Ol’ga Alekseevna Koshkina
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ol’ga Alekseevna Koshkina has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Alexander Sergeevich Smolyanskii
L. Ya. Karpov Institute of Physical Chemistry
3 shared publications - Leonid Izraiilevich Trakhtenberg
N.N. Semenov Federal Research Center for Chemical Physics RAS, 4 Kosygin Street, Moscow 119991, Russia
3 shared publications - Lev Vladimirovich Moskvitin
High Energy Chemistry and Radioecology Department, D. Mendeleev University of Chemical Technology of Russia, Moscow 125047, Russia
3 shared publications - Mikhail Aleksandrovich Arsentyev
Technology Department, Quantum R LLC, Moscow 125319, Russia
3 shared publications - Sergei Vital’evich Slesarenko
Technology Department, Quantum R LLC, Moscow 125319, Russia
3 shared publications - Dmitrii Pavlovich Kiryukhin
Laboratory of Cryochemistry and Radiation Chemistry, The Institute of Problems of Chemical Physics, Russian Academy of Science, Chernogolovka 142400, Moscow, Russia
2 shared publications
Latest Publications
- Open Access
Thermoradiationally Modified Polytetrafluoroethylene as a Basis for Membrane Fabrication: Resistance to Hydrogen Penetration, the Effect of Ion Treatment on the Chemical Structure and Surface Morphology, Evaluation of the Track Radius
A study of the properties of thermoradiationally modified polytetrafluoroethylene and its importance for use as the basis of polymer membranes is presented. The hydrogen permeability of a TRM-PTFE film was studied in comparison with an original PTFE film, and showed a three-fold decrease in hydrogen permeability. Further, TRM-PTFE films were irradiated with accelerated Xe ions with an energy of 1 MeV with fluences from 1 × 108 to 1 × 1011. The changes induced by ion treatment were analyzed by infrared spectroscopy of disturbed total internal reflection (IR-ATR) and by atomic force microscopy (ASM). IR-ATR indicated the absence of destruction in the fluence range from 1 × 108 to 3 × 1010 cm−2 (in the area of isolated tracks) and the beginning of overlap of latent tracks on fluences from 3 × 1010 to 1 × 1011 cm−2. Topographic images with AFM showed layered lamellar structures that collapsed at a fluence of 108 cm−2. The destruction was accompanied by a decrease in roughness about seven times the size of the track core observed by the ASM method, fully corresponding to the value obtained on the basis of calculations using modeling in an SRIM program.
Open AccessThermoradiationally Modified Polytetrafluoroethylene as a Basis for Membrane Fabrication: Resistance to Hydrogen Penetration, the Effect of Ion Treatment on the Chemical Structure and Surface Morphology, Evaluation of the Track Radius
A study of the properties of thermoradiationally modified polytetrafluoroethylene and its importance for use as the basis of polymer membranes is presented. The hydrogen permeability of a TRM-PTFE film was studied in comparison with an original PTFE film, and showed a three-fold decrease in hydrogen permeability. Further, TRM-PTFE films were irradiated with accelerated Xe ions with an energy of 1 MeV with fluences from 1 × 108 to 1 × 1011. The changes induced by ion treatment were analyzed by infrared spectroscopy of disturbed total internal reflection (IR-ATR) and by atomic force microscopy (ASM). IR-ATR indicated the absence of destruction in the fluence range from 1 × 108 to 3 × 1010 cm−2 (in the area of isolated tracks) and the beginning of overlap of latent tracks on fluences from 3 × 1010 to 1 × 1011 cm−2. Topographic images with AFM showed layered lamellar structures that collapsed at a fluence of 108 cm−2. The destruction was accompanied by a decrease in roughness about seven times the size of the track core observed by the ASM method, fully corresponding to the value obtained on the basis of calculations using modeling in an SRIM program.
- Open Access
Structure of Polytetrafluoroethylene Modified by the Combined Action of γ-Radiation and High Temperatures
By means of X-ray computed microtomography (XCMT), the existence of a developed porous structure with an average pore diameter of ~3.5 μm and pore content of ~1.1 vol.% has been revealed in unirradiated polytetrafluoroethylene (PTFE). It has been found that the combined action of gamma radiation (absorbed dose per PTFE of ~170 kGy) and high temperatures (327–350 °C) leads to the disappearance of the porous structure and the formation of several large pores with sizes from 30 to 50 μm in the bulk of thermal-radiation modified PTFE (TRM-PTFE). It has been established by X-ray diffraction (XRD) analysis that the thermal-radiation modification of PTFE leads to an increase in the interplanar spacings, the degree of crystallinity and the volume of the unit cell, as well as to a decrease in the size of crystals and the X-ray density of the crystalline phase in comparison with the initial polymer. It is assumed that the previously-established effect of improving the deformation-strength and tribological properties of the TRM-PTFE can be due not only to the radiation cross-linking of polymer chains but also to the disappearance of the pore system and to the ordering of the crystalline phase of PTFE.
Open AccessStructure of Polytetrafluoroethylene Modified by the Combined Action of γ-Radiation and High Temperatures
By means of X-ray computed microtomography (XCMT), the existence of a developed porous structure with an average pore diameter of ~3.5 μm and pore content of ~1.1 vol.% has been revealed in unirradiated polytetrafluoroethylene (PTFE). It has been found that the combined action of gamma radiation (absorbed dose per PTFE of ~170 kGy) and high temperatures (327–350 °C) leads to the disappearance of the porous structure and the formation of several large pores with sizes from 30 to 50 μm in the bulk of thermal-radiation modified PTFE (TRM-PTFE). It has been established by X-ray diffraction (XRD) analysis that the thermal-radiation modification of PTFE leads to an increase in the interplanar spacings, the degree of crystallinity and the volume of the unit cell, as well as to a decrease in the size of crystals and the X-ray density of the crystalline phase in comparison with the initial polymer. It is assumed that the previously-established effect of improving the deformation-strength and tribological properties of the TRM-PTFE can be due not only to the radiation cross-linking of polymer chains but also to the disappearance of the pore system and to the ordering of the crystalline phase of PTFE.
- Open Access
- 20 September 2021
- Published by MDPI AG in Preprints.org
Structure of polytetrafluoroethylene modified by the combined action of γ-radiation and high temperatures
By means of X-ray computed microtomography (XCMT) the existence of a developed microporous structure having an average pore diameter of ~3.5 μm and pore content of ~1.1 vol.% has been revealed in unirradiated polytetrafluoroethylene (PTFE). It has been found that the combined action of gamma radiation (absorbed dose per PTFE of ~170 kGy) and high temperatures (327-350 °C) leads to the disappearance of the microporous structure and the formation of several large pores with sizes from 30 to 50 μm in the bulk of thermal-radiation modified PTFE (TRM-PTFE). It has been established by X-ray diffraction (XRD) analysis that the thermal-radiation modification of PTFE leads to an increase in the interplanar spacings, the degree of crystallinity and volume of the unit cell, as well as to a decrease in the size of crystals and the X-ray density of the crystalline phase in comparison with the initial polymer. It is assumed that the previously established effect of improving the deformation-strength and tribological properties of the TRM-PTFE can be due not only to the radiation cross-linking of polymer chains but also to the disappearance of the micropore system and to the ordering of the crystalline phase of PTFE.
- 20 September 2021
- Published by MDPI AG in Preprints.org
Open AccessStructure of polytetrafluoroethylene modified by the combined action of γ-radiation and high temperatures
By means of X-ray computed microtomography (XCMT) the existence of a developed microporous structure having an average pore diameter of ~3.5 μm and pore content of ~1.1 vol.% has been revealed in unirradiated polytetrafluoroethylene (PTFE). It has been found that the combined action of gamma radiation (absorbed dose per PTFE of ~170 kGy) and high temperatures (327-350 °C) leads to the disappearance of the microporous structure and the formation of several large pores with sizes from 30 to 50 μm in the bulk of thermal-radiation modified PTFE (TRM-PTFE). It has been established by X-ray diffraction (XRD) analysis that the thermal-radiation modification of PTFE leads to an increase in the interplanar spacings, the degree of crystallinity and volume of the unit cell, as well as to a decrease in the size of crystals and the X-ray density of the crystalline phase in comparison with the initial polymer. It is assumed that the previously established effect of improving the deformation-strength and tribological properties of the TRM-PTFE can be due not only to the radiation cross-linking of polymer chains but also to the disappearance of the micropore system and to the ordering of the crystalline phase of PTFE.