Samuel E. Pate
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Samuel E. Pate has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Zhi-Li Xiao
Materials Science Division, Argonne National Laboratory, Argonne, Illinois 60439, USA
3 shared publications Laxman R. Thoutam
Materials Science Division, Argonne National Laboratory, Argonne, Illinois 60439, USA
2 shared publications- Ralu Divan
Center for Nanoscale Materials Argonne National Laboratory Lemont IL 60439 USA
2 shared publications Ulrich Welp
Materials Science Division, Argonne National Laboratory, Argonne, Illinois 60439, USA
2 shared publicationsWai-Kwong Kwok
Materials Science Division, Argonne National Laboratory, Argonne, Illinois 60439, USA
2 shared publications- Yong-Lei Wang
Nanjing University
2 shared publications
Latest Publications
- Open Access
- 1 October 2026
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 39 (10) , 105021
Vortex trapping and induced screening currents in superconducting moat arrays
The performance of superconducting circuits is frequently compromised by the unwanted trapping of magnetic flux within the device structure. While the inclusion of moats to sequester vortices in the device design can mitigate this, their effectiveness is often found to be inadequate. Here we use the complementary techniques of magneto optical imaging (MOI) and scanning Hall probe microscopy (SHPM) to develop a quantitative understanding of the efficiency of flux trapping in 2D periodic moat arrays patterned in superconducting Nb thin films. Field cooling in small out-of-plane fields leads to a slightly higher flux density in the moat holes compared to the adjacent Nb strips, as resolved in MOI images. High resolution SHPM images allow the quantitative analysis of interstitial Abrikosov vortices and moat-contained flux, and reveal a trapping window of ∼ ± 1.3 Oe below which all vortices migrate to the 5 μ m × 5 μ m moats. At higher cooling fields, both the interstitial vortex density and the net moat flux increase approximately linearly with cooling field, in reasonable agreement with time dependent Ginzburg–Landau simulations. The measured trapping field is close to the estimated expulsion field for 5 μ m-wide strips ( B 0 ∼ 1.37 Oe) and is slightly larger than an empirical generalisation of this expression for periodic arrays. The application of small out-of-plane fields after zero-field cooling leads to the observation of dipole-like field distributions in the moats in MOI images arising from large induced screening currents. Quantification of these dipoles from SHPM images shows qualitative agreement with a 2D critical state model of flux penetration. Our results demonstrate that existing theoretical models provide a good description of vortex sequestration in moat arrays and introduce a new contactless approach to create high supercurrent densities in thin film devices for vortex manipulation.
- 1 October 2026
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 39 (10) , 105021
Open AccessVortex trapping and induced screening currents in superconducting moat arrays
The performance of superconducting circuits is frequently compromised by the unwanted trapping of magnetic flux within the device structure. While the inclusion of moats to sequester vortices in the device design can mitigate this, their effectiveness is often found to be inadequate. Here we use the complementary techniques of magneto optical imaging (MOI) and scanning Hall probe microscopy (SHPM) to develop a quantitative understanding of the efficiency of flux trapping in 2D periodic moat arrays patterned in superconducting Nb thin films. Field cooling in small out-of-plane fields leads to a slightly higher flux density in the moat holes compared to the adjacent Nb strips, as resolved in MOI images. High resolution SHPM images allow the quantitative analysis of interstitial Abrikosov vortices and moat-contained flux, and reveal a trapping window of ∼ ± 1.3 Oe below which all vortices migrate to the 5 μ m × 5 μ m moats. At higher cooling fields, both the interstitial vortex density and the net moat flux increase approximately linearly with cooling field, in reasonable agreement with time dependent Ginzburg–Landau simulations. The measured trapping field is close to the estimated expulsion field for 5 μ m-wide strips ( B 0 ∼ 1.37 Oe) and is slightly larger than an empirical generalisation of this expression for periodic arrays. The application of small out-of-plane fields after zero-field cooling leads to the observation of dipole-like field distributions in the moats in MOI images arising from large induced screening currents. Quantification of these dipoles from SHPM images shows qualitative agreement with a 2D critical state model of flux penetration. Our results demonstrate that existing theoretical models provide a good description of vortex sequestration in moat arrays and introduce a new contactless approach to create high supercurrent densities in thin film devices for vortex manipulation.
- 27 February 2025
- Published by American Physical Society (APS) in Physical Review B
- Vol. 111 (5)
Anomalies in the electromagnetic response and peculiarities of the domain structure in the magnetic Weyl semimetal- 27 February 2025
- Published by American Physical Society (APS) in Physical Review B
- Vol. 111 (5)
Anomalies in the electromagnetic response and peculiarities of the domain structure in the magnetic Weyl semimetal- 10 October 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 106 (15) , 155117
Temperature-driven changes in the Fermi surface of graphite
We report on temperature-dependent size and anisotropy of the Fermi pockets in graphite revealed by magnetotransport measurements. The magnetoresistances (MRs) obtained in fields along the axis obey an extended Kohler's rule, with the carrier density following the prediction of a temperature-dependent Fermi energy, indicating a change in the Fermi pocket size with temperature. The angle-dependent magnetoresistivities at a given temperature exhibit a scaling behavior. The scaling factor that reflects the anisotropy of the Fermi surface is also found to vary with temperature. Our results demonstrate that temperature-driven changes in Fermi surface can be ubiquitous and need to be considered in understanding the temperature-dependent carrier density and MR anisotropy in semimetals.- 10 October 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 106 (15) , 155117
Temperature-driven changes in the Fermi surface of graphite
We report on temperature-dependent size and anisotropy of the Fermi pockets in graphite revealed by magnetotransport measurements. The magnetoresistances (MRs) obtained in fields along the axis obey an extended Kohler's rule, with the carrier density following the prediction of a temperature-dependent Fermi energy, indicating a change in the Fermi pocket size with temperature. The angle-dependent magnetoresistivities at a given temperature exhibit a scaling behavior. The scaling factor that reflects the anisotropy of the Fermi surface is also found to vary with temperature. Our results demonstrate that temperature-driven changes in Fermi surface can be ubiquitous and need to be considered in understanding the temperature-dependent carrier density and MR anisotropy in semimetals.- Open Access
- 10 November 2021
- Published by American Physical Society (APS) in Physical Review X
- Vol. 11 (4) , 041029
Extended Kohler’s Rule of Magnetoresistance
A notable phenomenon in topological semimetals is the violation of Kohler’s rule, which dictates that the magnetoresistance MR obeys a scaling behavior of , where and is the magnetic field, with and being the resistivity at and zero field, respectively. Here, we report a violation originating from thermally induced change in the carrier density. We find that the magnetoresistance of the Weyl semimetal TaP follows an extended Kohler’s rule , with describing the temperature dependence of the carrier density. We show that is associated with the Fermi level and the dispersion relation of the semimetal, providing a new way to reveal information on the electronic band structure. We offer a fundamental understanding of the violation and validity of Kohler’s rule in terms of different temperature responses of . We apply our extended Kohler’s rule to to settle a long-standing debate on the scaling behavior of the normal-state magnetoresistance of a superconductor, namely, , where is the Hall angle. We further validate the extended Kohler’s rule and demonstrate its generality in a semiconductor, InSb, where the temperature-dependent carrier density can be reliably determined both theoretically and experimentally.- 10 November 2021
- Published by American Physical Society (APS) in Physical Review X
- Vol. 11 (4) , 041029
Open AccessExtended Kohler’s Rule of Magnetoresistance
A notable phenomenon in topological semimetals is the violation of Kohler’s rule, which dictates that the magnetoresistance MR obeys a scaling behavior of , where and is the magnetic field, with and being the resistivity at and zero field, respectively. Here, we report a violation originating from thermally induced change in the carrier density. We find that the magnetoresistance of the Weyl semimetal TaP follows an extended Kohler’s rule , with describing the temperature dependence of the carrier density. We show that is associated with the Fermi level and the dispersion relation of the semimetal, providing a new way to reveal information on the electronic band structure. We offer a fundamental understanding of the violation and validity of Kohler’s rule in terms of different temperature responses of . We apply our extended Kohler’s rule to to settle a long-standing debate on the scaling behavior of the normal-state magnetoresistance of a superconductor, namely, , where is the Hall angle. We further validate the extended Kohler’s rule and demonstrate its generality in a semiconductor, InSb, where the temperature-dependent carrier density can be reliably determined both theoretically and experimentally.