Giovani Jesus Berrospi Aquino
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Giovani Jesus Berrospi Aquino has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Ana María Gómez Amador
Department of Mechanical Engineering, Universidad Carlos III de Madrid, 28911 Leganés, Spain
1 shared publication - Jorge Alencastre
Engineering Department, Pontificia Universidad Catolica del Peru, San Miguel 15088, Peru
1 shared publication - Juan José Jiménez de Cisneros
Engineering Department, Pontificia Universidad Católica del Perú, Lima 15088, Peru
1 shared publication
Latest Publications
- Open Access
- 13 November 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (22) , 10731
A Review of the T-Stub Components for the Analysis of Bolted Moment Joints
The analytical method for the calculation of the properties of a bolted joint established by the structural Eurocodes proposes the T-stub as a component for the characterization of the tension and compression zones in moment joints. In this article, a review of the state of the art on the T-stub component is developed, where the works developed since it was initially defined, and from the perspectives of formulation, experimentation and numerical simulation are summarized and discussed. Additionally, possible future lines of work are proposed.
- 13 November 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (22) , 10731
Open AccessA Review of the T-Stub Components for the Analysis of Bolted Moment Joints
The analytical method for the calculation of the properties of a bolted joint established by the structural Eurocodes proposes the T-stub as a component for the characterization of the tension and compression zones in moment joints. In this article, a review of the state of the art on the T-stub component is developed, where the works developed since it was initially defined, and from the perspectives of formulation, experimentation and numerical simulation are summarized and discussed. Additionally, possible future lines of work are proposed.