Siyu Ji
Siyu Ji has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Chengwang Lei
School of Civil Engineering, The University of Sydney, NSW, 2006, Australia
2 shared publications - Quang Duy Nguyen
University of Sydney
2 shared publications - Chenglin Wen
Guangdong Provincial Key Laboratory of Petrochemical Equipment Fault Diagnosis, Guangdong University of Petrochemical Technology, Maoming, China
1 shared publication - Leijiao Ge
School of Electrical and Information Engineering, Tianjin University, Tianjin, China
1 shared publication - Renhai Feng
Xinjiang Normal University
1 shared publication - Wanqi Yuan
School of Electrical and Information Engineering, Tianjin University, Tianjin, China
1 shared publication
Latest Publications
- Open Access
- 13 February 2025
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 212
A numerical study of blockage and inclination effects on natural convection in a uniformly heated air flow channel
- 13 February 2025
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 212
Open AccessA numerical study of blockage and inclination effects on natural convection in a uniformly heated air flow channel
- Open Access
- 1 March 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (3)
A numerical study of natural convection through a vertical heated channel with a confined circular cylinder
This study examines thermal flow structures and heat transfer through a vertical heated channel with an adiabatic circular cylinder symmetrically positioned between lateral walls. A two-dimensional numerical simulation is conducted covering a range of parameters including Rayleigh numbers Ra = 8.9 × 106–8.9 × 108, cylinder positions relative to the channel height h = 0–0.50, and blockage ratios (the ratio of cylinder diameter to channel width) β = 0.25–0.75. Three distinct flow regimes are observed at different Rayleigh numbers and blockage ratios, including steady symmetric, unsteady periodic, and unsteady asymmetric flow regimes. The steady symmetric and unsteady periodic flows are observed at all blockage ratios, while the unsteady asymmetric flow is only observed at the highest blockage ratio of β = 0.75 for Rayleigh numbers above 8.9 × 107. It is found that the presence of the cylinder significantly enhances mixing and turbulence in the channel, which in turn enhances heat transfer through the channel. A 64.3% enhancement of heat transfer is achieved at β = 0.50 and h = 0.05 for Ra = 8.9 × 108.
- 1 March 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (3)
Open AccessA numerical study of natural convection through a vertical heated channel with a confined circular cylinder
This study examines thermal flow structures and heat transfer through a vertical heated channel with an adiabatic circular cylinder symmetrically positioned between lateral walls. A two-dimensional numerical simulation is conducted covering a range of parameters including Rayleigh numbers Ra = 8.9 × 106–8.9 × 108, cylinder positions relative to the channel height h = 0–0.50, and blockage ratios (the ratio of cylinder diameter to channel width) β = 0.25–0.75. Three distinct flow regimes are observed at different Rayleigh numbers and blockage ratios, including steady symmetric, unsteady periodic, and unsteady asymmetric flow regimes. The steady symmetric and unsteady periodic flows are observed at all blockage ratios, while the unsteady asymmetric flow is only observed at the highest blockage ratio of β = 0.75 for Rayleigh numbers above 8.9 × 107. It is found that the presence of the cylinder significantly enhances mixing and turbulence in the channel, which in turn enhances heat transfer through the channel. A 64.3% enhancement of heat transfer is achieved at β = 0.50 and h = 0.05 for Ra = 8.9 × 108.
- 1 October 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 70 (00189456) , 1-12
Nonintrusive Load Disaggregation for Residential Users Based on Alternating Optimization and Downsampling
With the continuous development of the smart grid, details of residential users’ electricity consumption have received lots of attention. In recent years, a new concept of nonintrusive load monitoring (NILM) based on graph signal processing (NILM-GSP) has been proposed. NILM allows researchers to access the electricity consumption profile of every household appliance (AP) online, which greatly reduced the cost of grid operation. This article proposes a new NILM based on alternating optimization (NILM-AO) to solve the load disaggregation problem. Since the power consumption of residential users is basically stable in its operation cycle, a power consumption constraint is constructed to make NILM realistic. In order to improve real-time processing capability, we propose a statistical downsampling method (NILM-AODM) to find the optimal sampling rate. Simulation results show that NILM-AO is more accurate than NILM-GSP, and the sampling rate of NILM-AODM is also smaller than that of NILM-AO, which leads to less communication load and time delay.
- 1 October 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 70 (00189456) , 1-12
Nonintrusive Load Disaggregation for Residential Users Based on Alternating Optimization and Downsampling
With the continuous development of the smart grid, details of residential users’ electricity consumption have received lots of attention. In recent years, a new concept of nonintrusive load monitoring (NILM) based on graph signal processing (NILM-GSP) has been proposed. NILM allows researchers to access the electricity consumption profile of every household appliance (AP) online, which greatly reduced the cost of grid operation. This article proposes a new NILM based on alternating optimization (NILM-AO) to solve the load disaggregation problem. Since the power consumption of residential users is basically stable in its operation cycle, a power consumption constraint is constructed to make NILM realistic. In order to improve real-time processing capability, we propose a statistical downsampling method (NILM-AODM) to find the optimal sampling rate. Simulation results show that NILM-AO is more accurate than NILM-GSP, and the sampling rate of NILM-AODM is also smaller than that of NILM-AO, which leads to less communication load and time delay.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 6898-6901
An optimized scheduling strategy for smart home users under the limitation of daily electric charge
Smart home is an important symbol of smart grid electricity. Combing with the properties of household appliances, smart home appliance scheduling is based on the user-side and has different schedules in several periods for diverse equipment. Firstly, in this paper different household appliances are scheduled according to various prices in different periods, so that the daily electricity charge is limited to a certain range; also, numerous consumption plans can be developed in electricity charge. Then, based on the consumption plan, the simulated annealing algorithm is used to find out the solution and meanwhile computer simulations are performed. At last, the simulation results are analyzed. The results of the experiment show the accuracy of the model which can be very good for home appliances scheduling scheme, for the reason users could achieve the purpose of reducing the cost of electricity in the way of rational distribution of electricity.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 6898-6901
An optimized scheduling strategy for smart home users under the limitation of daily electric charge
Smart home is an important symbol of smart grid electricity. Combing with the properties of household appliances, smart home appliance scheduling is based on the user-side and has different schedules in several periods for diverse equipment. Firstly, in this paper different household appliances are scheduled according to various prices in different periods, so that the daily electricity charge is limited to a certain range; also, numerous consumption plans can be developed in electricity charge. Then, based on the consumption plan, the simulated annealing algorithm is used to find out the solution and meanwhile computer simulations are performed. At last, the simulation results are analyzed. The results of the experiment show the accuracy of the model which can be very good for home appliances scheduling scheme, for the reason users could achieve the purpose of reducing the cost of electricity in the way of rational distribution of electricity.