Soonho Shon
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Soonho Shon has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Kwanjung Yee
Seoul National University
5 shared publications Yoonpyo Hong
3 shared publications- Beomsu Kim
Korea Natl Univ Transportat, Dept Transportat Syst Engn, Uiwang 437763, South Korea
2 shared publications - Cheol Yoo
Wind Energy Laboratory, Korea Institute of Energy Research, Jeju-si, South Korea
1 shared publication - Hyeokbin Kwon
Department of Transportation System Engineering, Korea National University of Transportation, Uiwang-Si, Korea
1 shared publication - Jinkyu Bae
Mechatronics Research, Samsung Electronics Co., Ltd ., 1-1 Samsungjeonja-ro, Hwaseong-si, Gyeonggi-do 18448
1 shared publication
Latest Publications
- 26 February 2025
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- p. 1-19
Icing Characteristics of a Wing Behind a Propeller Wake
Propeller-generated wakes create complex aerodynamic interactions that influence ice accretion on aircraft wings, consequently affecting aerodynamic performance. However, the effect of the propeller wake on wing icing characteristics is not well understood. This study clarifies the mechanisms and extent of propeller wake effects on wing icing by comparing the icing characteristics with and without the propeller wake. Three-dimensional quasi-unsteady simulations are employed to capture temporal changes in the droplet field and ice accretion rates caused by local and unsteady propeller wake flows. The computational results provide insights into the icing characteristics induced by aerodynamic interactions. Higher axial velocities enhance droplet impingement and heat convection on the wing. Upwash and downwash change the local effective attack angle, altering droplet impingement limits and the size and intensity of heat convection. The rotation of tip vortices creates droplet voids and dense regions, enhancing heat convection on the inside of the wing tip and leading to noticeable differences in ice formation. Consequently, ice shapes behind the propeller wake are up to 80% thicker and more irregular, leading to twice as severe degradation in aerodynamic performance of the non-wake-induced iced wing. This study highlights the need to consider propeller wake effects in wing icing analysis.
- 26 February 2025
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- p. 1-19
Icing Characteristics of a Wing Behind a Propeller Wake
Propeller-generated wakes create complex aerodynamic interactions that influence ice accretion on aircraft wings, consequently affecting aerodynamic performance. However, the effect of the propeller wake on wing icing characteristics is not well understood. This study clarifies the mechanisms and extent of propeller wake effects on wing icing by comparing the icing characteristics with and without the propeller wake. Three-dimensional quasi-unsteady simulations are employed to capture temporal changes in the droplet field and ice accretion rates caused by local and unsteady propeller wake flows. The computational results provide insights into the icing characteristics induced by aerodynamic interactions. Higher axial velocities enhance droplet impingement and heat convection on the wing. Upwash and downwash change the local effective attack angle, altering droplet impingement limits and the size and intensity of heat convection. The rotation of tip vortices creates droplet voids and dense regions, enhancing heat convection on the inside of the wing tip and leading to noticeable differences in ice formation. Consequently, ice shapes behind the propeller wake are up to 80% thicker and more irregular, leading to twice as severe degradation in aerodynamic performance of the non-wake-induced iced wing. This study highlights the need to consider propeller wake effects in wing icing analysis.
- 27 September 2023
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 242
Snow accretion on a model train: Climate wind tunnel experiments
- 27 September 2023
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 242
Snow accretion on a model train: Climate wind tunnel experiments
- 19 December 2022
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 232
Evaluation of snow accumulation simulation on a train using experimental results
- 19 December 2022
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 232
Evaluation of snow accumulation simulation on a train using experimental results
- 3 July 2022
- Published by Taylor & Francis in International Journal of Rail Transportation
- Vol. 11 (4) , 465-489
Numerical investigation of snow accumulation on a high-speed train by snow saltation
Snow accumulation on the undercarriage of a train is an important issue that significantly degrades the safety and performance of the vehicle. This phenomenon is primarily attributed to snow saltation induced by train-generated wind gusts. This study numerically investigated the snow accumulation on a train by modelling the snow saltation for the initial movement of drifting snow from the ground. A semi-empirical snow saltation model was applied to the boundary condition for a snow-covered ground, and Eulerian governing equations were solved for snow phase flow. Using the present method, a high-speed train model comprising multiple cars and a single-car model were simulated. The results presented the novel trend of snow accumulation, which gradually increased towards the rear of the train but remained relatively constant after a third car.
- 3 July 2022
- Published by Taylor & Francis in International Journal of Rail Transportation
- Vol. 11 (4) , 465-489
Numerical investigation of snow accumulation on a high-speed train by snow saltation
Snow accumulation on the undercarriage of a train is an important issue that significantly degrades the safety and performance of the vehicle. This phenomenon is primarily attributed to snow saltation induced by train-generated wind gusts. This study numerically investigated the snow accumulation on a train by modelling the snow saltation for the initial movement of drifting snow from the ground. A semi-empirical snow saltation model was applied to the boundary condition for a snow-covered ground, and Eulerian governing equations were solved for snow phase flow. Using the present method, a high-speed train model comprising multiple cars and a single-car model were simulated. The results presented the novel trend of snow accumulation, which gradually increased towards the rear of the train but remained relatively constant after a third car.
- 1 July 2022
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Aircraft
- Vol. 59 (4) , 847-860
Design of Hybrid Airfoils for Icing Tunnel Tests Based on Reduced-Order Modeling Methods
A hybrid airfoil is a scaled model for generating a full-scale ice shape for icing wind tunnel tests. This is possible by matching full-scale properties such as the distributions of collection effi...
- 1 July 2022
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Aircraft
- Vol. 59 (4) , 847-860
Design of Hybrid Airfoils for Icing Tunnel Tests Based on Reduced-Order Modeling Methods
A hybrid airfoil is a scaled model for generating a full-scale ice shape for icing wind tunnel tests. This is possible by matching full-scale properties such as the distributions of collection effi...