JBJoão Brinco

João Brinco

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


João Brinco has a total of 30 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Integrated Electrochemical Technologies for Wastewater Treatment and Soil Remediation: Tackling Contaminants of Emerging Concern and Pathogens

    by Nazaré Couto, Paula Guedes, Ana R. Ferreira, Vanessa G. Correia, Raquel Carvalho, João Brinco, Eduardo P. Mateus, Alexandra B. Ribeiro

  • Open Access

    Analysis of Plasticizer Contamination Throughout Olive Oil Production

    by Flávia Freitas, João Brinco, Maria João Cabrita, Marco Gomes da Silva

    This study monitored the contamination of 32 plasticizers in olive oil throughout the production and storage process. Samples were collected at different stages of production from three olive oil production lines in distinct regions of Portugal and analyzed for 23 phthalates and 9 phthalates substitutes to identify contamination sources. The developed analytical method employed liquid–liquid extraction with hexane/methanol (1:4, v/v), followed by centrifugation, extract removal, and freezing as a clean-up step. Analysis was conducted using gas chromatography tandem mass spectrometry (GC-MS/MS), with detection limits ranging from 0.001 to 0.103 mg/kg. The results revealed that plasticizer concentrations progressively increased at each stage of the production process, although unprocessed olives also contained contaminants. Di-isononyl phthalate (DINP) was the most prevalent compound, but all phthalates regulated by the European Union for food contact materials were detected, as well as some unregulated plasticizers. In a few packaged olive oils, DINP concentrations exceeded the specific migration limits established by European regulations. Samples stored in glass and plastic bottles showed no significant differences in plasticizer concentrations after six months of storage. However, higher concentrations were observed in plastic-packaged samples after 18 months of storage. Our findings indicate that the primary source of plasticizer contamination in olive oil originates from the production process itself, except for prolonged storage in plastic bottles, which should be avoided.


  • Open Access

    Simultaneous Determination of Glyphosate and 13 Multiclass Pesticides in Agricultural Soil by Direct-Immersion SPME Followed by Solid–Liquid Extraction

    by João Brinco, Paula Guedes, Marco Gomes da Silva, Eduardo P. Mateus, Alexandra B. Ribeiro

    A new method is presented for the simultaneous determination of 13 multiclass pesticides along with glyphosate. The multiclass pesticides were extracted by creating a soil slurry with 2% ethanol in water (v/v), and then, applying direct-immersion solid-phase microextraction (DI-SPME) with a new type of semi-disposable SPME fiber configuration called LC-Tips. The fibers were then retroextracted to ethanol, and aqueous ammonia was added to the slurry to extract glyphosate. Derivatization of the glyphosate extract was accomplished with a mixture of trifluoroacetic anhydride and trifluoroethanol, after which the reaction mixture was dried and resuspended with the SPME ethanol extract. To this, a mixture of analyte protectants was added, and it was analyzed by GC-MS/MS in multiple-reaction-monitoring mode. All analytes showed a coefficient of determination greater than 0.95 in the 0.1–100 µg/kg calibrated range, and the limits of detection were between 0.1 and 1 µg/kg, except for glyphosate, which was 0.01 µg/kg. The method shows relatively high replicate relative standard deviation (as much as 37% for five extractions at 20 µg/kg), but the isotopically labeled internal standard was effective at mitigating this effect for some analytes.


  • Open Access

    Extraction of pesticides from soil using direct-immersion SPME LC-Tips followed by GC–MS/MS: Evaluation and proof-of-concept

    by João Brinco, Raquel Carvalho, Marco Gomes da Silva, Paula Guedes, Alexandra B. Ribeiro, Eduardo P. Mateus


  • Open Access

    Analysis of pesticide residues in soil: A review and comparison of methodologies

    by João Brinco, Paula Guedes, Marco Gomes da Silva, Eduardo P. Mateus, Alexandra B. Ribeiro


  • Aerobic oxidation of benzylic alcohols catalysed by new (aryl‐BIAN)copper(I) complexes: Their synthesis and structural characterization

    by Vitor Rosa, Helena Laronha, Clara S. B. Gomes, Cristina M. Cordas, João Brinco, Flávia Freitas, Marco D. R. Gomes da Silva, Teresa Avilés

    A new neutral dimeric Ar‐BIAN Cu(I) complex (where Ar‐BIAN = bis(aryl‐imino)acenaphthene) of formulation [CuBr(4‐iPrC6H4‐BIAN)]2 (2) was obtained by reacting CuBr and ligand 4‐iPrC6H4‐BIAN (L2) in refluxing acetonitrile under an argon atmosphere. When the ligand used was 2,4,6‐Me3C6H2‐BIAN (L1), we obtained 1 in which the expected dimer (1a) is present, but we could also observe, in solution, the presence of the bis‐chelate dimer [Cu(2,4,6‐Me3C6H2‐BIAN)2][CuBr2] (1b) bearing CuBr2− as counter‐ion; attempts to separate them failed. When the ligand used was 2‐iPrC6H4‐BIAN (L3), we obtained 3 in which the expected dimer (3a) is in equilibrium, in solution, with its bis‐chelate isomer [Cu(2‐iPrC6H4‐BIAN)2][CuBr2] (3b). The solid‐state molecular structures of compounds 2 and 3b were determined by single crystal X‐ray diffraction. The electrochemical behaviour of complexes: 1 (1a, and 1b), 2, and 3 (3a and 3b) and the known compound [Cu(2‐iPrC6H4‐BIAN)2][BF4] (7) were investigated by cyclic voltammetry. The new complexes 1 (1a, 1b), 2, and 3 (3a, 3b) were tested as catalysts for the aerobic oxidation of benzylic alcohols into aldehydes; they all catalyse the reaction, with good results; the catalytic studies were extended to the similar known complexes [CuBr(2,6‐iPr2C6H3‐BIAN)]2 (4), [CuI(2,6‐iPr2C6H3‐BIAN)]2 (5), [CuCl(2,6‐iPr2C6H3‐BIAN)]2 (6) and (7), in order to study the effect of different bridging halides or counter ions in the catalytic activity. We found that compound 4 exhibited a high catalytic activity comparable to the best results published so far. The oxidation products, benzaldehydes, were detected and further confirmed by NMR spectroscopy, and the conversion rate was determined after GC‐FID analysis.


  • Open Access

    Chemical and Functional Characterization of Extracts from Leaves and Twigs of Acacia dealbata

    by Ricardo Correia, Maria Paula Duarte, Elisabete Muchagato Maurício, João Brinco, José Carlos Quintela, Marco Gomes da Silva, Margarida Gonçalves

    The purpose of this work was to evaluate the recovery of bioactive extracts from Acacia dealbata leaves and twigs and to characterize their chemical composition and functional properties. Fresh and air-dried samples were extracted by maceration at room temperature and by hot extraction at 60 °C using aqueous solutions of acetone, ethanol, and methanol. The highest extraction yields (14.8 and 12.0% for dried leaves and twigs, respectively) were obtained with 70% acetone, for both extraction procedures. Extracts were characterized for total phenolics content (TPC), total flavonoid content (TFC) and total proanthocyanidin content (TPrAC). Bioactive extracts with high TPC (526.4 mg GAE/g extract), TFC (198.4 mg CatE/g extract), and TPrAC (631.3 mg PycE/g extract) were obtained using maceration, a technically simple and low-energy process. The non-polar fraction of selected extracts was characterized using gas chromatography and time of flight mass spectrometry (GC-TOFMS). The main components detected were phytol, squalene, α-tocopherol, lupenone, and lupeol. The antioxidant activity of the extracts was characterized through DPPH and FRAP assays. Antimicrobial activity of the extracts against different bacteria was also determined. The highest DPPH and FRAP activities were obtained from dried twigs from Alcobaça (1068.3 mg TE/g extract and 9194.6 mmol Fe2+/g extract, respectively). Extracts from both leaves and twigs showed antimicrobial properties against Staphylococcus aureus, Staphylococcus epidermidis, methicillin resistant Staphylococcus aureus (MRSA), Enterococcus faecalis, Bacillus cereus, Streptococcus mutans, and Streptococcus mitis. The results obtained demonstrate the feasibility of recovering valuable components from these biomass fractions that may be further valorized for energy production in a biorefinery concept.


  • Open Access

    DCMC as a Promising Alternative to Bentonite in White Wine Stabilization. Impact on Protein Stability and Wine Aromatic Fraction

    by Francesco Saracino, João Brinco, Diana Gago, Marco Gomes da Silva, Ricardo Boavida Ferreira, Jorge Ricardo-Da-Silva, Ricardo Chagas, Luísa Maria Ferreira

    Protein haze in white wine is one of the most common non-microbial defects of commercial wines, with bentonite being the main solution utilized by the winemaking industry to tackle this problem. Bentonite presents some serious disadvantages, and several alternatives have been proposed. Here, an alternative based on a new cellulose derivative (dicarboxymethyl cellulose, DCMC) is proposed. To determine the efficiency of DCMC as a bentonite alternative, three monovarietal wines were characterized, and their protein instability and content determined by a heat stability test (HST) and the Bradford method, respectively. The wines were treated with DCMC to achieve stable wines, as shown by the HST, and the efficacy of the treatments was assessed by determining, before and after treatment, the wine content in protein, phenolic compounds, sodium, calcium, and volatile organic compounds (VOCs) as well as the wine pH. DCMC applied at dosages such as those commonly employed for bentonite was able to reduce the protein content in all tested wines and to stabilize all but the Moscatel de Setúbal varietal wine. In general, DCMC was shown to induce lower changes in the wine pH and phenolic content than bentonite, reducing the wine calcium content. Regarding which VOCs are concerned, DCMC produced a general impact similar to that of bentonite, with differences depending on wine variety. The results obtained suggest that DCMC can be a sustainable alternative to bentonite in protein white wine stabilization.