Abu Bashar Mohammad Hamidul Islam has a total of 16 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Stress-induced efficiency degradation mechanism of InGaN-based red micro-LEDs depending on their size

    by Abu Bashar Mohammad Hamidul Islam, Hyeondong Lee, Tae Kyoung Kim, Dong-Min Jeon, Ji Hyung Moon, June-O Song, Dong-Soo Shin, Jong-In Shim, Dong-Pyo Han, Joon Seop Kwak

    This study systematically investigates the influence of forward current-induced stress on the optoelectronic performance of InGaN/GaN-based red micro light-emitting diodes with pixel sizes of 20 × 20 and 40 × 40 μm2. A constant forward current density of 3 A/cm2 was applied for 420 min. After aging, the 20-μm device exhibits a pronounced reduction in external quantum efficiency (EQE) by 43.2%, whereas the 40-μm device showed only a 16.5% decrease. Micro-photoluminescence mapping reveals that point defect formation near the mesa sidewalls is more prominent in the smaller device. Moreover, the degradation of peak emission intensity was more severe near the sidewall than in the center region after aging, which is more significant in the 20-μm device. This degradation is attributed to carrier tunneling through defect states generated during prolonged operation. Consequently, the pronounced EQE degradation observed in smaller devices is primarily ascribed to defect-assisted carrier tunneling. Additionally, this study elucidates the origin of the shorter peak emission wavelength observed near the mesa sidewall compared to that at the center region, which arises from strain relaxation.


  • Improved Optoelectronic Performance of InGaN/AlGaN Near-Ultraviolet LEDs: Effect of n-GaN Thickness

    by Abu Bashar Mohammad Hamidul Islam, Dong-Soo Shin, Joon Seop Kwak, Jong-In Shim

    This study systematically investigates the impact of n-GaN layer thickness on the optoelectronic performance of InGaN/AlGaN-based near-ultraviolet (NUV) light-emitting diodes (LEDs). A comparative analysis is performed between a reference LED and a sample with doubled n-GaN layer thickness. The n-GaN thicknesses considered are 30 and 60 nm beneath the superlattice (SL) layers for reference and thicker n-GaN samples, respectively. Experimental results indicate that increasing the n-GaN thickness significantly improves device performance. Specifically, the thicker n-GaN layer effectively reduces series resistance, piezoelectric field (Fpz), leakage current, Shockley–Read–Hall (SRH) recombination, and current crowding. The decrease in strain-induced ${F}_{\textit {PZ}}$ improves carrier confinement in the active region, thereby reducing efficiency droop at high injection currents. Furthermore, improved crystal quality in the active region results in reduced SRH recombination and an increased radiative recombination rate, contributing to higher efficiency. Temperature-dependent measurements further reveal that the thicker n-GaN LED exhibits improved thermal stability, with reduced efficiency droop observed even at elevated temperature compared to room temperature. These findings highlight the critical role of n-GaN-layer engineering in optimizing the performance and reliability of NUV-LEDs.


  • Enhanced size-dependent efficiency of InGaN/AlGaN near-ultraviolet micro-LEDs

    by Abu Bashar Mohammad Hamidul Islam, Tae Kyoung Kim, Yu-Jung Cha, Joosun Yun, June-O Song, Dong-Soo Shin, Jong-In Shim, Joon Seop Kwak

    This study presents an approach for enhancing the external quantum efficiency (EQE) of multiple-quantum-well InGaN/AlGaN near-ultraviolet (NUV) micro-light-emitting diodes (micro-LEDs) without changing the epitaxial layer. Unlike the size-dependent EQE reduction observed in blue, green, and red micro-LEDs, the EQE of NUV micro-LEDs at high current densities (≥10 A/cm2) improves as the device dimensions shrink from 500 × 500 μm2 to 20 × 20 μm2. A 20 × 20 μm2 micro-LED achieves a peak EQE of 12.3%, compared to 8.60% for a larger 500 × 500 μm2 micro-LED. Experimental results attribute this EQE enhancement to improved light-extraction efficiency, driven by better current spreading. In larger micro-LEDs, pronounced current crowding causes carrier overflow from the active region, leading to reduced EQE at high current densities. These findings highlight the promising potential of NUV micro-LEDs for diverse applications.


  • Temperature-Dependent Efficiency Droop in GaN-Based Blue Micro Light-Emitting Diodes

    by Abu Bashar Mohammad Hamidul Islam, Tae Kyoung Kim, Yu-Jung Cha, Dong-Soo Shin, Jong-In Shim, Joon Seop Kwak

    This work investigates the size-dependent decrease in external quantum efficiency (EQE) of various InGaN/GaN multiple-quantum-well flip-chip blue micro light-emitting diodes (μ-LEDs) of sizes from 10 × 10 μm2 to 250 × 250 μm2 and proposes that the temperature-dependent efficiency droop is the main mechanism for decrease in EQE with reducing dimensions for well-passivated μ-LEDs. Experimental results show that the EQE increases with reducing μ-LED sizes to 50 × 50 μm2. However, the EQE decreases as the μ-LED size is further reduced to 10 × 10 μm2. The measured current-voltage characteristics, the minimum ideality factor, the light-emission patterns by the photon-emission microscope, and the transmission-electron-microscopy images consistently reveal that the decreased EQE of the smallest sized μ-LED is not due to the sidewall leakage: the decreased EQE is rather caused by the temperature-dependent efficiency droop (T-droop), which is systematically found by investigating the blueshift in peak emission wavelength and calculating the thermal resistance (Rth) that increases with the reduced mesa area. The decrease in peak EQE at 440 K compared to 300 K is also presented, which demonstrates that the reduction in peak EQE increases with reducing μ-LED sizes. It is pointed out that the small-sized μ-LEDs suffer from higher junction temperature due to lower heat dissipation caused by higher Rth compared to large-sized μ-LEDs.


  • Determining the Turn-On Voltage of GaN-Based Light-Emitting Diodes: From Near-Ultraviolet to Green Spectra

    by Abu Bashar Mohammad Hamidul Islam, Dong-Soo Shin, Joon Seop Kwak, Jong-In Shim

    This work investigates the turn-on voltage (V on) estimation methods from experimental data of InGaN-based multiple-quantum-well light-emitting diodes (LEDs) with emission spectra from near-ultraviolet to green wavelengths. Three different methods are examined: fixed current intercept, linear fitting of current-voltage curve, and the minimum ideality factor (n ideal). The voltage at minimum n ideal consistently represents the on-state of LEDs since it describes the carrier recombination processes reflected in light output power (LOP) and the external quantum efficiency (EQE). Beyond the voltage at minimum n ideal, samples’ LOPs start to increase abruptly, with the EQEs reaching ≥ 54% of the peak EQE values. For V on determined by other methods, samples’LOPs are already turned on and the EQEs exceed their peak value. Therefore, using the minimum n ideal is a suitable method for determining Von of an LED.

  • Generation of sidewall defects in InGaN/GaN blue micro-LEDs under forward-current stress

    by Abu Bashar Mohammad Hamidul Islam, Tae Kyoung Kim, Dong-Soo Shin, Jong-In Shim, Joon Seop Kwak

    This work investigates the effect of current stress on InGaN/GaN multiple-quantum-well flip-chip blue micro light-emitting diodes (μ-LEDs) with a mesa size of 30 × 30 μm2 and describes the stress-related mechanisms: defect aggregation and generation, which cause the change in optoelectronic performance of μ-LEDs. A forward-current stress is applied at 75 A/cm2 (0.7 mA) for 200 h. The device performance degrades with increasing stress time except until 25 h. During the initial 25 h of aging, the light output power and the external quantum efficiency (EQE) increase due to the improved crystal quality caused by aggregation of point defects in the active region, which are supported by the ideality factor and the S-parameter. The high-resolution emission-microscope images reveal that the generation of point defects at mesa sidewalls rather than the active region is crucial in performance degradation. We highlight, in particular, that the aging test generates sidewall point defects even though the sidewalls were properly passivated by a thick SiO2 layer. The mechanisms of defect aggregation and generation due to aging are consistently described by the ideality factor, the S-parameter, and the EQE.


  • Open Access

    Demonstration of Efficient Ultrathin Side-Emitting InGaN/GaN Flip-Chip Light-Emitting Diodes by Double Side Reflectors

    by Tae Kyoung Kim, Abu Bashar Mohammad Hamidul Islam, Yu-Jung Cha, Seung Hyun Oh, Joon Seop Kwak

    This work proposes an InGaN/GaN multiple-quantum-well flip-chip blue ultrathin side-emitting (USE) light-emitting diode (LED) and describes the sidewall light emission characteristics for the application of backlight units in display technology. The USE-LEDs are fabricated with top (ITO/distributed Bragg reflector) and bottom (Ag) mirrors that cause light emission from the four sidewalls in a lateral direction. The effect of light output power (LOP) on lateral direction is consistently investigated for improving the optoelectronic performances of USE-LEDs. Initially, the reference USE-LED suffers from very low LOP because of poor light extraction efficiency (LEE). Therefore, the LEE is improved by fabricating ZnO nanorods at each sidewall through hydrothermal method. The effects of ZnO nanorod lengths and diameters on LOP are systematically investigated for optimizing the dimensions of ZnO nanorods. The optimized ZnO nanorods improve the LEE of USE-LED, which thus results in increasing the LOP > 80% compared to the reference LED. In addition, the light-tools simulator is also used for elucidating the increase in LEE of ZnO nanorods USE-LED.


  • Open Access

    32 × 32 Pixelated High-Power Flip-Chip Blue Micro-LED-on-HFET Arrays for Submarine Optical Communication

    by Tae Kyoung Kim, Abu Bashar Mohammad Hamidul Islam, Yu-Jung Cha, Joon Seop Kwak

    This work proposes the use of integrated high-power InGaN/GaN multiple-quantum-well flip-chip blue micro light-emitting diode (μ-LED) arrays on an AlGaN/GaN-based heterojunction field-effect transistor (HFET), also known as a high electron mobility transistor (HEMT), for various applications: underwater wireless optical communication (UWOC) and smart lighting. Therefore, we demonstrate high-power μ-LED-on-HEMT arrays that consist of 32 × 32 pixelated μ-LED arrays and 32 × 32 pixelated HEMT arrays and that are interconnected by a solder bump bonding technique. Each pixel of the μ-LED arrays emits light in the HEMT on-state. The threshold voltage, the off-state leakage current, and the drain current of the HEMT arrays are −4.6 V, <~1.1 × 10−9 A at gate-to-source voltage (VGS) = −10 V, and 21 mA at VGS = 4 V, respectively. At 12 mA, the forward voltage and the light output power (LOP) of μ-LED arrays are ~4.05 V and ~3.5 mW, respectively. The LOP of the integrated μ-LED-on-HEMT arrays increases from 0 to ~4 mW as the VGS increases from −6 to 4 V at VDD = 10 V. Each pixel of the integrated μ-LEDs exhibits a modulated high LOP at a peak wavelength of ~450 nm, showing their potential as candidates for use in UWOC.


  • Effect of Defects on Strain Relaxation in InGaN/AlGaN Multiple‐Quantum‐Well Near‐Ultraviolet Light‐Emitting Diodes

    by Abu Bashar Mohammad Hamidul Islam, Jong-In Shim, Dong-Soo Shin, Joon Seop Kwak

    Three similar‐structure InGaN/AlGaN multiple‐quantum‐well near‐ultraviolet (NUV) light‐emitting diodes (LEDs) are utilized to investigate the microscopic effect of defects on strain relaxation. Consistent correlations among the crystal quality, the piezoelectric field (FPZ), the internal quantum efficiency (IQE), and the bandgap shrinkage of NUV LEDs are obtained by investigating the macroscopic characterizations. The difference in crystal quality (or the defect density) of NUV LEDs is found by the ideality factor, the emission microscope image, the Shockley–Read–Hall coefficient, and the IQE. Electroreflectance spectra are used to calculate FPZ of NUV LEDs. FPZ, the IQE, and the peak‐wavelength shift at driving currents are increased with the samples’ crystal quality compared to the reference sample. Also, FPZ, the IQE, and the peak‐wavelength shift are decreased with the increase in samples’ defect densities. A similar result is found for the bandgap shrinkage. This effect significantly indicates that the strain relaxation is induced by defects. Herein, a model that systematically explains the observed changes in macroscopic properties of NUV LEDs is proposed.