Yansong Wang

In this paper, we propose an all-dielectric metamaterials structure which contains four asymmetric square holes in the unit cell to design a high-sensitivity refractive index sensor in the long-wave infrared region. Theoretical analysis of the electromagnetic field distributions shows that the four transmission dips originate from magnetic dipole, electric quadrupole and Toroidal dipole. And its position can be tuned by adjusting different geometric parameters, which can optimize the structure to obtain a narrower linewidth to improve the performance of the sensor. Finally, we evaluate the performance of the structure as refractive index sensor by changing the refractive index of the tested substrate. The results show the refractive index sensor has high sensitivity in the long-wave infrared region: the highest sensitivity is 2803 nm/RIU and the figure of merit will reach up to 350.

A bandpass filter integrated metalens based on electromagnetically induced transparency (EIT) for long-wavelength infrared (LWIR) imaging is designed in this paper. The bandwidth of the metalens, which is a diffractive optical element, decreases significantly with the increase of the aperture size to a fixed f-number, which leads to the decline of imaging performance. The same material composition and preparation process of the metalens and the EIT metasurface in the long-wavelength infrared make it feasible that the abilities of focusing imaging and filtering are integrated into a metasurface device. With the purpose of validating the feasibility of this design method, we have designed a 300-μm-diameter integrated metalens whose f-number is 0.8 and the simulation was carried out. The introduction of EIT metasurface does not affect the focusing near the diffraction limit at the target wavelength, and greatly reduces the influence of stray light caused by non-target wavelength incident light. This bandpass filter integrated metalens design method may have a great potential in the field of LWIR compact optical systems.

Longwave infrared (LWIR) optics are essential for several technologies, such as thermal imaging and wireless communication, but their development is hindered by their bulk and high fabrication costs. Metasurfaces have recently emerged as powerful platforms for LWIR integrated optics; however, conventional metasurfaces are highly chromatic, which adversely affects their performance in broadband applications. In this work, the chromatic dispersion properties of metasurfaces are analyzed via ray tracing, and a general method for correcting chromatic aberrations of metasurfaces is presented. By combining the dynamic and geometric phases, the desired group delay and phase profiles are imparted to the metasurfaces simultaneously, resulting in good achromatic performance. Two broadband achromatic metasurfaces based on all-germanium platforms are demonstrated in the LWIR: a broadband achromatic metalens with a numerical aperture of 0.32, an average intensity efficiency of 31%, and a Strehl ratio above 0.8 from 9.6 μm to 11.6 μm, and a broadband achromatic metasurface grating with a constant deflection angle of 30° from 9.6 μm to 11.6 μm. Compared with state-of-the-art chromatic-aberration-restricted LWIR metasurfaces, this work represents a substantial advance and brings the field a step closer to practical applications.