Audrey Tourrette
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Audrey Tourrette has a total of 50 co-authors. Here are the top co-authors by number of shared publications:
- Guillaume Conzatti
French National Institute of Health and Medical Research (INSERM), UMR 1260, Regenerative Nanomedicine (RNM), FMTS, CRBS Strasbourg France
6 shared publications S. Cavalie
CIRIMAT, Université de Toulouse 3 - Paul Sabatier, CNRS, Toulouse, France
4 shared publicationsF. Ayadi
Univ Toulouse 3 Paul Sabatier, Univ Toulouse, CNRS, CIRIMAT, Toulouse, France
2 shared publicationsJ. Torrisani
INSERM, Université Toulouse 3 - Paul Sabatier, Centre de Recherches en Cancérologie de Toulouse, Toulouse, France
2 shared publications- Jalloul Bouajila
Laboratoire de Génie Chimique, Université de Toulouse, CNRS-INPT-UPS, 31062 Toulouse, France
2 shared publications - Mehrez Romdhane
Research Laboratory on Energy, Water, Environment and Processes, National School of Engineering, Gabes University, Gabes 6029, Tunisia
2 shared publications
Latest Publications
- Open Access
- 23 December 2025
- Published by Elsevier in Applied Materials Today
- Vol. 48
Shape-morphing photo-crosslinked alginate hydrogels via digital light processing 4D printing
- 23 December 2025
- Published by Elsevier in Applied Materials Today
- Vol. 48
Open AccessShape-morphing photo-crosslinked alginate hydrogels via digital light processing 4D printing
- Open Access
- 31 July 2024
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 16 (35) , 16517-16534
Surface-anchored carbon nanomaterials for antimicrobial surfaces
We demonstrate that after anchoring at the surface of silicone, carbon nanomaterials exhibit antibacterial activity against Gram+ or Gram− bacteria depending on their surface chemistry.
- 31 July 2024
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 16 (35) , 16517-16534
Open AccessSurface-anchored carbon nanomaterials for antimicrobial surfaces
We demonstrate that after anchoring at the surface of silicone, carbon nanomaterials exhibit antibacterial activity against Gram+ or Gram− bacteria depending on their surface chemistry.
- Open Access
Influence of Extraction Techniques and Solvents on the Antioxidant and Biological Potential of Different Parts of Scorzonera undulata
The genus Scorzonera has various medicinal values. Species belonging to this genus were traditionally used as drugs or in food. The current study aimed to determine the phytochemical composition, antioxidant activity, and biological properties of the tuber, leaf, and flower of Scorzonera undulata extracts, collected from the southwest of Tunisia. Phenolic compounds from the three parts were extracted using two solvents (water and ethanol) and two extraction techniques (maceration and ultrasound). The total phenolic content was measured by the Folin–Ciocalteu assay. Furthermore, the chemical composition of Scorzonera undulata extract was also investigated by the LC-ESI–MS method using phenolic acid and flavonoid standards. The variation of the extraction methods induced a variation in the real potentialities of the three parts in terms of bioactive molecules. However, the aerial part of S. undulata (leaves and flowers) showed, in general, the highest phenolic contents. Twenty-five volatile compounds have been detected by GC-MS in S. undulata extracts; among them, fourteen were identified before derivatization. The DPPH test showed that the aerial part of the plant has a higher antioxidant activity compared to the tuber (25.06% at 50 µg/mL for the leaf ethanolic extract obtained by ultrasound extraction). For most biological activities (anti-Xanthine, anti-inflammatory, and antidiabetic (alpha-amylase and alpha-glucosidase)), the aerial parts (flowers and leaves) of the plant showed the highest inhibition than tubers.
Open AccessInfluence of Extraction Techniques and Solvents on the Antioxidant and Biological Potential of Different Parts of Scorzonera undulata
The genus Scorzonera has various medicinal values. Species belonging to this genus were traditionally used as drugs or in food. The current study aimed to determine the phytochemical composition, antioxidant activity, and biological properties of the tuber, leaf, and flower of Scorzonera undulata extracts, collected from the southwest of Tunisia. Phenolic compounds from the three parts were extracted using two solvents (water and ethanol) and two extraction techniques (maceration and ultrasound). The total phenolic content was measured by the Folin–Ciocalteu assay. Furthermore, the chemical composition of Scorzonera undulata extract was also investigated by the LC-ESI–MS method using phenolic acid and flavonoid standards. The variation of the extraction methods induced a variation in the real potentialities of the three parts in terms of bioactive molecules. However, the aerial part of S. undulata (leaves and flowers) showed, in general, the highest phenolic contents. Twenty-five volatile compounds have been detected by GC-MS in S. undulata extracts; among them, fourteen were identified before derivatization. The DPPH test showed that the aerial part of the plant has a higher antioxidant activity compared to the tuber (25.06% at 50 µg/mL for the leaf ethanolic extract obtained by ultrasound extraction). For most biological activities (anti-Xanthine, anti-inflammatory, and antidiabetic (alpha-amylase and alpha-glucosidase)), the aerial parts (flowers and leaves) of the plant showed the highest inhibition than tubers.
- 17 November 2021
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 139 (12) , 51829
Hydrophobization of hydrophilic alginate/chitosan PEC surfaces
Alginate and chitosan are biocompatible polysaccharides that are often combined as polyelectrolyte complexes (PECs) for the development of biomaterials. These PECs are interesting as wound dressings, among other uses. The properties of such devices depend on their surface characteristics, however. Herein we propose a method to hydrophobize highly hydrophilic alginate/chitosan PECs by initial chemical grafting of polycaprolactone (PCL) or polylactic acid, using hexane diamine or ethylenediamine as linkers, followed by a drop casting covering step. This resulted in increased adhesion between the hydrophobic layer and the PEC, when compared to direct casting. The materials obtained were evaluated as potential biomaterials by analyzing the hydrophilic properties of their surface, swelling, enzymatic degradation, and impermeability. The results revealed that hydrophobization was effective but decreased the swelling abilities of PECs, which still remained interesting (~1000%) for wound dressing applications. However, the PCL layer was not resistant to the enzymatic environment, while PLA showed impermeabilization of the PECs.
- 17 November 2021
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 139 (12) , 51829
Hydrophobization of hydrophilic alginate/chitosan PEC surfaces
Alginate and chitosan are biocompatible polysaccharides that are often combined as polyelectrolyte complexes (PECs) for the development of biomaterials. These PECs are interesting as wound dressings, among other uses. The properties of such devices depend on their surface characteristics, however. Herein we propose a method to hydrophobize highly hydrophilic alginate/chitosan PECs by initial chemical grafting of polycaprolactone (PCL) or polylactic acid, using hexane diamine or ethylenediamine as linkers, followed by a drop casting covering step. This resulted in increased adhesion between the hydrophobic layer and the PEC, when compared to direct casting. The materials obtained were evaluated as potential biomaterials by analyzing the hydrophilic properties of their surface, swelling, enzymatic degradation, and impermeability. The results revealed that hydrophobization was effective but decreased the swelling abilities of PECs, which still remained interesting (~1000%) for wound dressing applications. However, the PCL layer was not resistant to the enzymatic environment, while PLA showed impermeabilization of the PECs.
- 1 July 2020
- Published by Elsevier in Acta Biomaterialia
- Vol. 111, 418-428
Bio-inspired apatite particles limit skin penetration of drugs for dermatology applications
- 1 July 2020
- Published by Elsevier in Acta Biomaterialia
- Vol. 111, 418-428
Bio-inspired apatite particles limit skin penetration of drugs for dermatology applications
- 30 July 2019
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 45 (1) , 53-61
Development and Characterization of Novel Bigel-Based 1,4-Naphthoquinones for Topical Application with Antioxidant Potential
- 30 July 2019
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 45 (1) , 53-61
Development and Characterization of Novel Bigel-Based 1,4-Naphthoquinones for Topical Application with Antioxidant Potential
- 1 March 2019
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 175, 91-97
Elaboration of a thermosensitive smart biomaterial: From synthesis to the ex vivo bioadhesion evaluation
- 1 March 2019
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 175, 91-97
Elaboration of a thermosensitive smart biomaterial: From synthesis to the ex vivo bioadhesion evaluation
- 1 February 2019
- Published by Elsevier in Applied Surface Science
- Vol. 467-468, 940-948
Thermosensitive PNIPAM grafted alginate/chitosan PEC
- 1 February 2019
- Published by Elsevier in Applied Surface Science
- Vol. 467-468, 940-948
Thermosensitive PNIPAM grafted alginate/chitosan PEC
- Open Access
- 1 August 2018
- Published by Elsevier in European Polymer Journal
- Vol. 105, 434-441
Surface functionalization of plasticized chitosan films through PNIPAM grafting via UV and plasma graft polymerization
- 1 August 2018
- Published by Elsevier in European Polymer Journal
- Vol. 105, 434-441
Open AccessSurface functionalization of plasticized chitosan films through PNIPAM grafting via UV and plasma graft polymerization