Pedro Augusto Santos Almeida
Research Subjects
Research Interests
Pedro Augusto Santos Almeida has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- André Maia-Lima
Boa Vista Zona Oeste Campus, Federal Institute of Roraima, Roraima, Brazil
1 shared publication - André Scotti Rabelo
Universidade Federal do Maranhão-UFMA
1 shared publication - Bruno Teobaldo Campos
Universidade Federal de Minas Gerais
1 shared publication - Bruno Victor Corrêa da Silva
Exercise Science, Health and Human Performance Research Group, Department of Sport Sciences, Institute of Health Sciences, Federal University of Triângulo Mineiro
1 shared publication - Bárbara Marielle Silva França
Exercise Physiology Lab, School of Physical Education, Physical Therapy and Occupational Therapy of Federal University of Minas Gerais, Brazil
1 shared publication - Dan Gordon
Anglia Ruskin University
1 shared publication
Latest Publications
- 30 October 2025
- Published by Taylor & Francis in International Journal of Performance Analysis in Sport
- Vol. 26 (4) , 1-12
Acute effect of mechanical vibration on sprint performance in mountain bike athletes
- 30 October 2025
- Published by Taylor & Francis in International Journal of Performance Analysis in Sport
- Vol. 26 (4) , 1-12
Acute effect of mechanical vibration on sprint performance in mountain bike athletes
- Open Access
- 24 July 2025
- Published by University of Leon in Revista de Artes Marciales Asiáticas
- Vol. 25 (2) , 199-208
Anthropometric characteristics of Brazilian jiu-jitsu athletes and their relationship with anaerobic performance
Anaerobic metabolism is crucial to Brazilian jiu-jitsu athletes (BJJ), principally during the decisive moments of the match, to perform sweeps, throws, and ground techniques. However, little is known about the association between anthropometric variables with anaerobic performance. Objectives: To describe the peak power (PP) and mean power (MP) obtained in the Wingate test by BJJ athletes, to investigate the correlations between PP and MP and anthropometric variables, and to identify the anthropometric predictors of anaerobic performance. Methods: Twenty male BJJ athletes (aged: 22.9 ± 2.3 yrs, height: 1.75 ± 0.05 m, and body mass: 75.7 ± 10.3 kg) performed a 30 s Wingate test. Anthropometric variables, body mass (BM), fat free mass (FFM), muscle mass (MM), fat mass (FM), and percentage fat mass (%FM) were measured through electric bioimpedance. Results: Absolute mean values for PP and MP were 926 ± 154 and 665 ± 110 W, respectively, whereas relative values to BM were 12.2 ± 1.3 and 8.8 ± 0.9 W.kg-1, respectively. The mean FI value was 30.0 ± 4.7%. A significant and positive correlation was observed between PP and MP with all anthropometric variables (MM, FFM, %FM, FM). FFM was the best predictor of both PP (R2 = 0.69, p = .001) and MP (R2 = 0.67, p = 0.001) in the Wingate test. Conclusions: The results of this study demonstrated that FFM was the main anthropometric variable associated with anaerobic performance in BJJ athletes. Improving FFM may be a key strategy for enhancing anaerobic performance in this population.
- 24 July 2025
- Published by University of Leon in Revista de Artes Marciales Asiáticas
- Vol. 25 (2) , 199-208
Open AccessAnthropometric characteristics of Brazilian jiu-jitsu athletes and their relationship with anaerobic performance
Anaerobic metabolism is crucial to Brazilian jiu-jitsu athletes (BJJ), principally during the decisive moments of the match, to perform sweeps, throws, and ground techniques. However, little is known about the association between anthropometric variables with anaerobic performance. Objectives: To describe the peak power (PP) and mean power (MP) obtained in the Wingate test by BJJ athletes, to investigate the correlations between PP and MP and anthropometric variables, and to identify the anthropometric predictors of anaerobic performance. Methods: Twenty male BJJ athletes (aged: 22.9 ± 2.3 yrs, height: 1.75 ± 0.05 m, and body mass: 75.7 ± 10.3 kg) performed a 30 s Wingate test. Anthropometric variables, body mass (BM), fat free mass (FFM), muscle mass (MM), fat mass (FM), and percentage fat mass (%FM) were measured through electric bioimpedance. Results: Absolute mean values for PP and MP were 926 ± 154 and 665 ± 110 W, respectively, whereas relative values to BM were 12.2 ± 1.3 and 8.8 ± 0.9 W.kg-1, respectively. The mean FI value was 30.0 ± 4.7%. A significant and positive correlation was observed between PP and MP with all anthropometric variables (MM, FFM, %FM, FM). FFM was the best predictor of both PP (R2 = 0.69, p = .001) and MP (R2 = 0.67, p = 0.001) in the Wingate test. Conclusions: The results of this study demonstrated that FFM was the main anthropometric variable associated with anaerobic performance in BJJ athletes. Improving FFM may be a key strategy for enhancing anaerobic performance in this population.
- 2 October 2021
- Published by Taylor & Francis in Fatigue: Biomedicine, Health & Behavior
- Vol. 9 (4) , 175-188
Optimal load setting provides higher peak power and fatigue index with a similar mean power during 30-s Wingate anaerobic test in physically active men
Background: The Wingate test is usually conducted using resistance loads of 7.5, 8.5 or 8.7 g.kg−1 of body mass. However, these cycle ergometer resistance loads may be insufficient to enable maximal power values. As such, the use of individual optimal load selection (OPT) can positively influence other Wingate test parameters. Moreover, anthropometric parameters, e.g. body mass index, may also affect the OPT, but have not been well investigated. Aim: To investigate (i) individual OPT on the Wingate Test for peak power (PP), mean power outputs (MP), and the fatigue index (FI) and (ii) the association between OPT and anthropometric parameters. Methods: Fifteen physically active men (age = 26.4 ± 4.1 yr) performed six 30-s Wingate tests, with loads corresponding to 6.5%, 8.5%, 10.5% 11.5% 12.5%, and 13.5% of body mass to determine OPT (the load corresponding with the highest peak power), and also PP, MP, and FI. Results: Peak Power was 15% higher (pp=0.03) for the OPT method, whereas Mean Power values were similar between OPT and the 8.5% of body mass load. The 8.5% of body mass resistance load underestimates power outputs and is directly related to individual Peak Power (r=0.58, p=0.02). Furthermore, the load corresponding to OPT was inversely correlated to body mass index (r=−0.81, pr=−0.51, p=0.04). Conclusion: Optimal load selection is more appropriate than the use of 8.5% of body mass load to enable higher Peak power in the 30-s Wingate test in a physically active male population.
- 2 October 2021
- Published by Taylor & Francis in Fatigue: Biomedicine, Health & Behavior
- Vol. 9 (4) , 175-188
Optimal load setting provides higher peak power and fatigue index with a similar mean power during 30-s Wingate anaerobic test in physically active men
Background: The Wingate test is usually conducted using resistance loads of 7.5, 8.5 or 8.7 g.kg−1 of body mass. However, these cycle ergometer resistance loads may be insufficient to enable maximal power values. As such, the use of individual optimal load selection (OPT) can positively influence other Wingate test parameters. Moreover, anthropometric parameters, e.g. body mass index, may also affect the OPT, but have not been well investigated. Aim: To investigate (i) individual OPT on the Wingate Test for peak power (PP), mean power outputs (MP), and the fatigue index (FI) and (ii) the association between OPT and anthropometric parameters. Methods: Fifteen physically active men (age = 26.4 ± 4.1 yr) performed six 30-s Wingate tests, with loads corresponding to 6.5%, 8.5%, 10.5% 11.5% 12.5%, and 13.5% of body mass to determine OPT (the load corresponding with the highest peak power), and also PP, MP, and FI. Results: Peak Power was 15% higher (pp=0.03) for the OPT method, whereas Mean Power values were similar between OPT and the 8.5% of body mass load. The 8.5% of body mass resistance load underestimates power outputs and is directly related to individual Peak Power (r=0.58, p=0.02). Furthermore, the load corresponding to OPT was inversely correlated to body mass index (r=−0.81, pr=−0.51, p=0.04). Conclusion: Optimal load selection is more appropriate than the use of 8.5% of body mass load to enable higher Peak power in the 30-s Wingate test in a physically active male population.