Taís Arriero Shinma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Taís Arriero Shinma has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Marcus Vinícius Galbetti
Faculty of Environmental Engineer, Mato Grosso do Sul State University, Dourados 79804-970, MS, Brazil
4 shared publications - Antonio Carlos Zuffo
School of Civil Engineering, Architecture and Urban Design, State University of Campinas, Campinas, Sao Paulo, Brazil
2 shared publications - Monzur Alam Imteaz
Department of Civil and Construction Engineering Swinburne University of Technology Hawthorn Victoria Australia
2 shared publications - Vassiliki Terezinha Galvão Boulomytis
Federal Institute of Science, Education and Technology of Sao Paulo (IFSP)
2 shared publications - Alessandra Querino da Silva
Faculty of Exact Sciences and Technology Federal University of Grande Dourados Dourados Mato Grosso do Sul Brazil
1 shared publication - Carlos Antonio Costa dos Santos
Academic Unit of Atmospheric Sciences, Federal University of Campina Grande, Campina Grande, Brazil
1 shared publication
Latest Publications
- Open Access
- 1 September 2022
- Published by FapUNIFESP (SciELO) in Revista Brasileira de Meteorologia
- Vol. 37 (3) , 373-383
Modelagem Espacial de Chuvas Intensas no Estado da Paraíba
Resumo O Nordeste Brasileiro (NEB) apresenta, como característica marcante, a irregularidade em acumulados de precipitações, o que é decorrência de vários fatores, tais como as características ambientais e de sistemas atmosféricos. Análises estatísticas adequadas são necessárias para ter conhecimento dos níveis de retorno da precipitação em uma região e são muito importantes para auxiliar ações para prevenção de desastres naturais causados por chuvas máximas. O objetivo dessa pesquisa consistiu em apresentar os níveis de retorno da precipitação máxima diária (PMD) em todo o estado da Paraíba, o qual está localizado na NEB. O conjunto de dados foi composto por 238 estações pluviométricas, abrangendo o período de 1994 a 2020. Para a modelagem estatística foi ajustada a distribuição Gumbel, por meio do método da máxima verossimilhança. Os resultados indicaram que o Sertão Paraibano apresentou as maiores estimadas da PMD nos meses de janeiro a março, com volumes superiores a 75 mm. A Mata Paraibana apresentou as maiores estimativas da PMD nos meses de abril a junho, com valores superiores a 125 mm no mês de junho em regiões litorâneas. As informações obtidas sobre os níveis de retorno da PMD são relevantes e podem ser de grande auxílio na implementação de políticas públicas, visando a diminuição dos impactos causados pelas chuvas intensas.
- 1 September 2022
- Published by FapUNIFESP (SciELO) in Revista Brasileira de Meteorologia
- Vol. 37 (3) , 373-383
Open AccessModelagem Espacial de Chuvas Intensas no Estado da Paraíba
Resumo O Nordeste Brasileiro (NEB) apresenta, como característica marcante, a irregularidade em acumulados de precipitações, o que é decorrência de vários fatores, tais como as características ambientais e de sistemas atmosféricos. Análises estatísticas adequadas são necessárias para ter conhecimento dos níveis de retorno da precipitação em uma região e são muito importantes para auxiliar ações para prevenção de desastres naturais causados por chuvas máximas. O objetivo dessa pesquisa consistiu em apresentar os níveis de retorno da precipitação máxima diária (PMD) em todo o estado da Paraíba, o qual está localizado na NEB. O conjunto de dados foi composto por 238 estações pluviométricas, abrangendo o período de 1994 a 2020. Para a modelagem estatística foi ajustada a distribuição Gumbel, por meio do método da máxima verossimilhança. Os resultados indicaram que o Sertão Paraibano apresentou as maiores estimadas da PMD nos meses de janeiro a março, com volumes superiores a 75 mm. A Mata Paraibana apresentou as maiores estimativas da PMD nos meses de abril a junho, com valores superiores a 125 mm no mês de junho em regiões litorâneas. As informações obtidas sobre os níveis de retorno da PMD são relevantes e podem ser de grande auxílio na implementação de políticas públicas, visando a diminuição dos impactos causados pelas chuvas intensas.
- Open Access
- 9 March 2022
- Published by IWA Publishing in Water Policy
- Vol. 24 (4) , 626-644
Evaluating the effectiveness of the Water Resources Master Plan in Campinas, Brazil
From 2013 to 2015, the Brazilian southeast region experienced the most severe and intense drought recorded, the Water Crisis. This outstanding drought led the government to make efforts toward an adequate water resources management. In Campinas, the third most populous city of the State of São Paulo, the government proposed the Campinas Water Resources Master Plan (CWRMP), the main objective of which was to ensure the quantity and quality of water, reducing water vulnerability in the municipality. In this study, we evaluated the effectiveness of this plan through the major guidelines into four actions: (1) increase the permeability rate and the soil infiltration capacity, (2) increase the vegetation cover, (3) improve the sanitation services, and (4) minimize the number of contaminated areas. For Actions 1 and 2, we inferred that the aforementioned parameters have increased after the CWRMP enactment. About the Action 3, we found that Campinas has historically provided good sanitation services to the population, regardless of the CWRMP promulgation. However, more improvements should be given to waste collection and recycling services. The underground water consumption also has to be regulated, as significant exploitation has no legal permit. Finally, considering Action 4, the number of contaminated areas was reduced in the available data period. Therefore, the CWRMP was considered a valuable initiative to support an integrated and sustainable use of water, improving the water resources management in Campinas.
- 9 March 2022
- Published by IWA Publishing in Water Policy
- Vol. 24 (4) , 626-644
Open AccessEvaluating the effectiveness of the Water Resources Master Plan in Campinas, Brazil
From 2013 to 2015, the Brazilian southeast region experienced the most severe and intense drought recorded, the Water Crisis. This outstanding drought led the government to make efforts toward an adequate water resources management. In Campinas, the third most populous city of the State of São Paulo, the government proposed the Campinas Water Resources Master Plan (CWRMP), the main objective of which was to ensure the quantity and quality of water, reducing water vulnerability in the municipality. In this study, we evaluated the effectiveness of this plan through the major guidelines into four actions: (1) increase the permeability rate and the soil infiltration capacity, (2) increase the vegetation cover, (3) improve the sanitation services, and (4) minimize the number of contaminated areas. For Actions 1 and 2, we inferred that the aforementioned parameters have increased after the CWRMP enactment. About the Action 3, we found that Campinas has historically provided good sanitation services to the population, regardless of the CWRMP promulgation. However, more improvements should be given to waste collection and recycling services. The underground water consumption also has to be regulated, as significant exploitation has no legal permit. Finally, considering Action 4, the number of contaminated areas was reduced in the available data period. Therefore, the CWRMP was considered a valuable initiative to support an integrated and sustainable use of water, improving the water resources management in Campinas.
- 1 January 2022
- Published by Universidade Estadual de Ponta Grossa (UEPG) in Terr@ Plural
- Vol. 16, 1-12
AltBlock - Design Storms Software
A design storm can be defined as a precipitation pattern used to determine indirectly the design flood, which is an important data in many hydrologic design projects. Due to difficult to obtain historical data on precipitation, it has become common to construct design storms using general characteristics of precipitation in the surrounding region, represented by intensity-duration-frequency (IDF) relationships. In addition, it’s also necessary specify design return period, storm duration and the temporal distribution. For this purpose, is used the Alternating Block Method. In the view of software development applied to hydrology and to make more practical using this Alternating Block Method, this article intended to develop the AltBlock, a software able to calculate design storms automatically. Using Visual Studio .NET and the programming language Visual Studio .NET it was sought to build a graphical user-friendly interface. The AltBlock is applicable to any location and it’s useful for educational uses, engineering projects and hydrological studies.
- 1 January 2022
- Published by Universidade Estadual de Ponta Grossa (UEPG) in Terr@ Plural
- Vol. 16, 1-12
AltBlock - Design Storms Software
A design storm can be defined as a precipitation pattern used to determine indirectly the design flood, which is an important data in many hydrologic design projects. Due to difficult to obtain historical data on precipitation, it has become common to construct design storms using general characteristics of precipitation in the surrounding region, represented by intensity-duration-frequency (IDF) relationships. In addition, it’s also necessary specify design return period, storm duration and the temporal distribution. For this purpose, is used the Alternating Block Method. In the view of software development applied to hydrology and to make more practical using this Alternating Block Method, this article intended to develop the AltBlock, a software able to calculate design storms automatically. Using Visual Studio .NET and the programming language Visual Studio .NET it was sought to build a graphical user-friendly interface. The AltBlock is applicable to any location and it’s useful for educational uses, engineering projects and hydrological studies.
- 25 October 2021
- Published by Taylor & Francis in Urban Water Journal
- Vol. 19 (3) , 244-255
Evaluation of the tabulated, NEH4, least squares and asymptotic fitting methods for the CN estimation of urban watersheds
The Soil Conservation Service Curve Number (SCS-CN) model is widely used to estimate the watershed runoff. However, the model may result in inaccurate estimations when assuming a tabulated CN value and an initial abstraction (λ) of 0.20. Therefore, in this paper, we evaluated the suitability of four CN estimation methods for an urban watershed: Tabulated CN, National Engineering Handbook 4, Least Squares and Asymptotic Fitting. Also, the effect of ordering the data and different λ values (0.20 or 0.05) were analyzed. Our findings suggest that the transient approach of Asymptotic Fitting method, a variance from the original Asymptotic Fitting method, provides the best runoff estimations using rank ordered data and λ equal to 0.05 (R2 = 0.79, PBIAS = 0.01% and NSE = 0.78). It is to be noted that similar results were also obtained through a simple linear model.
- 25 October 2021
- Published by Taylor & Francis in Urban Water Journal
- Vol. 19 (3) , 244-255
Evaluation of the tabulated, NEH4, least squares and asymptotic fitting methods for the CN estimation of urban watersheds
The Soil Conservation Service Curve Number (SCS-CN) model is widely used to estimate the watershed runoff. However, the model may result in inaccurate estimations when assuming a tabulated CN value and an initial abstraction (λ) of 0.20. Therefore, in this paper, we evaluated the suitability of four CN estimation methods for an urban watershed: Tabulated CN, National Engineering Handbook 4, Least Squares and Asymptotic Fitting. Also, the effect of ordering the data and different λ values (0.20 or 0.05) were analyzed. Our findings suggest that the transient approach of Asymptotic Fitting method, a variance from the original Asymptotic Fitting method, provides the best runoff estimations using rank ordered data and λ equal to 0.05 (R2 = 0.79, PBIAS = 0.01% and NSE = 0.78). It is to be noted that similar results were also obtained through a simple linear model.