Daniel Cruz
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Daniel Cruz has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
Axel Knop-Gericke
Fritz-Haber-Institut der Max-Planck-Gesellschaft, Department of Inorganic Chemistry, Berlin, Germany
3 shared publicationsRobert Schlögl
Fritz-Haber-Institut der Max-Planck-Gesellschaft, Department of Inorganic Chemistry, Berlin, Germany
3 shared publications- Thomas Lunkenbein
Fritz-Haber-Institut der Max-Planck-Gesellschaft Faradayweg 4-6
3 shared publications - Luis Sandoval-Diaz
Inorganic Chemistry Department, Fritz-Haber-Institute of the Max-Planck-Society, Berlin, Germany
2 shared publications - Malte Behrens
Kiel University, Institute of Inorganic Chemistry, Max-Eyth-Straße 2, 24118 Kiel, Germany
2 shared publications - Michael Hävecker
Department of Inorganic Chemistry
2 shared publications
Latest Publications
- Open Access
- 24 November 2025
- Published by Wiley in Advanced Materials
- Vol. 38 (8) , e15292
Stabilizing Frustrated Phase Transitions in Selective Oxidation Reactions
Frustrated phase transitions represent the ideal working state of a heterogeneous catalyst. These states exist within a narrow parameter window, making them difficult to stabilize. Here, it is shown for the selective oxidation of 2‐propanol to acetone over Co 3 O 4 spinels that the addition of water extends the stability regime of the relevant frustrated phase transition. This conclusion is based on results obtained from multi‐modal experiments, including operando scanning electron microscopy (OSEM), near ambient pressure X‐ray photoelectron spectroscopy (NAP‐XPS), transmission electron microscopy (TEM), and computer vision analysis. It is found that the most selective state for acetone formation coincides with a dynamic spinel structure that fluctuates through reversible redox processes. At elevated temperatures, this metastable state undergoes a complete phase transition into the rock‐salt CoO phase characterized by low acetone selectivity. This process is found to be mediated by the generation of mobile vacancies. The addition of water vapor mitigates vacancy mobility and stabilizes the selective, but thermodynamically frustrated, state. As such, the study conceptualizes a strategy to extend the lifetime of a catalyst during reaction by the adequate addition of a co‐reactant.
- 24 November 2025
- Published by Wiley in Advanced Materials
- Vol. 38 (8) , e15292
Open AccessStabilizing Frustrated Phase Transitions in Selective Oxidation Reactions
Frustrated phase transitions represent the ideal working state of a heterogeneous catalyst. These states exist within a narrow parameter window, making them difficult to stabilize. Here, it is shown for the selective oxidation of 2‐propanol to acetone over Co 3 O 4 spinels that the addition of water extends the stability regime of the relevant frustrated phase transition. This conclusion is based on results obtained from multi‐modal experiments, including operando scanning electron microscopy (OSEM), near ambient pressure X‐ray photoelectron spectroscopy (NAP‐XPS), transmission electron microscopy (TEM), and computer vision analysis. It is found that the most selective state for acetone formation coincides with a dynamic spinel structure that fluctuates through reversible redox processes. At elevated temperatures, this metastable state undergoes a complete phase transition into the rock‐salt CoO phase characterized by low acetone selectivity. This process is found to be mediated by the generation of mobile vacancies. The addition of water vapor mitigates vacancy mobility and stabilizes the selective, but thermodynamically frustrated, state. As such, the study conceptualizes a strategy to extend the lifetime of a catalyst during reaction by the adequate addition of a co‐reactant.
- Open Access
- 18 November 2025
- Published by Springer Nature in Nature Catalysis
- Vol. 8 (12) , 1314-1324
Local solid-state processes adjust the selectivity in catalytic oxidation reactions on cobalt oxides
Transition metal oxides are excellent catalysts for selective oxidation reactions, which are a prominent source of industrially relevant chemicals. However, these reactions suffer from multiple competing reaction pathways, limiting the selectivity. Thus, it is essential to gain an understanding of the underlying processes occurring on the catalyst that affect its performance. Here we synergistically combine operando X-ray spectroscopy and operando transmission electron microscopy to unravel a network of solid-state processes that controls the catalytic properties of Co 3 O 4 in the oxidation of 2-propanol towards acetone. These include exsolution, diffusion and defect formation, which strongly distort the catalyst lattice at lower temperatures. Ultimately, they also lead to a maximum in acetone selectivity when the catalyst is trapped in a frustrated or metastable state at the onset of crystallization of the exsolved particles to CoO and void formation, which coincides with the maximum in surface cobalt oxidation state in the spinel.
- 18 November 2025
- Published by Springer Nature in Nature Catalysis
- Vol. 8 (12) , 1314-1324
Open AccessLocal solid-state processes adjust the selectivity in catalytic oxidation reactions on cobalt oxides
Transition metal oxides are excellent catalysts for selective oxidation reactions, which are a prominent source of industrially relevant chemicals. However, these reactions suffer from multiple competing reaction pathways, limiting the selectivity. Thus, it is essential to gain an understanding of the underlying processes occurring on the catalyst that affect its performance. Here we synergistically combine operando X-ray spectroscopy and operando transmission electron microscopy to unravel a network of solid-state processes that controls the catalytic properties of Co 3 O 4 in the oxidation of 2-propanol towards acetone. These include exsolution, diffusion and defect formation, which strongly distort the catalyst lattice at lower temperatures. Ultimately, they also lead to a maximum in acetone selectivity when the catalyst is trapped in a frustrated or metastable state at the onset of crystallization of the exsolved particles to CoO and void formation, which coincides with the maximum in surface cobalt oxidation state in the spinel.
- Open Access
- 3 January 2025
- Published by Springer Nature in Nature Communications
- Vol. 16 (1) , 1-7
Carbon nitride caught in the act of artificial photosynthesis
Covalent semiconductors of the carbon nitride family are among the most promising systems to realize “artificial photosynthesis”, that is exploiting synthetic materials which use sunlight as an energy source to split water into its elements or converting CO2 into added value chemicals. However, the role of surface interactions and electronic properties on the reaction mechanism remain still elusive. Here, we use in-situ spectroscopic techniques that enable monitoring surface interactions in carbon nitride under artificial photosynthetic conditions. We show that the water adsorption and light illumination cause changes of the surface electron density, which activate the photocatalyst and enable the water splitting process. Our results reveal critical details on the photocatalytic mechanism, which proceeds through proton-coupled electron transfer, and provide key information to design more efficient photocatalyst for artificial photosynthesis.
- 3 January 2025
- Published by Springer Nature in Nature Communications
- Vol. 16 (1) , 1-7
Open AccessCarbon nitride caught in the act of artificial photosynthesis
Covalent semiconductors of the carbon nitride family are among the most promising systems to realize “artificial photosynthesis”, that is exploiting synthetic materials which use sunlight as an energy source to split water into its elements or converting CO2 into added value chemicals. However, the role of surface interactions and electronic properties on the reaction mechanism remain still elusive. Here, we use in-situ spectroscopic techniques that enable monitoring surface interactions in carbon nitride under artificial photosynthetic conditions. We show that the water adsorption and light illumination cause changes of the surface electron density, which activate the photocatalyst and enable the water splitting process. Our results reveal critical details on the photocatalytic mechanism, which proceeds through proton-coupled electron transfer, and provide key information to design more efficient photocatalyst for artificial photosynthesis.
- Open Access
- 9 July 2024
- Published by Springer Nature in Research Square
Increased Catalytic Activity of the Sabatier Reaction for Space Applications
Water is crucial in space missions, and developing lightweight, high-performing catalysts for water recycling is essential. Extensive research on nanosized and even single-atom catalysts supported on oxides has been conducted for this purpose. However, the oxide supports usually constitute over 90% of the total mass, so the catalysts are heavy. Here, we fabricated a light, fibrous RuO2 nanostructured textile consisting solely of RuO2 nanoparticles (NPs), which did not require an oxide support, and evaluated it in the Sabatier reaction for water recycling. Remarkably, this support-free catalyst textile displayed an unprecedented catalytic mass activity (~60 mmolCH4 h-1 gcat-1 at 160 °C), which was approximately 20 times higher than that of a previously reported Ru/TiO2 catalyst, and the highest TOF (0.021 s-1 at 160 °C). Although well-known catalyst degradation was observed during prolonged testing, the performance of the textile remained exceptional even after 46 hours of continuous operation. A detailed surface analysis unveiled phenomena such as RuO2 reduction, nanoparticle growth, surface smoothing, and Ru loss during the reaction, contributing to degradation. We expect that addressing these intrinsic and thermodynamically driven phenomena will improve activity and durability.
- 9 July 2024
- Published by Springer Nature in Research Square
Open AccessIncreased Catalytic Activity of the Sabatier Reaction for Space Applications
Water is crucial in space missions, and developing lightweight, high-performing catalysts for water recycling is essential. Extensive research on nanosized and even single-atom catalysts supported on oxides has been conducted for this purpose. However, the oxide supports usually constitute over 90% of the total mass, so the catalysts are heavy. Here, we fabricated a light, fibrous RuO2 nanostructured textile consisting solely of RuO2 nanoparticles (NPs), which did not require an oxide support, and evaluated it in the Sabatier reaction for water recycling. Remarkably, this support-free catalyst textile displayed an unprecedented catalytic mass activity (~60 mmolCH4 h-1 gcat-1 at 160 °C), which was approximately 20 times higher than that of a previously reported Ru/TiO2 catalyst, and the highest TOF (0.021 s-1 at 160 °C). Although well-known catalyst degradation was observed during prolonged testing, the performance of the textile remained exceptional even after 46 hours of continuous operation. A detailed surface analysis unveiled phenomena such as RuO2 reduction, nanoparticle growth, surface smoothing, and Ru loss during the reaction, contributing to degradation. We expect that addressing these intrinsic and thermodynamically driven phenomena will improve activity and durability.
- Open Access
- 9 January 2024
- Published by Springer Nature in Nature Catalysis
- Vol. 7 (2) , 161-171
Metastable nickel–oxygen species modulate rate oscillations during dry reforming of methane
When a heterogeneous catalyst is active, it forms metastable structures that constantly transform into each other. These structures contribute differently to the catalytic function. Here we show the role of different metastable oxygen species on a Ni catalyst during dry reforming of methane by combining environmental scanning electron microscopy, near ambient pressure X-ray photoelectron spectroscopy, on-line product detection and computer vision. We highlight the critical role of dissociative CO2 adsorption in regulating the oxygen content of the catalyst and in CH4 activation. We also discover rate oscillations during dry reforming of methane resulting from the sequential transformation of metastable oxygen species that exhibit different catalytic properties: atomic surface oxygen, subsurface oxygen and bulk NiOx. The imaging approach allowed the localization of fluctuating surface regions that correlated directly with catalytic activity. The study highlights the importance of metastability and operando analytics in catalysis science and provides impetus towards the design of catalytic systems.
- 9 January 2024
- Published by Springer Nature in Nature Catalysis
- Vol. 7 (2) , 161-171
Open AccessMetastable nickel–oxygen species modulate rate oscillations during dry reforming of methane
When a heterogeneous catalyst is active, it forms metastable structures that constantly transform into each other. These structures contribute differently to the catalytic function. Here we show the role of different metastable oxygen species on a Ni catalyst during dry reforming of methane by combining environmental scanning electron microscopy, near ambient pressure X-ray photoelectron spectroscopy, on-line product detection and computer vision. We highlight the critical role of dissociative CO2 adsorption in regulating the oxygen content of the catalyst and in CH4 activation. We also discover rate oscillations during dry reforming of methane resulting from the sequential transformation of metastable oxygen species that exhibit different catalytic properties: atomic surface oxygen, subsurface oxygen and bulk NiOx. The imaging approach allowed the localization of fluctuating surface regions that correlated directly with catalytic activity. The study highlights the importance of metastability and operando analytics in catalysis science and provides impetus towards the design of catalytic systems.
- Open Access
- 11 October 2021
- Published by Wiley in Chemistry – A European Journal
- Vol. 27 (68) , 17127-17144
The Effect of Water on the 2‐Propanol Oxidation Activity of Co‐Substituted LaFe1−xCoxO3 Perovskites
Perovskites are interesting oxidation catalysts due to their chemical flexibility enabling the tuning of several properties. In this work, we synthesized LaFe1−xCoxO3 catalysts by co‐precipitation and thermal decomposition, characterized them thoroughly and studied their 2‐propanol oxidation activity under dry and wet conditions to bridge the knowledge gap between gas and liquid phase reactions. Transient tests showed a highly active, unstable low‐temperature (LT) reaction channel in conversion profiles and a stable, less‐active high‐temperature (HT) channel. Cobalt incorporation had a positive effect on the activity. The effect of water was negative on the LT channel, whereas the HT channel activity was boosted for x>0.15. The boost may originate from a slower deactivation rate of the Co3+ sites under wet conditions and a higher amount of hydroxide species on the surface comparing wet to dry feeds. Water addition resulted in a slower deactivation for Co‐rich catalysts and higher activity in the HT channel state.
- 11 October 2021
- Published by Wiley in Chemistry – A European Journal
- Vol. 27 (68) , 17127-17144
Open AccessThe Effect of Water on the 2‐Propanol Oxidation Activity of Co‐Substituted LaFe1−xCoxO3 Perovskites
Perovskites are interesting oxidation catalysts due to their chemical flexibility enabling the tuning of several properties. In this work, we synthesized LaFe1−xCoxO3 catalysts by co‐precipitation and thermal decomposition, characterized them thoroughly and studied their 2‐propanol oxidation activity under dry and wet conditions to bridge the knowledge gap between gas and liquid phase reactions. Transient tests showed a highly active, unstable low‐temperature (LT) reaction channel in conversion profiles and a stable, less‐active high‐temperature (HT) channel. Cobalt incorporation had a positive effect on the activity. The effect of water was negative on the LT channel, whereas the HT channel activity was boosted for x>0.15. The boost may originate from a slower deactivation rate of the Co3+ sites under wet conditions and a higher amount of hydroxide species on the surface comparing wet to dry feeds. Water addition resulted in a slower deactivation for Co‐rich catalysts and higher activity in the HT channel state.