Advanced Materials
- Vol. 38 (62) , e75074
Multi‐Biomimetic Structural Colors Inspired by Pearls and Bird Feathers
One‐dimensional photonic crystals (1D PCs) enable precise control of light–matter interactions and display stable structural colors. However, their optical performance critically depends on strict periodicity and nanometer‐scale control of thickness, necessitating complex fabrication processes. In this work, we present a bio‐inspired structural coloration strategy that avoids these limitations by mimicking the structures of pearls and bird feathers. Specifically, a pearl‐like inorganic multilayer architecture lacking strict periodicity was synthesized via a facile solution‐based method. Distinct from traditional 1D PCs, this structure does not rely on precise periodicity, yet preserves the alternating refractive index modulation characteristic of 1D PCs. This disordered multilayer structure causes multiple reflections and partially coherent interference at internal interfaces, resulting in vivid and stable structural colors. Furthermore, inspired by the broadband‐absorbing melanin in bird feathers, surface‐integrated absorbing materials were introduced to selectively suppress non‐target interference. By tuning the absorbing materials, a continuous structural color spectrum covering the visible range can be achieved. The resulting biomimetic optical materials are readily processable and compatible with paints, plastics, coatings, and cosmetic applications.
- 22 September 2026
- Published by Wiley in Advanced Materials
- Vol. 38 (62) , e75074
Open AccessMulti‐Biomimetic Structural Colors Inspired by Pearls and Bird Feathers
One‐dimensional photonic crystals (1D PCs) enable precise control of light–matter interactions and display stable structural colors. However, their optical performance critically depends on strict periodicity and nanometer‐scale control of thickness, necessitating complex fabrication processes. In this work, we present a bio‐inspired structural coloration strategy that avoids these limitations by mimicking the structures of pearls and bird feathers. Specifically, a pearl‐like inorganic multilayer architecture lacking strict periodicity was synthesized via a facile solution‐based method. Distinct from traditional 1D PCs, this structure does not rely on precise periodicity, yet preserves the alternating refractive index modulation characteristic of 1D PCs. This disordered multilayer structure causes multiple reflections and partially coherent interference at internal interfaces, resulting in vivid and stable structural colors. Furthermore, inspired by the broadband‐absorbing melanin in bird feathers, surface‐integrated absorbing materials were introduced to selectively suppress non‐target interference. By tuning the absorbing materials, a continuous structural color spectrum covering the visible range can be achieved. The resulting biomimetic optical materials are readily processable and compatible with paints, plastics, coatings, and cosmetic applications.
- Open Access
- 26 June 2026
- Published by Elsevier in SSRN Electronic Journal
Magnesiothermic reduction–nitridation synthesis of Zr1-xHfxN solid-solution nanoparticles and their composition-tunable LSPR properties for photothermal nanofluids
Group IV transition metal nitrides (MeN; Me = Zr, Hf) exhibit localized surface plasmon resonance (LSPR) in the visible-to-near-infrared region and offer superior thermal stability over noble metals, making them highly attractive for solar photothermal applications. However, experimental control of the LSPR wavelength in MeN systems through solid-solution formation remains largely unexplored. Here, we report the low-temperature synthesis of Zr1-xHfxN solid-solution nanoparticles across the full composition range (x = 0, 0.25, 0.50, 0.75, 1.00) by combining a sol–gel method with magnesiothermic reduction–nitridation at 1000 °C. All samples formed the cubic rocksalt phase with a MeN phase fraction exceeding 92%. Rietveld refinement confirmed systematic compliance with Vegard's law, providing structural evidence for homogeneous solid-solution formation. The average particle diameter was 15-40 nm. Nanofluids were prepared by dispersing the nanoparticles in a 1:1 (v/v) mixture of water and ethylene glycol (EG) with polyvinylpyrrolidone (PVP) as a dispersant. The nanofluids exhibited distinct LSPR absorption peaks in the range of 650–800 nm, with the peak position shifting systematically to shorter wavelengths with increasing Hf content, demonstrating composition-dependent LSPR tunability. Under continuous halogen lamp irradiation, all nanofluids achieved a maximum temperature rise of approximately 25 °C relative to the base solvent. These results demonstrate that the LSPR wavelength of MeN-based nanofluids can be rationally controlled by solid-solution composition, providing a design strategy for high-efficiency photothermal conversion materials tailored to specific light sources.
- 26 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMagnesiothermic reduction–nitridation synthesis of Zr1-xHfxN solid-solution nanoparticles and their composition-tunable LSPR properties for photothermal nanofluids
Group IV transition metal nitrides (MeN; Me = Zr, Hf) exhibit localized surface plasmon resonance (LSPR) in the visible-to-near-infrared region and offer superior thermal stability over noble metals, making them highly attractive for solar photothermal applications. However, experimental control of the LSPR wavelength in MeN systems through solid-solution formation remains largely unexplored. Here, we report the low-temperature synthesis of Zr1-xHfxN solid-solution nanoparticles across the full composition range (x = 0, 0.25, 0.50, 0.75, 1.00) by combining a sol–gel method with magnesiothermic reduction–nitridation at 1000 °C. All samples formed the cubic rocksalt phase with a MeN phase fraction exceeding 92%. Rietveld refinement confirmed systematic compliance with Vegard's law, providing structural evidence for homogeneous solid-solution formation. The average particle diameter was 15-40 nm. Nanofluids were prepared by dispersing the nanoparticles in a 1:1 (v/v) mixture of water and ethylene glycol (EG) with polyvinylpyrrolidone (PVP) as a dispersant. The nanofluids exhibited distinct LSPR absorption peaks in the range of 650–800 nm, with the peak position shifting systematically to shorter wavelengths with increasing Hf content, demonstrating composition-dependent LSPR tunability. Under continuous halogen lamp irradiation, all nanofluids achieved a maximum temperature rise of approximately 25 °C relative to the base solvent. These results demonstrate that the LSPR wavelength of MeN-based nanofluids can be rationally controlled by solid-solution composition, providing a design strategy for high-efficiency photothermal conversion materials tailored to specific light sources.
- Open Access
- 10 May 2026
- Published by Elsevier in Applied Surface Science
- Vol. 741
A novel dual-functional K0.33WO3-g-C3N4-rGO nanocomposite fabricated using solvothermal and physical mixing for NIR shielding and self-cleaning application
- 10 May 2026
- Published by Elsevier in Applied Surface Science
- Vol. 741
Open AccessA novel dual-functional K0.33WO3-g-C3N4-rGO nanocomposite fabricated using solvothermal and physical mixing for NIR shielding and self-cleaning application
- Open Access
- 2 May 2026
- Published by Elsevier in Solar Energy
- Vol. 314
Optical properties, NIR reflectance, and application of blue-green/yellow-green inorganic pigments from cobalt/nickel doped Li2MgTi3O8
- 2 May 2026
- Published by Elsevier in Solar Energy
- Vol. 314
Open AccessOptical properties, NIR reflectance, and application of blue-green/yellow-green inorganic pigments from cobalt/nickel doped Li2MgTi3O8
- Open Access
- 23 August 2025
- Published by Elsevier in Materials Research Bulletin
- Vol. 194
Synthesis and optical properties of blue inorganic pigments with tetrahedrally coordinated Co2+/Ni2+ in Li2ZnSiO4
- 23 August 2025
- Published by Elsevier in Materials Research Bulletin
- Vol. 194
Open AccessSynthesis and optical properties of blue inorganic pigments with tetrahedrally coordinated Co2+/Ni2+ in Li2ZnSiO4
- Open Access
- 10 June 2025
- Published by Elsevier in Advanced Powder Technology
- Vol. 36 (8)
Optical characteristics and application of cobalt/nickel doped SrZn2(PO4)2 blue-violet and violet inorganic pigment powders
- 10 June 2025
- Published by Elsevier in Advanced Powder Technology
- Vol. 36 (8)
Open AccessOptical characteristics and application of cobalt/nickel doped SrZn2(PO4)2 blue-violet and violet inorganic pigment powders
- Open Access
- 27 March 2025
- Published by Elsevier in Advanced Powder Technology
- Vol. 36 (5)
Insights into the phase transition behavior of thermochromic VO2 (M1) powders doped with Tungsten
- 27 March 2025
- Published by Elsevier in Advanced Powder Technology
- Vol. 36 (5)
Open AccessInsights into the phase transition behavior of thermochromic VO2 (M1) powders doped with Tungsten