Zhenyu Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zhenyu Liu has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Yue Li
Department of Electronic Engineering, Beijing National Research Center for Information Science and Technology, State Key Laboratory of Space Network and Communications, Tsinghua University, Beijing, China
5 shared publications - Yongjian Zhang
Unmanned System Research Institute, Northwestern Polytechnical University, Xian, China
3 shared publications - Yijing He
Beijing Key Laboratory of Millimeter Wave and Terahertz Technology, School of Integrated Circuits and Electronics, Beijing Institute of Technology, Beijing, China
2 shared publications - Shuyu Wang
Department of Electronic Engineering, Tsinghua University, Beijing, China
1 shared publication - Wangyu Sun
Department of Electronic Engineering, Tsinghua University, Beijing, China
1 shared publication - Yang Li
School of Electronics and Information Technology State Key Laboratory of Optoelectronic Materials and Technologies Sun Yat-sen University 510275 Guangzhou China
1 shared publication
Latest Publications
- 16 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 72 (9) , 7323-7328
Active–Passive Reconfigurable Antenna Covering 70–7200 MHz Bandwidth
This communication presents an active-passive reconfigurable antenna with 70-7200 MHz bandwidth for multiple wireless services. The active-passive reconfiguration is achieved by reusing a properly designed monopole antenna with active-passive reconfigurable matching circuit, which is composed of a passive path and an active path. The passive path guarantees an inherent bandwidth of 923-7200 MHz for higher frequencies. While the active path, achieved by a transistor biased in its ohmic region, ensures the impedance matching within 70-1200 MHz for lower frequencies. The path selection is facilitated by the cooperated design among the transistor, the PIN diodes, and their own bias circuits. Therefore, the proposed active-passive reconfigurable antenna achieves a total bandwidth spanning from 70 MHz to 7200 MHz with a reflection coefficient consistently below -10 dB, and validated by experiments. Such wideband performance exhibits the exciting potential for multiple-standard signal sensing to support increasing wireless services with single antenna configuration.
- 16 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 72 (9) , 7323-7328
Active–Passive Reconfigurable Antenna Covering 70–7200 MHz Bandwidth
This communication presents an active-passive reconfigurable antenna with 70-7200 MHz bandwidth for multiple wireless services. The active-passive reconfiguration is achieved by reusing a properly designed monopole antenna with active-passive reconfigurable matching circuit, which is composed of a passive path and an active path. The passive path guarantees an inherent bandwidth of 923-7200 MHz for higher frequencies. While the active path, achieved by a transistor biased in its ohmic region, ensures the impedance matching within 70-1200 MHz for lower frequencies. The path selection is facilitated by the cooperated design among the transistor, the PIN diodes, and their own bias circuits. Therefore, the proposed active-passive reconfigurable antenna achieves a total bandwidth spanning from 70 MHz to 7200 MHz with a reflection coefficient consistently below -10 dB, and validated by experiments. Such wideband performance exhibits the exciting potential for multiple-standard signal sensing to support increasing wireless services with single antenna configuration.
- 28 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 23 (7) , 2115-2119
Low-Profile Epsilon-Near-Zero (ENZ) Cavity Antenna Array for Wide-Angle Beam Scanning
In this letter, a low-profile epsilon-near-zero (ENZ) cavity antenna array is proposed to achieve wide-angle beam scanning. The proposed array utilizes four slot-fed cavity antenna elements that operate with the ENZ mode, in which the electric field presents a unique sign-function-like distribution. By properly designing the width of the ENZ cavity, a wide 3-dB beamwidth is achieved in a low profile to increase the beam scanning angle of the array configuration. Furthermore, the narrow width of the antenna element also facilitates a decreased spacing between array elements, enabling the use of the appropriate spacing to increase the scanning angle. Different from the conventional wide-angle beam-scanning arrays with high profile, the proposed ENZ cavity antenna array achieves a remarkable beam scanning angle of ±72° (±73° in the measurement) while maintaining a low profile of only 0.03 λ 0 , exhibiting the potential applications in low-profile phased array systems.
- 28 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 23 (7) , 2115-2119
Low-Profile Epsilon-Near-Zero (ENZ) Cavity Antenna Array for Wide-Angle Beam Scanning
In this letter, a low-profile epsilon-near-zero (ENZ) cavity antenna array is proposed to achieve wide-angle beam scanning. The proposed array utilizes four slot-fed cavity antenna elements that operate with the ENZ mode, in which the electric field presents a unique sign-function-like distribution. By properly designing the width of the ENZ cavity, a wide 3-dB beamwidth is achieved in a low profile to increase the beam scanning angle of the array configuration. Furthermore, the narrow width of the antenna element also facilitates a decreased spacing between array elements, enabling the use of the appropriate spacing to increase the scanning angle. Different from the conventional wide-angle beam-scanning arrays with high profile, the proposed ENZ cavity antenna array achieves a remarkable beam scanning angle of ±72° (±73° in the measurement) while maintaining a low profile of only 0.03 λ 0 , exhibiting the potential applications in low-profile phased array systems.
- Open Access
- 30 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 4, 151-158
Beamwidth Enhancement of Microstrip Antennas Using Capacitive Via-Fence Loading
In this paper, a general approach to enhance the beamwidth of microstrip antennas is proposed for wide beam coverage in both E-and H-planes. A microstrip antenna loaded with two arrays of capacitive via fences is propounded and systematically studied. By introducing the vertical currents brought by the capacitive metalized vias, the half-power beamwidth (HPBW) is effectively broadened compared with the regular microstrip antennas. In addition, by utilizing the air medium with low loss, the microstrip antenna can be supported by the two arrays of via fences, maintaining a high radiation efficiency. To validate the proposed design, a prototype is fabricated and tested. The measurement results agree well with the simulated ones, with enhanced HPBWs of 1000 and 900 in E-and H-planes, respectively. Compared with the existing 2.4-GHz antennas, the propounded antenna is with the advantages of wide beamwidth and high radiation efficiency, exhibiting the potential applications for space-limited mobile devices with wide coverage requirement.
- 30 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 4, 151-158
Open AccessBeamwidth Enhancement of Microstrip Antennas Using Capacitive Via-Fence Loading
In this paper, a general approach to enhance the beamwidth of microstrip antennas is proposed for wide beam coverage in both E-and H-planes. A microstrip antenna loaded with two arrays of capacitive via fences is propounded and systematically studied. By introducing the vertical currents brought by the capacitive metalized vias, the half-power beamwidth (HPBW) is effectively broadened compared with the regular microstrip antennas. In addition, by utilizing the air medium with low loss, the microstrip antenna can be supported by the two arrays of via fences, maintaining a high radiation efficiency. To validate the proposed design, a prototype is fabricated and tested. The measurement results agree well with the simulated ones, with enhanced HPBWs of 1000 and 900 in E-and H-planes, respectively. Compared with the existing 2.4-GHz antennas, the propounded antenna is with the advantages of wide beamwidth and high radiation efficiency, exhibiting the potential applications for space-limited mobile devices with wide coverage requirement.
- 30 September 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 70 (12) , 12317-12321
A Compact-Size and High-Efficiency Cage Antenna for 2.4-GHz WLAN Access Points
In this communication, a compact-size and high-efficiency air cavity antenna with a cage-like structure is proposed for 2.4-GHz Wireless Local Area Networks (WLAN). The air cavity antenna is constructed with four sides of hybrid metallized vias, including sparsely arranged blind vias and tightly arranged shorting vias. Firstly, the antenna size is significantly reduced by utilizing the shorting vias, which make the antenna operate at the high-order TM 1/2,1/2 mode. Then, by loading the capacitive blind vias at the radiating apertures, the antenna size is further miniaturized. Notably, high radiation efficiency is obtained attributed to the lower dielectric loss of the air-medium structure. Finally, a prototype of the proposed cage antenna has been fabricated and tested with good agreement between simulated and measured results. In such a compact size of 0.128 λ 0 ×0.128 λ 0 ×0.10 λ 0 (λ 0 is free-space wavelength at the center frequency), the measured total efficiency over 90% is achieved in the WLAN band by the cage structure. Compared with the existing 2.4-GHz antennas, the proposed one is with the ascendency of compact size and high radiating efficiency for WLAN applications.
- 30 September 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 70 (12) , 12317-12321
A Compact-Size and High-Efficiency Cage Antenna for 2.4-GHz WLAN Access Points
In this communication, a compact-size and high-efficiency air cavity antenna with a cage-like structure is proposed for 2.4-GHz Wireless Local Area Networks (WLAN). The air cavity antenna is constructed with four sides of hybrid metallized vias, including sparsely arranged blind vias and tightly arranged shorting vias. Firstly, the antenna size is significantly reduced by utilizing the shorting vias, which make the antenna operate at the high-order TM 1/2,1/2 mode. Then, by loading the capacitive blind vias at the radiating apertures, the antenna size is further miniaturized. Notably, high radiation efficiency is obtained attributed to the lower dielectric loss of the air-medium structure. Finally, a prototype of the proposed cage antenna has been fabricated and tested with good agreement between simulated and measured results. In such a compact size of 0.128 λ 0 ×0.128 λ 0 ×0.10 λ 0 (λ 0 is free-space wavelength at the center frequency), the measured total efficiency over 90% is achieved in the WLAN band by the cage structure. Compared with the existing 2.4-GHz antennas, the proposed one is with the ascendency of compact size and high radiating efficiency for WLAN applications.
- 11 October 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 119 (15) , 151904
Integrated epsilon-near-zero antenna for omnidirectional radiation
Antennas with omnidirectional radiation of electromagnetic wave have wide applications in sensing, positioning, and wireless communications. Here, we investigate the potentials of using epsilon-near-zero (ENZ) metamaterial to realize omnidirectional radiation with high degrees of freedom. We propose an omnidirectional antenna based on an ENZ cavity integrated in printed circuits board (PCB). By taking advantage of ENZ behavior, the ENZ antenna can decouple the radiation patterns and the operating frequency while maintaining the omnidirectional radiation characteristic. Based on the omnidirectional ENZ antenna element, a parallel-fed array is realized based on the low-cost PCB process. The integrated ENZ antenna array exhibits the capability of engineering the omnidirectional radiation flexibly, such as beam scanning and beam intensity control for practical applications.
- 11 October 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 119 (15) , 151904
Integrated epsilon-near-zero antenna for omnidirectional radiation
Antennas with omnidirectional radiation of electromagnetic wave have wide applications in sensing, positioning, and wireless communications. Here, we investigate the potentials of using epsilon-near-zero (ENZ) metamaterial to realize omnidirectional radiation with high degrees of freedom. We propose an omnidirectional antenna based on an ENZ cavity integrated in printed circuits board (PCB). By taking advantage of ENZ behavior, the ENZ antenna can decouple the radiation patterns and the operating frequency while maintaining the omnidirectional radiation characteristic. Based on the omnidirectional ENZ antenna element, a parallel-fed array is realized based on the low-cost PCB process. The integrated ENZ antenna array exhibits the capability of engineering the omnidirectional radiation flexibly, such as beam scanning and beam intensity control for practical applications.