Dongdong Han
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Dongdong Han has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Chuang Li
Institute of Advanced Technology University of Science and Technology of China 230031 Hefei China
1 shared publication Kangli Xu
Department of Chemistry University of Science and Technology of China Hefei Anhui 230026 P. R. China
1 shared publicationLizhi Xu
CAS Key Laboratory of Urban Pollutant Conversion Department of Applied Chemistry University of Science and Technology of China 230041 Hefei China
1 shared publicationTianqi Yin
Institute of Advanced Technology University of Science and Technology of China 230031 Hefei China
1 shared publicationYishang Wu
Department of Chemistry University of Science and Technology of China Hefei Anhui 230026 P. R. China
1 shared publication- Yitai Qian
Department of Applied Chemistry, University of Science and Technology of China, Hefei 230026, P. R. China
1 shared publication
Latest Publications
- Open Access
- 12 January 2024
- Published by Wiley in ChemistryOpen
- Vol. 13 (5) , e202300178
Preparation of green high‐performance biomass‐derived hard carbon materials from bamboo powder waste
Efficient energy storage systems are crucial for the optimal utilization of renewable energy. Sodium‐ion batteries (SIBs) are considered potential substitutes for next‐generation low‐cost energy storage systems due to the low cost and abundance of sodium resources. However, the industrialization of SIBs faces a great challenge in terms of the anode. Hard carbon could be a promising anode material due to its high capacity and low cost which originates from biomass. This study used pre‐treatment and template carbonization methods to extract a hard carbon material from a large amount of discarded biomass in bamboo powder waste. This material has a good initial Coulombic efficiency of 78.6 % and good cycling stability when applied to sodium ion batteries.Typically, the optimal hard carbon material is used as the anode to prepare sodium ion battery prototypes to demonstrate their potential applications. The anode exhibited excellent sodium storage performance with a reversible capacity of 303 mAh ⋅ g−1 at 1 C rate and good cycling performance, retaining 92.0 % of its capacity after 100 cycles. These results demonstrate that BPPHC is a promising candidate for anode material in sodium‐ion batteries. This work suggests that bamboo powder could be a low‐cost anode material for SIBs.
- 12 January 2024
- Published by Wiley in ChemistryOpen
- Vol. 13 (5) , e202300178
Open AccessPreparation of green high‐performance biomass‐derived hard carbon materials from bamboo powder waste
Efficient energy storage systems are crucial for the optimal utilization of renewable energy. Sodium‐ion batteries (SIBs) are considered potential substitutes for next‐generation low‐cost energy storage systems due to the low cost and abundance of sodium resources. However, the industrialization of SIBs faces a great challenge in terms of the anode. Hard carbon could be a promising anode material due to its high capacity and low cost which originates from biomass. This study used pre‐treatment and template carbonization methods to extract a hard carbon material from a large amount of discarded biomass in bamboo powder waste. This material has a good initial Coulombic efficiency of 78.6 % and good cycling stability when applied to sodium ion batteries.Typically, the optimal hard carbon material is used as the anode to prepare sodium ion battery prototypes to demonstrate their potential applications. The anode exhibited excellent sodium storage performance with a reversible capacity of 303 mAh ⋅ g−1 at 1 C rate and good cycling performance, retaining 92.0 % of its capacity after 100 cycles. These results demonstrate that BPPHC is a promising candidate for anode material in sodium‐ion batteries. This work suggests that bamboo powder could be a low‐cost anode material for SIBs.
- 10 October 2021
- Published by Wiley in European Journal of Inorganic Chemistry
- Vol. 2021 (48) , 5045-5051
Enhanced Hydrogen Evolution Catalysis from Hierarchical Nanostructure Co−P@CoMo−P Electrode
The construction of hierarchical nanostructures is a fascinating target because of their promising applications in electronic analysis and catalysis. Herein, we establish a 3‐d hierarchical nanostructure Co−P@CoMo−P to enhance the catalytic ability. The hydrogen evolution reaction catalytic ability was enhanced significantly with a Tafel slope of 34 mV dec−1 and an overpotential of 37 mV to achieve 10 mA cm−2, which are superior to that of recently reported non‐noble metal catalysts. The high catalytic performance could be rationalized as follows: (1) Co−P nanowire intimately contacted with Ni foam enables good mechanical adhesion and facilitates the flow of electrons from Ni foam to CoMo−P nanosheet; (2) the hierarchical nanostructure can expose more active sites and transport reactants and products sufficiently; (3) the space between two separate hierarchical nanostructures is loose and open, allowing electrolyte to diffuse into all the active sites and make them used efficiently. This work is promising for the development of novel non‐noble metal catalysts for energy technologies.
- 10 October 2021
- Published by Wiley in European Journal of Inorganic Chemistry
- Vol. 2021 (48) , 5045-5051
Enhanced Hydrogen Evolution Catalysis from Hierarchical Nanostructure Co−P@CoMo−P Electrode
The construction of hierarchical nanostructures is a fascinating target because of their promising applications in electronic analysis and catalysis. Herein, we establish a 3‐d hierarchical nanostructure Co−P@CoMo−P to enhance the catalytic ability. The hydrogen evolution reaction catalytic ability was enhanced significantly with a Tafel slope of 34 mV dec−1 and an overpotential of 37 mV to achieve 10 mA cm−2, which are superior to that of recently reported non‐noble metal catalysts. The high catalytic performance could be rationalized as follows: (1) Co−P nanowire intimately contacted with Ni foam enables good mechanical adhesion and facilitates the flow of electrons from Ni foam to CoMo−P nanosheet; (2) the hierarchical nanostructure can expose more active sites and transport reactants and products sufficiently; (3) the space between two separate hierarchical nanostructures is loose and open, allowing electrolyte to diffuse into all the active sites and make them used efficiently. This work is promising for the development of novel non‐noble metal catalysts for energy technologies.