Yu Mao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yu Mao has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Guoming Wu
Jiamusi Forestry and Grassland Administration, Jiamusi 154000, China
2 shared publications - Opelele Omeno Michel
Faculté des Sciences Agronomiques et Environnement. Mention Gestion des Ressources Naturelles Renouvelables Université de Kinshasa BP 117 Kinshasa XI (RDC
2 shared publications - Wenyi Fan
Key Laboratory of Sustainable Forest Ecosystem Management—Ministry of Education, School of Forestry, Northeast Forestry University, Harbin 150040, China
2 shared publications - Zhihui Liu
International Institute for Earth System Science, Nanjing University, Nanjing 210023, China
2 shared publications - Ao Sui
Key Laboratory of Sustainable Forest Ecosystem Management-Ministry of Education, School of Forestry, Northeast Forestry University, Harbin 150040, China
1 shared publication - Yifan Hu
Key Laboratory of Sustainable Forest Ecosystem Management—Ministry of Education, School of Forestry, Northeast Forestry University, Harbin 150040, China
1 shared publication
Latest Publications
- Open Access
- 30 January 2022
- Published by MDPI AG in Remote Sensing
- Vol. 14 (3) , 669
The Potential of Fully Polarized ALOS-2 Data for Estimating Forest Above-Ground Biomass
SAR data have a longer wavelength and stronger penetrating power compared with traditional optical remote sensing. Therefore, SAR data are more suitable for the estimation of the above-ground biomass (AGB) of forests. This study was aimed at evaluating the sensitivity of L-band full polarization data to AGB. L-band data were improved to estimate the saturation point produced by AGB, and were found to be suitable for estimating a wide range of AGB. This study extracted backscattering coefficients, polarization decomposition variables, and terrain factors. New parameters were constructed from these variables, and their performance in predicting AGB was evaluated. Significant variables found with AGB were added to the multivariate linear model. A statistical analysis showed the presence of multicollinearity between the variables. Therefore, ridge regression, random forest method (RF), and principal component analysis (PCA) were introduced to solve the problem of collinearity. In all the three methods, the saturation of the ridge regression model was low, reaching it at 150 t/ha. Better accuracy was obtained with the RF model. No obvious saturation incident was detected in the model established using the principal component analysis. This could be attributed to the low biomass levels observed in our study area. This model provided accurate results (adjusted r2 = 0.90 rmse = 14.24 t/ha), indicating that L-band data have the potential to estimate AGB. Additionally, suitable variables and models were selected in this study, with the principal component analysis being more helpful in combining various SAR parameters. The achievement of these accurate results could be attributed to the synergy among variables.
- 30 January 2022
- Published by MDPI AG in Remote Sensing
- Vol. 14 (3) , 669
Open AccessThe Potential of Fully Polarized ALOS-2 Data for Estimating Forest Above-Ground Biomass
SAR data have a longer wavelength and stronger penetrating power compared with traditional optical remote sensing. Therefore, SAR data are more suitable for the estimation of the above-ground biomass (AGB) of forests. This study was aimed at evaluating the sensitivity of L-band full polarization data to AGB. L-band data were improved to estimate the saturation point produced by AGB, and were found to be suitable for estimating a wide range of AGB. This study extracted backscattering coefficients, polarization decomposition variables, and terrain factors. New parameters were constructed from these variables, and their performance in predicting AGB was evaluated. Significant variables found with AGB were added to the multivariate linear model. A statistical analysis showed the presence of multicollinearity between the variables. Therefore, ridge regression, random forest method (RF), and principal component analysis (PCA) were introduced to solve the problem of collinearity. In all the three methods, the saturation of the ridge regression model was low, reaching it at 150 t/ha. Better accuracy was obtained with the RF model. No obvious saturation incident was detected in the model established using the principal component analysis. This could be attributed to the low biomass levels observed in our study area. This model provided accurate results (adjusted r2 = 0.90 rmse = 14.24 t/ha), indicating that L-band data have the potential to estimate AGB. Additionally, suitable variables and models were selected in this study, with the principal component analysis being more helpful in combining various SAR parameters. The achievement of these accurate results could be attributed to the synergy among variables.
- Open Access
- 26 October 2021
- Published by MDPI AG in Remote Sensing
- Vol. 13 (21) , 4306
Retrieval of Boreal Forest Heights Using an Improved Random Volume over Ground (RVoG) Model Based on Repeat-Pass Spaceborne Polarimetric SAR Interferometry: The Case Study of Saihanba, China
Spaceborne polarimetric synthetic aperture radar interferometry (PolInSAR) has the potential to deal with large-scale forest height inversion. However, the inversion is influenced by strong temporal decorrelation interference resulting from a large temporal baseline. Additionally, the forest canopy induces phase errors, while the smaller vertical wavenumber () enhances the sensitivity of the inversion to temporal decorrelation, which limits the efficiency in forest height inversion. This research is based on the random volume over ground (RVoG) model and follows the assumptions of the three-stage inversion method, to quantify the impact of repeat-pass spaceborne PolInSAR temporal decorrelation on the relative error of retrieval height, and develop a semi-empirical improved inversion model, using ground data to eliminate the interference of coherence and phase error caused by temporal decorrelation. Forest height inversion for temperate forest in northern China was conducted using repeat-pass spaceborne L-band ALOS2 PALSAR data, and was further verified using ground measurement data. The correction of temporal decorrelation using the improved model provided robust inversion for mixed conifer-broad forest height retrieval as it addressed the over-sensitivity to temporal decorrelation resulting from the inappropriate value. The method performed height inversion using interferometric data with temporal baselines ranging from 14 to 70 days and vertical wavenumbers ranging from 0.015 to 0.021 rad/m. The R2 and RMSE reached 0.8126 and 2.3125 m, respectively.- 26 October 2021
- Published by MDPI AG in Remote Sensing
- Vol. 13 (21) , 4306
Open AccessRetrieval of Boreal Forest Heights Using an Improved Random Volume over Ground (RVoG) Model Based on Repeat-Pass Spaceborne Polarimetric SAR Interferometry: The Case Study of Saihanba, China
Spaceborne polarimetric synthetic aperture radar interferometry (PolInSAR) has the potential to deal with large-scale forest height inversion. However, the inversion is influenced by strong temporal decorrelation interference resulting from a large temporal baseline. Additionally, the forest canopy induces phase errors, while the smaller vertical wavenumber () enhances the sensitivity of the inversion to temporal decorrelation, which limits the efficiency in forest height inversion. This research is based on the random volume over ground (RVoG) model and follows the assumptions of the three-stage inversion method, to quantify the impact of repeat-pass spaceborne PolInSAR temporal decorrelation on the relative error of retrieval height, and develop a semi-empirical improved inversion model, using ground data to eliminate the interference of coherence and phase error caused by temporal decorrelation. Forest height inversion for temperate forest in northern China was conducted using repeat-pass spaceborne L-band ALOS2 PALSAR data, and was further verified using ground measurement data. The correction of temporal decorrelation using the improved model provided robust inversion for mixed conifer-broad forest height retrieval as it addressed the over-sensitivity to temporal decorrelation resulting from the inappropriate value. The method performed height inversion using interferometric data with temporal baselines ranging from 14 to 70 days and vertical wavenumbers ranging from 0.015 to 0.021 rad/m. The R2 and RMSE reached 0.8126 and 2.3125 m, respectively.