Jingjing Su
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Jingjing Su has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Jiapeng Mou
State Key Laboratory of Modern Optical Instrumentation, College of Optical Science and Engineering, Zhejiang University, Hangzhou, China
3 shared publications - Lijun Miao
Zhejiang University
2 shared publications - Tengchao Huang
Zhejiang University
2 shared publications - Xingfan Chen
State Key Laboratory of Modern Optical Instrumentation, College of Optical Science and Engineering, Zhejiang University, Hangzhou 310027, China
2 shared publications - Dong Pu
Center of Mathematical Sciences, Zhejiang University, Hangzhou, China
1 shared publication - Fei Yuan
School of Informatics, Xiamen University, Xiamen, China
1 shared publication
Latest Publications
- Open Access
- 17 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 15 (4) , 1-8
Reduction of the Relative Intensity Noise of Broadband Sources Using Dual Fiber Ring Resonator
Interferometric fiber-optic gyroscopes (IFOGs) are widely utilized due to their compact size and solid-state design. However, their sensitivity of detecting rotation is limited by the relative intensity noise (RIN) associated with the broadband source. To overcome this limitation, a conventional fiber ring resonator (FRR) can be employed to filter the RIN specifically at the IFOG frequency. Nonetheless, implementing this solution necessitates a fiber delay line with a length equal to that of the fiber coil. To address this challenge, we propose the utilization of passive and active dual FRRs and examine their RIN suppression characteristics. By utilizing the active dual FRR as an optimized gain point filter, we achieve a theoretical RIN suppression ratio equivalent to that of the traditional FRR, while significantly reducing the required length of the fiber delay line.
- 17 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 15 (4) , 1-8
Open AccessReduction of the Relative Intensity Noise of Broadband Sources Using Dual Fiber Ring Resonator
Interferometric fiber-optic gyroscopes (IFOGs) are widely utilized due to their compact size and solid-state design. However, their sensitivity of detecting rotation is limited by the relative intensity noise (RIN) associated with the broadband source. To overcome this limitation, a conventional fiber ring resonator (FRR) can be employed to filter the RIN specifically at the IFOG frequency. Nonetheless, implementing this solution necessitates a fiber delay line with a length equal to that of the fiber coil. To address this challenge, we propose the utilization of passive and active dual FRRs and examine their RIN suppression characteristics. By utilizing the active dual FRR as an optimized gain point filter, we achieve a theoretical RIN suppression ratio equivalent to that of the traditional FRR, while significantly reducing the required length of the fiber delay line.
- Open Access
- 29 June 2021
- Published by MDPI AG in Micromachines
- Vol. 12 (7) , 769
Simultaneous Trapping of Two Types of Particles with Focused Elegant Third-Order Hermite–Gaussian Beams
The focusing properties of elegant third-order Hermite–Gaussian beams (TH3GBs) and the radiation forces exerted on dielectric spherical particles produced by such beams in the Rayleigh scattering regime have been theoretically studied. Numerical results indicate that the elegant TH3GBs can be used to simultaneously trap and manipulate nanosized dielectric spheres with refractive indexes lower than the surrounding medium at the focus and those with refractive indexes larger than the surrounding medium in the focal vicinity. Furthermore, by changing the radius of the beam waist, the transverse trapping range and stiffness at the focal plane can be changed.
- 29 June 2021
- Published by MDPI AG in Micromachines
- Vol. 12 (7) , 769
Open AccessSimultaneous Trapping of Two Types of Particles with Focused Elegant Third-Order Hermite–Gaussian Beams
The focusing properties of elegant third-order Hermite–Gaussian beams (TH3GBs) and the radiation forces exerted on dielectric spherical particles produced by such beams in the Rayleigh scattering regime have been theoretically studied. Numerical results indicate that the elegant TH3GBs can be used to simultaneously trap and manipulate nanosized dielectric spheres with refractive indexes lower than the surrounding medium at the focus and those with refractive indexes larger than the surrounding medium in the focal vicinity. Furthermore, by changing the radius of the beam waist, the transverse trapping range and stiffness at the focal plane can be changed.
- 14 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 70 (00189456) , 1-10
Evaluation of Angle Measurement Uncertainty of Fiber Optic Gyroscope Based on Monte Carlo Method
Research on the transfer and traceability of a dynamic angle has great value in the field of measurement. The fiber optic gyroscope (FOG), as a high-precision angular velocity sensor, has broad prospects in this application. The focus of this article is the evaluation of angle measurement uncertainty of the FOG based on the Monte Carlo method (MCM). The angle measurement uncertainty evaluation model is established based on the principle of the FOG, and the simulation is carried out in detail based on the model and MCM. Finally, the angle measurement experiments of the FOG are carried out in the National Institute of Metrology, China. The experimental results show that the angle measurement uncertainty within the range of 360° is about 0.96 '' in a relatively stable environment when the confidence probability is 95%. It is highly consistent with the simulation, which confirms the accuracy of the evaluation model and the effectiveness of MCM.
- 14 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 70 (00189456) , 1-10
Evaluation of Angle Measurement Uncertainty of Fiber Optic Gyroscope Based on Monte Carlo Method
Research on the transfer and traceability of a dynamic angle has great value in the field of measurement. The fiber optic gyroscope (FOG), as a high-precision angular velocity sensor, has broad prospects in this application. The focus of this article is the evaluation of angle measurement uncertainty of the FOG based on the Monte Carlo method (MCM). The angle measurement uncertainty evaluation model is established based on the principle of the FOG, and the simulation is carried out in detail based on the model and MCM. Finally, the angle measurement experiments of the FOG are carried out in the National Institute of Metrology, China. The experimental results show that the angle measurement uncertainty within the range of 360° is about 0.96 '' in a relatively stable environment when the confidence probability is 95%. It is highly consistent with the simulation, which confirms the accuracy of the evaluation model and the effectiveness of MCM.
- 12 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 21 (13) , 15308-15317
Research on Field Application Technology of Dynamic Angle Measurement Based on Fiber Optic Gyroscope and Autocollimator
For the purpose of realizing the dynamic angle measurement and calibration of the inertial equipment (such as rotary table), a dynamic angle measurement system based on the autocollimator and the fiber optic gyroscope (FOG), which can be used as an angle standard device, is designed in this paper. In this system, the scale factor of the FOG can be calibrated in the field application based on the autocollimator with the precision of 1 '' in the range of ±0.05°. Furthermore, the angle measurement deviation between the FOG and the rotary table can be limited in ±3 '' when the scale factor of the FOG is calibrated by the autocollimator when necessary. This research can guarantee the long-term accuracy of the scale factor of the FOG in the field application and it will greatly promote the applications of the FOG as an angle standard device in the field of dynamic angle measurement.
- 12 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 21 (13) , 15308-15317
Research on Field Application Technology of Dynamic Angle Measurement Based on Fiber Optic Gyroscope and Autocollimator
For the purpose of realizing the dynamic angle measurement and calibration of the inertial equipment (such as rotary table), a dynamic angle measurement system based on the autocollimator and the fiber optic gyroscope (FOG), which can be used as an angle standard device, is designed in this paper. In this system, the scale factor of the FOG can be calibrated in the field application based on the autocollimator with the precision of 1 '' in the range of ±0.05°. Furthermore, the angle measurement deviation between the FOG and the rotary table can be limited in ±3 '' when the scale factor of the FOG is calibrated by the autocollimator when necessary. This research can guarantee the long-term accuracy of the scale factor of the FOG in the field application and it will greatly promote the applications of the FOG as an angle standard device in the field of dynamic angle measurement.
- Open Access
Surfaces pinched by normal curvature for mean curvature flow in space forms
In this paper, we investigate the mean curvature flow of compact surfaces in $4$-dimensional space forms. We prove the convergence theorems for the mean curvature flow under certain pinching conditions involving the normal curvature, which generalise Baker-Nguyen's convergence theorem.
Open AccessSurfaces pinched by normal curvature for mean curvature flow in space forms
In this paper, we investigate the mean curvature flow of compact surfaces in $4$-dimensional space forms. We prove the convergence theorems for the mean curvature flow under certain pinching conditions involving the normal curvature, which generalise Baker-Nguyen's convergence theorem.
- Open Access
- 4 August 2015
- Published by Springer Nature
- p. 68-79
Phase Unwrapping Method Based on Heterodyne Three Frequency Non-equal Step Phase Shift
- 4 August 2015
- Published by Springer Nature
- p. 68-79
Open AccessPhase Unwrapping Method Based on Heterodyne Three Frequency Non-equal Step Phase Shift