Alexis Dufour
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Alexis Dufour has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Sylvain Girard
Université Jean Monnet Saint-Etienne
4 shared publications - Adriana Morana
Université Jean Monnet Saint-Etienne
3 shared publications - Emmanuel Marin
Laboratoire Hubert Curien, UMR CNRS 5516, Université Jean Monnet, 42000 Saint-Etienne, France
3 shared publications - Aziz Boukenter
Laboratoire Hubert Curien, UMR CNRS 5516, Université Jean Monnet, 42000 Saint-Etienne, France
2 shared publications - Damien Jamon
Université Jean Monnet‐Saint‐Étienne, CNRS, Institut d'Optique Graduate School, Laboratoire Hubert Curien, UMR 5516 Saint‐Étienne France
2 shared publications F. Royer
CNRS 5516, IOGS, Laboratory Hubert Curien, University of Lyon, Universit Jean Monnet, Saint-tienne, France
2 shared publications
Latest Publications
- 13 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 72 (8) , 2555-2561
Influence of Manufacturing Parameters on the Steady-State Radiation Response of Radiation-Sensitive Optical Fibers
We study the radiation induced attenuation (RIA) levels and kinetics at 1.53 μm, under X-rays, of a set of germanosilicate single-mode optical fibers designed with a small amount of phosphorus in their diversely-doped claddings. In addition to this compositional aspect, the influence of several manufacturing parameters on the RIA is also discussed. We observe that a lower vitrification temperature of the preform (from 2000°C to 1600°C) leads to higher (about 20%) signal losses at this wavelength. Varying the drawing tension from 120 g to 40 g has a negligible effect (<5%) on the fiber radiation response in this spectral range. In contrast, the GeP co-doping in the fiber cladding has a major impact. Moreover, the low dose-rate dependence of the RIA could make these optical fibers interesting for dosimetry applications.
- 13 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 72 (8) , 2555-2561
Influence of Manufacturing Parameters on the Steady-State Radiation Response of Radiation-Sensitive Optical Fibers
We study the radiation induced attenuation (RIA) levels and kinetics at 1.53 μm, under X-rays, of a set of germanosilicate single-mode optical fibers designed with a small amount of phosphorus in their diversely-doped claddings. In addition to this compositional aspect, the influence of several manufacturing parameters on the RIA is also discussed. We observe that a lower vitrification temperature of the preform (from 2000°C to 1600°C) leads to higher (about 20%) signal losses at this wavelength. Varying the drawing tension from 120 g to 40 g has a negligible effect (<5%) on the fiber radiation response in this spectral range. In contrast, the GeP co-doping in the fiber cladding has a major impact. Moreover, the low dose-rate dependence of the RIA could make these optical fibers interesting for dosimetry applications.
- 8 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 42 (14) , 4987-4996
Overview of the Infrared Radiation Responses of Telecom-Grade Single Mode Optical Fibers
We present a comprehensive study about the radiation response of ten single mode optical fibers (SMFs) from three different manufacturers, commercially-available for the telecommunication market. All the SMFs were exposed at room temperature to 100 kV X-rays at two different dose rates, 6 Gy(SiO 2 )/s and 0.6 Gy(SiO 2 )/s, up to 100 kGy and 10 kGy, respectively. Their radiation induced attenuation (RIA) growth and decay kinetics were measured around 1535 nm. The observed RIA levels and kinetics strongly varied between the different samples, allowing to distinguish four different behaviors that are discussed in details. In particular, three of the SMFs exhibit attenuation levels of up to thousands of dB/km at low dose, all pertain to the category of recently developed ultra-low loss pure-silica core SMFs. The RIA kinetics were also found to differ depending on the specifications of the tested fibers: G.652, G.654 or G.657. Spectral measurements in the infrared domain reveal that the most radiosensitive SMFs present infrared absorption bands related to radiation induced point defects created by ionization processes. Our findings demonstrate the potential use and limits of these SMFs in harsh environments for data transfer or sensing. It also reveals how the evolution of the fiber manufacturing techniques pushed by the telecommunication market could affect the fiber radiation response. This also highlights the difficult use of commercial fibers in radiation-demanding applications such as those associated with NewSpace.
- 8 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 42 (14) , 4987-4996
Overview of the Infrared Radiation Responses of Telecom-Grade Single Mode Optical Fibers
We present a comprehensive study about the radiation response of ten single mode optical fibers (SMFs) from three different manufacturers, commercially-available for the telecommunication market. All the SMFs were exposed at room temperature to 100 kV X-rays at two different dose rates, 6 Gy(SiO 2 )/s and 0.6 Gy(SiO 2 )/s, up to 100 kGy and 10 kGy, respectively. Their radiation induced attenuation (RIA) growth and decay kinetics were measured around 1535 nm. The observed RIA levels and kinetics strongly varied between the different samples, allowing to distinguish four different behaviors that are discussed in details. In particular, three of the SMFs exhibit attenuation levels of up to thousands of dB/km at low dose, all pertain to the category of recently developed ultra-low loss pure-silica core SMFs. The RIA kinetics were also found to differ depending on the specifications of the tested fibers: G.652, G.654 or G.657. Spectral measurements in the infrared domain reveal that the most radiosensitive SMFs present infrared absorption bands related to radiation induced point defects created by ionization processes. Our findings demonstrate the potential use and limits of these SMFs in harsh environments for data transfer or sensing. It also reveals how the evolution of the fiber manufacturing techniques pushed by the telecommunication market could affect the fiber radiation response. This also highlights the difficult use of commercial fibers in radiation-demanding applications such as those associated with NewSpace.
- 28 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (4) , 556-561
Functionalized Microstructured Optical Fiber for Magnetic-Field Sensing in Radiation Environments
A functionalized microstructured silica-based optical fiber, displaying significant magneto-optical effects in the C-band telecommunication wavelength (1530-1565 nm) has been developed by adding a sol-gel layer doped with magnetic nanoparticles around its pure silica core. The fiber was subjected to X-rays at room temperature up to a total ionizing dose (TID) of 500 kGy(SiO 2 ) – 50 Mrad – at a dose rate of 9.5 Gy(SiO 2 )/s. The magneto-optical responses of the functionalized fiber under a rotating permanent NeFeB magnet were investigated prior, during and after the irradiation using a dedicated setup. The results show that magneto-optical properties of the sample remain unaffected by such radiation constraints, keeping the same promising performances than the not-irradiated sample. An additional passive measurement was conducted with an even greater TID of 2.5 MGy, at same dose rate, giving identical results. This work demonstrates the radiation resistance of such a functionalization process in order to develop magneto-optically sensitive optical fibers able to be implemented in harsh environments such as the ones encountered in fusion-devoted facilities or nuclear power plants.
- 28 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (4) , 556-561
Functionalized Microstructured Optical Fiber for Magnetic-Field Sensing in Radiation Environments
A functionalized microstructured silica-based optical fiber, displaying significant magneto-optical effects in the C-band telecommunication wavelength (1530-1565 nm) has been developed by adding a sol-gel layer doped with magnetic nanoparticles around its pure silica core. The fiber was subjected to X-rays at room temperature up to a total ionizing dose (TID) of 500 kGy(SiO 2 ) – 50 Mrad – at a dose rate of 9.5 Gy(SiO 2 )/s. The magneto-optical responses of the functionalized fiber under a rotating permanent NeFeB magnet were investigated prior, during and after the irradiation using a dedicated setup. The results show that magneto-optical properties of the sample remain unaffected by such radiation constraints, keeping the same promising performances than the not-irradiated sample. An additional passive measurement was conducted with an even greater TID of 2.5 MGy, at same dose rate, giving identical results. This work demonstrates the radiation resistance of such a functionalization process in order to develop magneto-optically sensitive optical fibers able to be implemented in harsh environments such as the ones encountered in fusion-devoted facilities or nuclear power plants.
- 27 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 39 (17) , 5604-5610
All-Fiber Magneto-Optical Effect Using Nanoparticles Doped Sol-Gel Thin Film Deposited Within Microstructured Fibers
An innovative functionalization method allowing to greatly increase the Faraday effect of microstructured silica-based optical fibers is described. This method relies on the coating of a sol-gel thin film doped with magnetic field sensitive cobalt ferrite nanoparticles around the suspended core of the fiber. By varying the functionalization process parameters, both the film thickness and nanoparticle concentrations can be tailored to optimize the fiber magneto-optical response by a proper adjustment the interaction between the guided mode and the composite film. Experimental measurements in an all-fiber configuration on several samples diversely functionalized show a significant polar magneto-optical effect. A polarization rotation as large as 10 has been measured at 1550 nm when the most efficiently functionalized fiber is located inside a 0.7 cm air gap electromagnet at 1 Tesla. The present method and the developed all-fiber components are very promising candidates for the design of fiber-based sensors of magnetic fields.
- 27 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 39 (17) , 5604-5610
All-Fiber Magneto-Optical Effect Using Nanoparticles Doped Sol-Gel Thin Film Deposited Within Microstructured Fibers
An innovative functionalization method allowing to greatly increase the Faraday effect of microstructured silica-based optical fibers is described. This method relies on the coating of a sol-gel thin film doped with magnetic field sensitive cobalt ferrite nanoparticles around the suspended core of the fiber. By varying the functionalization process parameters, both the film thickness and nanoparticle concentrations can be tailored to optimize the fiber magneto-optical response by a proper adjustment the interaction between the guided mode and the composite film. Experimental measurements in an all-fiber configuration on several samples diversely functionalized show a significant polar magneto-optical effect. A polarization rotation as large as 10 has been measured at 1550 nm when the most efficiently functionalized fiber is located inside a 0.7 cm air gap electromagnet at 1 Tesla. The present method and the developed all-fiber components are very promising candidates for the design of fiber-based sensors of magnetic fields.
- 1 January 2021
- Published by Optica Publishing Group
- p. W4.8
Micro-structured optical fiber functionalization with magnetic nanoparticles doped sol-gel matrix: application to an all-fiber magnetic field sensor
The functionalization of micro-structured optical fibers can bring new applications for conventional fibers. We present a magneto-optic sensor based on the Faraday effect, through magnetic nanoparticles doped sol-gel thin film coating the fiber core.
- 1 January 2021
- Published by Optica Publishing Group
- p. W4.8
Micro-structured optical fiber functionalization with magnetic nanoparticles doped sol-gel matrix: application to an all-fiber magnetic field sensor
The functionalization of micro-structured optical fibers can bring new applications for conventional fibers. We present a magneto-optic sensor based on the Faraday effect, through magnetic nanoparticles doped sol-gel thin film coating the fiber core.