Hans Beck
Hans Beck has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Daniel Hofstetter
Independent Researcher, Chemin du Château 5, 2068 Hauterive, Switzerland
7 shared publications - David P. Bour
Google LLC, 1250 Reliance Way, Fremont, CA 94539, USA
6 shared publications - Andreas Dirk Wieck
Ruhr-Universität Bochum
1 shared publication - Cynthia Aku-Leh
ISciences, L.L.C., 2155 Jackson Avenue, Ann Arbor, MI 48103, USA
1 shared publication - David P. Bour
Apple Inc., 1 Infinite Loop, Cupertino, CA 95014, USA
1 shared publication
Latest Publications
- Open Access
- 30 June 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (7) , 787
Observation of a Fano Resonance at 92 meV (13.5 µm) in Al0.2Ga0.8N/GaN-Based Quantum Cascade Emitters
We report on asymmetrically shaped Fano resonances in Al0.2Ga0.8N/GaN-based quantum cascade structures. In order to observe this type of resonance in electro-luminescence, a spectrally narrow feature must interact with a broad, quasi-continuous emission. While the narrow waveform is provided by the GaN-based LO-phonon at 92 meV (13.5 µm, 741 cm−1), the broad peak consists of overlapping inter-subband transitions between several higher-order excited states ranging from 80 to 300 meV and the ground state. Through the interference of these spectrally dissimilar peaks, a typical, asymmetric Fano line shape is generated.
- 30 June 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (7) , 787
Open AccessObservation of a Fano Resonance at 92 meV (13.5 µm) in Al0.2Ga0.8N/GaN-Based Quantum Cascade Emitters
We report on asymmetrically shaped Fano resonances in Al0.2Ga0.8N/GaN-based quantum cascade structures. In order to observe this type of resonance in electro-luminescence, a spectrally narrow feature must interact with a broad, quasi-continuous emission. While the narrow waveform is provided by the GaN-based LO-phonon at 92 meV (13.5 µm, 741 cm−1), the broad peak consists of overlapping inter-subband transitions between several higher-order excited states ranging from 80 to 300 meV and the ground state. Through the interference of these spectrally dissimilar peaks, a typical, asymmetric Fano line shape is generated.
- Open Access
Correction: Hofstetter et al. Monolithically Integrated Michelson Interferometer Using an InGaAs/InAlAs Quantum Cascade Laser at λ = 4 µm. Photonics 2024, 11, 593
There was an error in the original publication
Open AccessCorrection: Hofstetter et al. Monolithically Integrated Michelson Interferometer Using an InGaAs/InAlAs Quantum Cascade Laser at λ = 4 µm. Photonics 2024, 11, 593
There was an error in the original publication
- Open Access
Monolithically Integrated Michelson Interferometer Using an InGaAs/InAlAs Quantum Cascade Laser at λ = 4 µm
In the present article, we propose a monolithically integrated Michelson interferometer using a λ = 4 µm InGaAs/InAlAs quantum cascade laser as the light source. By using simple fringe detection and a four-point interpolation on each fringe, we will be able to detect minimal object displacements of 500 nm—corresponding to 25% of half the laser emission wavelength. Such an interferometric photonic integrated circuit has interesting applications for precision computerized numerical controlled machines. Since the industrial standard of such machines currently consists of glass-based linear encoders with a resolution of 5 µm, our interferometer-based system will enable an improvement of at least one order of magnitude.
Open AccessMonolithically Integrated Michelson Interferometer Using an InGaAs/InAlAs Quantum Cascade Laser at λ = 4 µm
In the present article, we propose a monolithically integrated Michelson interferometer using a λ = 4 µm InGaAs/InAlAs quantum cascade laser as the light source. By using simple fringe detection and a four-point interpolation on each fringe, we will be able to detect minimal object displacements of 500 nm—corresponding to 25% of half the laser emission wavelength. Such an interferometric photonic integrated circuit has interesting applications for precision computerized numerical controlled machines. Since the industrial standard of such machines currently consists of glass-based linear encoders with a resolution of 5 µm, our interferometer-based system will enable an improvement of at least one order of magnitude.
- Open Access
Interferometric Optical Pumping of an InGaN/GaN-Based Gain-Coupled Distributed Feedback Multi Quantum Well Laser
We describe an all-optical method to achieve—prior to further advanced processing steps—a perfect match of the relevant wavelength-sensitive parameters of an InGaN/GaN semiconductor distributed feedback laser. Instead of permanently etching and epitaxially over-growing a waveguide-based diffraction grating for the definition of an index-coupled distributed feedback laser, we suggest here—by employing a powerful ultraviolet pump laser—a non-permanent, photoinduced generation of an optical diffraction grating. The resulting complex refractive index modulation then forms a gain-coupled distributed feedback laser. Such an approach has the advantage of remaining flexible as long as possible—both in terms of the correct grating period and the ideal coupling constant. This flexibility is maintained until the definitive etch and the epitaxial over-growth of the diffraction grating are completed. Such devices can—like their dye laser counterparts in the early seventies—also be used as ultra-broadly tunable single-mode sources.
Open AccessInterferometric Optical Pumping of an InGaN/GaN-Based Gain-Coupled Distributed Feedback Multi Quantum Well Laser
We describe an all-optical method to achieve—prior to further advanced processing steps—a perfect match of the relevant wavelength-sensitive parameters of an InGaN/GaN semiconductor distributed feedback laser. Instead of permanently etching and epitaxially over-growing a waveguide-based diffraction grating for the definition of an index-coupled distributed feedback laser, we suggest here—by employing a powerful ultraviolet pump laser—a non-permanent, photoinduced generation of an optical diffraction grating. The resulting complex refractive index modulation then forms a gain-coupled distributed feedback laser. Such an approach has the advantage of remaining flexible as long as possible—both in terms of the correct grating period and the ideal coupling constant. This flexibility is maintained until the definitive etch and the epitaxial over-growth of the diffraction grating are completed. Such devices can—like their dye laser counterparts in the early seventies—also be used as ultra-broadly tunable single-mode sources.
- Open Access
Ultra-Short Lifetime of Intersubband Electrons in Resonance to GaN-Based LO-Phonons at 92 meV
In this study, we report on the ultra-short lifetime of excited intersubband electrons in a 38 Å wide AlGaN/GaN-based quantum well. The rapid decay of these charge carriers occurs due to a resonance between the relevant intersubband transition energy and the size of the GaN-based LO-phonon at 92 meV. Based on the experimentally observed Lorentz-shaped intersubband emission peak with a spectral width of roughly 6 meV (48 cm−1) respecting the Fourier transform limit, a very short lifetime, namely 111 fs, could be calculated. By comparing this lifetime to the existing literature data, our value confirms the potential high-speed capability of III-nitride-based optoelectronics.
Open AccessUltra-Short Lifetime of Intersubband Electrons in Resonance to GaN-Based LO-Phonons at 92 meV
In this study, we report on the ultra-short lifetime of excited intersubband electrons in a 38 Å wide AlGaN/GaN-based quantum well. The rapid decay of these charge carriers occurs due to a resonance between the relevant intersubband transition energy and the size of the GaN-based LO-phonon at 92 meV. Based on the experimentally observed Lorentz-shaped intersubband emission peak with a spectral width of roughly 6 meV (48 cm−1) respecting the Fourier transform limit, a very short lifetime, namely 111 fs, could be calculated. By comparing this lifetime to the existing literature data, our value confirms the potential high-speed capability of III-nitride-based optoelectronics.
- Open Access
Proposal for Deep-UV Emission from a Near-Infrared AlN/GaN-Based Quantum Cascade Device Using Multiple Photon Up-Conversion
We propose the use of an n-doped periodic AlN/GaN quantum cascade structure for the optical up-conversion of multiple near-infrared (near-IR) photons into deep-ultraviolet (deep-UV) radiation. Without applying an external bias voltage, the active region of such a device will (similar to an un-biased quantum cascade laser) resemble a sawtooth-shaped inter-subband structure. A carefully adjusted bias voltage then converts this sawtooth pattern into a ‘quantum-stair’. Illumination with λ = 1.55 µm radiation results in photon absorption thereby lifting electrons from the ground state of each main well into the first excited state. Three additional GaN quantum wells per period then provide by LO-phonon-assisted tunneling a diagonal transfer of these electrons towards the ground level of the neighboring period. From there, the next near-infrared (near-IR) photon absorption, electron excitation, and partial relaxation takes place. After 12 such absorption, transfer, and relaxation processes, the excited electrons have gained a sufficiently high amount of energy to undergo in the final AlN-based p-type contact layer an electron-hole band-to-band recombination. By employing this procedure, multiple near-IR photons will be up-converted to produce deep-UV radiation. Since for a wavelength of 1.55 µm very powerful near-IR pump lasers are readily available, such an up-conversion device will (even at a moderate overall conversion efficiency) potentially result in an equal or even higher output power than the one of an AlN-based p-n-junction light-emitting diode. The proposed structures are therefore very interesting for applications such as ultra-high-resolution photolithography or printing, water purification, medical equipment disinfection, white light generation, or the automotive industry.
Open AccessProposal for Deep-UV Emission from a Near-Infrared AlN/GaN-Based Quantum Cascade Device Using Multiple Photon Up-Conversion
We propose the use of an n-doped periodic AlN/GaN quantum cascade structure for the optical up-conversion of multiple near-infrared (near-IR) photons into deep-ultraviolet (deep-UV) radiation. Without applying an external bias voltage, the active region of such a device will (similar to an un-biased quantum cascade laser) resemble a sawtooth-shaped inter-subband structure. A carefully adjusted bias voltage then converts this sawtooth pattern into a ‘quantum-stair’. Illumination with λ = 1.55 µm radiation results in photon absorption thereby lifting electrons from the ground state of each main well into the first excited state. Three additional GaN quantum wells per period then provide by LO-phonon-assisted tunneling a diagonal transfer of these electrons towards the ground level of the neighboring period. From there, the next near-infrared (near-IR) photon absorption, electron excitation, and partial relaxation takes place. After 12 such absorption, transfer, and relaxation processes, the excited electrons have gained a sufficiently high amount of energy to undergo in the final AlN-based p-type contact layer an electron-hole band-to-band recombination. By employing this procedure, multiple near-IR photons will be up-converted to produce deep-UV radiation. Since for a wavelength of 1.55 µm very powerful near-IR pump lasers are readily available, such an up-conversion device will (even at a moderate overall conversion efficiency) potentially result in an equal or even higher output power than the one of an AlN-based p-n-junction light-emitting diode. The proposed structures are therefore very interesting for applications such as ultra-high-resolution photolithography or printing, water purification, medical equipment disinfection, white light generation, or the automotive industry.
- Open Access
AlGaN-Based 1.55 µm Phototransistor as a Crucial Building Block for Optical Computers
An optically activated, enhancement mode heterostructure field effect transistor is proposed and analytically studied. A particular feature of this device is its gate region, which is made of a photovoltaic GaN/AlN-based superlattice detector for a wavelength of 1.55 µm. Since the inter-subband transition in this superlattice does normally not interact with TE-polarized (or vertically incoming) radiation, a metallic second-order diffraction grating on the transistor gate results in a re-orientation of the light into the horizontal direction—thus providing the desired TM-polarization. Upon illumination of this gate, efficient inter-subband absorption lifts electrons from the ground to the first excited quantized state. Due to partial screening of the strong internal polarization fields between GaN quantum wells and AlN barriers, this slightly diagonal transition generates an optical rectification voltage. Added to a constant electrical bias, this optically produced gate voltage leads to a noticeable increase of the transistor’s source-drain current. The magnitude of the bias voltage is chosen to result in maximal transconductance. Since such a phototransistor based on high-bandgap material is a device involving only fast majority carriers, very low dark and leakage currents are expected. The most important advantage of such a device, however, is the expected switching speed and, hence, its predicted use as an optical logic gate for photonic computing. In the absence of a p-n-junction and thus of both a carrier-induced space charge region, and the parasitic capacitances resulting thereof, operation frequencies of appropriately designed, sufficiently small phototransistors reaching 100 GHz are envisaged.
Open AccessAlGaN-Based 1.55 µm Phototransistor as a Crucial Building Block for Optical Computers
An optically activated, enhancement mode heterostructure field effect transistor is proposed and analytically studied. A particular feature of this device is its gate region, which is made of a photovoltaic GaN/AlN-based superlattice detector for a wavelength of 1.55 µm. Since the inter-subband transition in this superlattice does normally not interact with TE-polarized (or vertically incoming) radiation, a metallic second-order diffraction grating on the transistor gate results in a re-orientation of the light into the horizontal direction—thus providing the desired TM-polarization. Upon illumination of this gate, efficient inter-subband absorption lifts electrons from the ground to the first excited quantized state. Due to partial screening of the strong internal polarization fields between GaN quantum wells and AlN barriers, this slightly diagonal transition generates an optical rectification voltage. Added to a constant electrical bias, this optically produced gate voltage leads to a noticeable increase of the transistor’s source-drain current. The magnitude of the bias voltage is chosen to result in maximal transconductance. Since such a phototransistor based on high-bandgap material is a device involving only fast majority carriers, very low dark and leakage currents are expected. The most important advantage of such a device, however, is the expected switching speed and, hence, its predicted use as an optical logic gate for photonic computing. In the absence of a p-n-junction and thus of both a carrier-induced space charge region, and the parasitic capacitances resulting thereof, operation frequencies of appropriately designed, sufficiently small phototransistors reaching 100 GHz are envisaged.