JLJiarun Li

Jiarun Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jiarun Li has a total of 3 co-authors. Here are the top co-authors by number of shared publications:

  • Ping Zhou

    State Key Laboratory of High-Performance Precision Manufacturing, Department of Mechanical Engineering, Dalian University of Technology, Dalian, China

    1 shared publication
  • Qiuyu Liu

    Key Laboratory for Precision and Non-traditional Machining Technology of Ministry of Education, Dalian University of Technology, Dalian 116024, China

    1 shared publication
  • Ying Yan

    State Key Laboratory of High-Performance Precision Manufacturing, Dalian University of Technology, Dalian 116024, China

    1 shared publication

Latest Publications

  • Open Access

    Evaporation Effect on Thickness Distribution for Spin-Coated Films on Rectangular and Circular Substrates

    by Ying Yan, Jiarun Li, Qiuyu Liu, Ping Zhou

    Spin-coating is widely applied in the field of thin-film fabrication due to its simplicity and high film uniformity. To prepare thin films on rectangular substrates by spin-coating, the simulation and experimental methods were used to study the characteristics of the film thickness in this work. The two-phase flow simulations of spin-coating on a rectangular substrate and circular substrate were carried out with the volume of fluid (VOF) method. The simulation results showed that the airflow field and the substrate geometry had little effect on the evolution of spin-coated film thickness. However, in the experimental results, there was a significant difference in the thickness of the spin-coated film on the rectangular substrate and the circular substrate. According to further study, the solvent evaporation that was neglected in the simulation was the dominant factor of the differences. In addition, it was concluded that the non-uniform evaporation caused by the surface tension and edge accumulation in the later spin-coating stage was the main reason for the film accumulation of the windward area on the rectangular substrate. This work is useful to obtain a deeper understanding of the thin-film formation mechanism of spin-coating.