Sarah E. Johnson
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Sarah E. Johnson has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- William C. Haneberg
Kentucky Geological Survey, University of Kentucky, Lexington, KY 40506, USA
3 shared publications - Edward W. Woolery
Department of Earth and Environmental Sciences, University of Kentucky, Lexington, Kentucky, U.S.A.
2 shared publications Ben Roenker
1 shared publicationC. Matocha
1 shared publicationC.J. Cortese
1 shared publication- J. Ryan Thigpen
Department of Earth and Environmental Sciences University of Kentucky Lexington KY USA
1 shared publication
Latest Publications
- 26 December 2024
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 50 (1)
Machine learning for surficial geologic mapping
Surficial geologic maps contribute to decisions regarding natural hazard mitigation, land‐use planning and infrastructure development. However, geologic maps may not adequately convey the uncertainty inherent in the information shown. In this study, we use machine learning and lidar elevation data to produce surficial geologic maps for parts of two quadrangles in Kentucky. We measured the performance of eight supervised machine learning methods by comparing the overall accuracy and F1 scores for each geologic unit. Surficial geologic units include residuum, colluvium, alluvial and lacustrine terraces, high‐level alluvial deposits and modern alluvium. The importance of 41 moving‐window geomorphic variables, including slope, roughness, residual topography, curvature, topographic wetness index, vertical distance to channel network and topographic flatness, was reduced to 12 variables by ranking the importance of each variable. The gradient‐boosted trees model produced the classifier with the greatest overall accuracy, producing maps with overall accuracies of 87.4% to 90.7% in areas of simple geology and 80.7% to 81.6% in areas with more complex geology. The model produced high F1 scores of up to 96.2% for colluvium but was not as good at distinguishing between units found in the same geomorphic position, such as high‐level alluvium and residuum, both of which are found on ridgelines. Probability values for each geologic unit at each cell are conveyed using gradations of colour and eliminate the need for drawn boundaries between units. Machine learning may be used to create accurate surficial geologic maps in areas of simple geology; in more complex areas, highlight that additional information obtained in the field is necessary to distinguish between units.
- 26 December 2024
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 50 (1)
Machine learning for surficial geologic mapping
Surficial geologic maps contribute to decisions regarding natural hazard mitigation, land‐use planning and infrastructure development. However, geologic maps may not adequately convey the uncertainty inherent in the information shown. In this study, we use machine learning and lidar elevation data to produce surficial geologic maps for parts of two quadrangles in Kentucky. We measured the performance of eight supervised machine learning methods by comparing the overall accuracy and F1 scores for each geologic unit. Surficial geologic units include residuum, colluvium, alluvial and lacustrine terraces, high‐level alluvial deposits and modern alluvium. The importance of 41 moving‐window geomorphic variables, including slope, roughness, residual topography, curvature, topographic wetness index, vertical distance to channel network and topographic flatness, was reduced to 12 variables by ranking the importance of each variable. The gradient‐boosted trees model produced the classifier with the greatest overall accuracy, producing maps with overall accuracies of 87.4% to 90.7% in areas of simple geology and 80.7% to 81.6% in areas with more complex geology. The model produced high F1 scores of up to 96.2% for colluvium but was not as good at distinguishing between units found in the same geomorphic position, such as high‐level alluvium and residuum, both of which are found on ridgelines. Probability values for each geologic unit at each cell are conveyed using gradations of colour and eliminate the need for drawn boundaries between units. Machine learning may be used to create accurate surficial geologic maps in areas of simple geology; in more complex areas, highlight that additional information obtained in the field is necessary to distinguish between units.
- Open Access
- 15 February 2023
- Published by Geological Society of London in Quarterly Journal of Engineering Geology and Hydrogeology
- Vol. 56 (2)
Measuring ground surface elevation changes in a slow-moving colluvial landslide using combinations of regional airborne lidar, UAV lidar and UAV photogrammetric surveys
Slow-moving, chronically destructive landslides are projected to grow in number globally in response to precipitation increases from climate change, and land disturbances from wildfire, mining and construction. In the Cincinnati and northern Kentucky metropolitan area, USA, landslides develop in colluvium that covers the steep slopes along the Ohio River and its tributaries. Here we quantify elevation changes in a slow-moving colluvial landslide over 14 years using county-wide lidar, uncrewed aerial vehicle (UAV) structure-from-motion (SfM) surveys and a UAV lidar survey. Because the technology and quality differ between surveys, the challenge was to calculate a threshold of detectable change for each survey combination. We introduce two methods; the first uses propagated elevation difference errors and the second back-calculates the individual survey errors. Thresholds of detection range from ±0.05 to ±0.20 m. Record rainfall in 2011 produced the largest vertical changes. Since then, the landslide toe has continued to deform, and the landslide has doubled its width by extending into a previously undisturbed slope. Although this study presents a technique to utilize older datasets in combination with modern surveys to monitor slow-moving landslides, it is broadly applicable to other studies where topographic data of differing quality are available.
- 15 February 2023
- Published by Geological Society of London in Quarterly Journal of Engineering Geology and Hydrogeology
- Vol. 56 (2)
Open AccessMeasuring ground surface elevation changes in a slow-moving colluvial landslide using combinations of regional airborne lidar, UAV lidar and UAV photogrammetric surveys
Slow-moving, chronically destructive landslides are projected to grow in number globally in response to precipitation increases from climate change, and land disturbances from wildfire, mining and construction. In the Cincinnati and northern Kentucky metropolitan area, USA, landslides develop in colluvium that covers the steep slopes along the Ohio River and its tributaries. Here we quantify elevation changes in a slow-moving colluvial landslide over 14 years using county-wide lidar, uncrewed aerial vehicle (UAV) structure-from-motion (SfM) surveys and a UAV lidar survey. Because the technology and quality differ between surveys, the challenge was to calculate a threshold of detectable change for each survey combination. We introduce two methods; the first uses propagated elevation difference errors and the second back-calculates the individual survey errors. Thresholds of detection range from ±0.05 to ±0.20 m. Record rainfall in 2011 produced the largest vertical changes. Since then, the landslide toe has continued to deform, and the landslide has doubled its width by extending into a previously undisturbed slope. Although this study presents a technique to utilize older datasets in combination with modern surveys to monitor slow-moving landslides, it is broadly applicable to other studies where topographic data of differing quality are available.
- 2 June 2022
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 592
The influence of glacial topography on fluvial efficiency in the Teton Range, Wyoming (USA)
- 2 June 2022
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 592
The influence of glacial topography on fluvial efficiency in the Teton Range, Wyoming (USA)
- 15 October 2021
- Published by Springer Nature in Natural Hazards
- Vol. 111 (1) , 567-584
Response of the Laprak, Nepal, landslide to the 2015 Mw 7.8 Gorkha earthquake
- 15 October 2021
- Published by Springer Nature in Natural Hazards
- Vol. 111 (1) , 567-584
Response of the Laprak, Nepal, landslide to the 2015 Mw 7.8 Gorkha earthquake