Hisataka Yoshida
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hisataka Yoshida has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Yoshitaka Kuno
Research Center of Nuclear Physics, Osaka University , 10-1 Mihogaoka, Ibaraki, Osaka 565-0871
2 shared publications - Akira Sato
Osaka University
1 shared publication - Chen Wu
Institute of High Energy Physics, Chinese Academy of Sciences (CAS), Beijing, China
1 shared publication H. Sakamoto
1 shared publicationH.-B. Li
1 shared publication- Han Miao
Institute of High Energy Physics
1 shared publication
Latest Publications
- Open Access
- 30 September 2024
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1069
Design and construction of the cylindrical drift chamber for the COMET Phase-I experiment
- 30 September 2024
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1069
Open AccessDesign and construction of the cylindrical drift chamber for the COMET Phase-I experiment
- 28 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 68 (8) , 2028-2034
An FPGA-Based Trigger System With Online Track Recognition in COMET Phase-I
A field programmable gate array (FPGA)-based online trigger system has been developed for the COherent Muon To Electron Transition (COMET) Phase-I experiment, which searches for muon-to-electron conversion as a signature of New Physics beyond the Standard Model. A drift chamber and trigger counters are devised to detect a mono-energetic electron from the conversion process in a 1-T solenoidal magnetic field. A highly intense muon source enables reaching unprecedented experimental sensitivity, however, it also generates undesirable background particles which increase the trigger rate to a much higher level than the capability of the data acquisition (DAQ) system. By using hit information from the drift chamber in addition to the trigger counter, the newly proposed online trigger system efficiently suppresses the background trigger rate while keeping the signal-event acceptance large. A characteristic of this system is the utilization of machine learning (ML) techniques for optimizing lookup tables (LUTs) implemented in hardware. Simulation studies show that the signal-event acceptance of the online trigger is 96% while the background trigger rate is reduced from 91 to 13 kHz. The global trigger system and trigger electronics that construct a distributed trigger architecture were built. The total trigger latency was estimated to be 3.2 μs. The trigger system test was carried out by using a part of the drift-chamber readout region.
- 28 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 68 (8) , 2028-2034
An FPGA-Based Trigger System With Online Track Recognition in COMET Phase-I
A field programmable gate array (FPGA)-based online trigger system has been developed for the COherent Muon To Electron Transition (COMET) Phase-I experiment, which searches for muon-to-electron conversion as a signature of New Physics beyond the Standard Model. A drift chamber and trigger counters are devised to detect a mono-energetic electron from the conversion process in a 1-T solenoidal magnetic field. A highly intense muon source enables reaching unprecedented experimental sensitivity, however, it also generates undesirable background particles which increase the trigger rate to a much higher level than the capability of the data acquisition (DAQ) system. By using hit information from the drift chamber in addition to the trigger counter, the newly proposed online trigger system efficiently suppresses the background trigger rate while keeping the signal-event acceptance large. A characteristic of this system is the utilization of machine learning (ML) techniques for optimizing lookup tables (LUTs) implemented in hardware. Simulation studies show that the signal-event acceptance of the online trigger is 96% while the background trigger rate is reduced from 91 to 13 kHz. The global trigger system and trigger electronics that construct a distributed trigger architecture were built. The total trigger latency was estimated to be 3.2 μs. The trigger system test was carried out by using a part of the drift-chamber readout region.