Juan-Jesús Valdivia-Sánchez
Research Subjects
Research Interests
Juan-Jesús Valdivia-Sánchez has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Basilio Cano-Álvarez
CIFP “Virgen de Gracia”, 13500 Ciudad Real, Spain
1 shared publication - César García-Hernández
Design for Safety (D4S), I3A, University of Zaragoza, 50018 Zaragoza, Spain
1 shared publication - Francisco Valdivia-Calvo
CPIFP “Corona de Aragón”, 50009 Zaragoza, Spain
1 shared publication - José-Antonio Bueno-Pérez
IES “Jaume Huguet”, 43800 Tarragona, Spain
1 shared publication - José-Luis Huertas-Talón
University of Zaragoza
1 shared publication - Juan-José Garde-Barace
CPIFP “Corona de Aragón”, 50009 Zaragoza, Spain
1 shared publication
Latest Publications
- Open Access
- 25 October 2021
- Published by MDPI AG in Mathematics
- Vol. 9 (21) , 2701
Trochoidal Milling Path with Variable Feed. Application to the Machining of a Ti-6Al-4V Part
Trochoidal milling is a well-stablished machining strategy which still allows for the introduction of new approaches. This strategy can be applied to any kind of material, although it is usually associated to advanced materials, such as titanium and nickel alloys. This study is based on the adaptation of the feed speed of a milling tool with Ti-6Al-4V, so the chip width can be maintained constant without modifying the path geometry. A singularity in the experimental stage was to mill an Archimedes spiral groove instead of the conventional straight grooves. This made it possible to obtain a concave wall as well as a convex one and to optimize the amount of material used. The time efficiency compared to a constant feed, was slightly superior to 20%, reducing tool wear also. These techniques require milling machines with high mechanical and kinematic performance, as well as the absence of clearance between joints and a high acceleration capacity.
- 25 October 2021
- Published by MDPI AG in Mathematics
- Vol. 9 (21) , 2701
Open AccessTrochoidal Milling Path with Variable Feed. Application to the Machining of a Ti-6Al-4V Part
Trochoidal milling is a well-stablished machining strategy which still allows for the introduction of new approaches. This strategy can be applied to any kind of material, although it is usually associated to advanced materials, such as titanium and nickel alloys. This study is based on the adaptation of the feed speed of a milling tool with Ti-6Al-4V, so the chip width can be maintained constant without modifying the path geometry. A singularity in the experimental stage was to mill an Archimedes spiral groove instead of the conventional straight grooves. This made it possible to obtain a concave wall as well as a convex one and to optimize the amount of material used. The time efficiency compared to a constant feed, was slightly superior to 20%, reducing tool wear also. These techniques require milling machines with high mechanical and kinematic performance, as well as the absence of clearance between joints and a high acceleration capacity.