David Bitauld
David Bitauld has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Claire Besancon
III-V Lab, a joint lab of Nokia Bell Labs, Thales Research and Technology and CEA LETI, 91120 Palaiseau, France
4 shared publications - Jean Decobert
III-V Lab
4 shared publications - Nicolas Vaissiere
III-V Lab
4 shared publications - Joan Manel Ramirez
III-V Lab
3 shared publications - Karim Hassan
Université Grenoble Alpes, CEA, LETI, Minatec Campus, F-38054, Grenoble, France.
3 shared publications - Amin Souleiman
Institut Polytechnique de Paris
2 shared publications
Latest Publications
- 7 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 36 (3) , 155-158
Ultra-Fast Continuous Wavelength Sweep in III-V-on-SOI MOSCAP DFB Lasers
We demonstrate an ultra-fast athermal continuous wavelength-swept III-V-on-SOI MOSCAP DFB laser with a mode-hop-free-tuning up to 10 GHz in less than 2 ns. We also propose a new method to linearize the frequency response without any pre-distortion or active feedback in the gain’s current injection ramp. Instead, we polarize the III-V gain section under direct current injection, and we drive the hybrid MOSCAP waveguide with an AC voltage signal. By optimizing its driving frequency, we demonstrate an ultra-fast athermal triangular-shaped time-varying frequency tuning with a speed of 4×10 4 PHz/s and a laser’s frequency excursion of 4 GHz.
- 7 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 36 (3) , 155-158
Ultra-Fast Continuous Wavelength Sweep in III-V-on-SOI MOSCAP DFB Lasers
We demonstrate an ultra-fast athermal continuous wavelength-swept III-V-on-SOI MOSCAP DFB laser with a mode-hop-free-tuning up to 10 GHz in less than 2 ns. We also propose a new method to linearize the frequency response without any pre-distortion or active feedback in the gain’s current injection ramp. Instead, we polarize the III-V gain section under direct current injection, and we drive the hybrid MOSCAP waveguide with an AC voltage signal. By optimizing its driving frequency, we demonstrate an ultra-fast athermal triangular-shaped time-varying frequency tuning with a speed of 4×10 4 PHz/s and a laser’s frequency excursion of 4 GHz.
- 1 January 2023
- Published by Optica Publishing Group
- p. M1C.5
Athermal Silicon Photonic Wavemeter with Wide Temperature Range
We demonstrate a silicon photonic wavemeter with high accuracy for broadband measurements over a large temperature range of 20-60˚C. The integrated wavemeter reaches a mean error of 11 pm over an 80 nm span.
- 1 January 2023
- Published by Optica Publishing Group
- p. M1C.5
Athermal Silicon Photonic Wavemeter with Wide Temperature Range
We demonstrate a silicon photonic wavemeter with high accuracy for broadband measurements over a large temperature range of 20-60˚C. The integrated wavemeter reaches a mean error of 11 pm over an 80 nm span.
- Open Access
- 28 December 2021
- Published by MDPI AG in Applied Sciences
- Vol. 12 (1) , 263
AlGaInAs Multi-Quantum Well Lasers on Silicon-on-Insulator Photonic Integrated Circuits Based on InP-Seed-Bonding and Epitaxial Regrowth
The tremendous demand for low-cost, low-consumption and high-capacity optical transmitters in data centers challenges the current InP-photonics platform. The use of silicon (Si) photonics platform to fabricate photonic integrated circuits (PICs) is a promising approach for low-cost large-scale fabrication considering the CMOS-technology maturity and scalability. However, Si itself cannot provide an efficient emitting light source due to its indirect bandgap. Therefore, the integration of III-V semiconductors on Si wafers allows us to benefit from the III-V emitting properties combined with benefits offered by the Si photonics platform. Direct epitaxy of InP-based materials on 300 mm Si wafers is the most promising approach to reduce the costs. However, the differences between InP and Si in terms of lattice mismatch, thermal coefficients and polarity inducing defects are challenging issues to overcome. III-V/Si hetero-integration platform by wafer-bonding is the most mature integration scheme. However, no additional epitaxial regrowth steps are implemented after the bonding step. Considering the much larger epitaxial toolkit available in the conventional monolithic InP platform, where several epitaxial steps are often implemented, this represents a significant limitation. In this paper, we review an advanced integration scheme of AlGaInAs-based laser sources on Si wafers by bonding a thin InP seed on which further regrowth steps are implemented. A 3 µm-thick AlGaInAs-based MutiQuantum Wells (MQW) laser structure was grown onto on InP-SiO2/Si (InPoSi) wafer and compared to the same structure grown on InP wafer as a reference. The 400 ppm thermal strain on the structure grown on InPoSi, induced by the difference of coefficient of thermal expansion between InP and Si, was assessed at growth temperature. We also showed that this structure demonstrates laser performance similar to the ones obtained for the same structure grown on InP. Therefore, no material degradation was observed in spite of the thermal strain. Then, we developed the Selective Area Growth (SAG) technique to grow multi-wavelength laser sources from a single growth step on InPoSi. A 155 nm-wide spectral range from 1515 nm to 1670 nm was achieved. Furthermore, an AlGaInAs MQW-based laser source was successfully grown on InP-SOI wafers and efficiently coupled to Si-photonic DBR cavities. Altogether, the regrowth on InP-SOI wafers holds great promises to combine the best from the III-V monolithic platform combined with the possibilities offered by the Si photonics circuitry via efficient light-coupling.
- 28 December 2021
- Published by MDPI AG in Applied Sciences
- Vol. 12 (1) , 263
Open AccessAlGaInAs Multi-Quantum Well Lasers on Silicon-on-Insulator Photonic Integrated Circuits Based on InP-Seed-Bonding and Epitaxial Regrowth
The tremendous demand for low-cost, low-consumption and high-capacity optical transmitters in data centers challenges the current InP-photonics platform. The use of silicon (Si) photonics platform to fabricate photonic integrated circuits (PICs) is a promising approach for low-cost large-scale fabrication considering the CMOS-technology maturity and scalability. However, Si itself cannot provide an efficient emitting light source due to its indirect bandgap. Therefore, the integration of III-V semiconductors on Si wafers allows us to benefit from the III-V emitting properties combined with benefits offered by the Si photonics platform. Direct epitaxy of InP-based materials on 300 mm Si wafers is the most promising approach to reduce the costs. However, the differences between InP and Si in terms of lattice mismatch, thermal coefficients and polarity inducing defects are challenging issues to overcome. III-V/Si hetero-integration platform by wafer-bonding is the most mature integration scheme. However, no additional epitaxial regrowth steps are implemented after the bonding step. Considering the much larger epitaxial toolkit available in the conventional monolithic InP platform, where several epitaxial steps are often implemented, this represents a significant limitation. In this paper, we review an advanced integration scheme of AlGaInAs-based laser sources on Si wafers by bonding a thin InP seed on which further regrowth steps are implemented. A 3 µm-thick AlGaInAs-based MutiQuantum Wells (MQW) laser structure was grown onto on InP-SiO2/Si (InPoSi) wafer and compared to the same structure grown on InP wafer as a reference. The 400 ppm thermal strain on the structure grown on InPoSi, induced by the difference of coefficient of thermal expansion between InP and Si, was assessed at growth temperature. We also showed that this structure demonstrates laser performance similar to the ones obtained for the same structure grown on InP. Therefore, no material degradation was observed in spite of the thermal strain. Then, we developed the Selective Area Growth (SAG) technique to grow multi-wavelength laser sources from a single growth step on InPoSi. A 155 nm-wide spectral range from 1515 nm to 1670 nm was achieved. Furthermore, an AlGaInAs MQW-based laser source was successfully grown on InP-SOI wafers and efficiently coupled to Si-photonic DBR cavities. Altogether, the regrowth on InP-SOI wafers holds great promises to combine the best from the III-V monolithic platform combined with the possibilities offered by the Si photonics circuitry via efficient light-coupling.
- Open Access
- 23 November 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (23) , 11096
Low-Threshold, High-Power On-Chip Tunable III-V/Si Lasers with Integrated Semiconductor Optical Amplifiers
Heterogeneously integrated III-V/Si lasers and semiconductor optical amplifiers (SOAs) are key devices for integrated photonics applications requiring miniaturized on-chip light sources, such as in optical communications, sensing, or spectroscopy. In this work, we present a widely tunable laser co-integrated with a semiconductor optical amplifier in a heterogeneous platform that combines AlGaInAs multiple quantum wells (MQWs) and InP-based materials with silicon-on-insulator (SOI) wafers containing photonic integrated circuits. The co-integrated device is compact, has a total device footprint of 0.5 mm2, a lasing current threshold of 10 mA, a selectable wavelength tuning range of 50 nm centered at λ = 1549 nm, a fiber-coupled output power of 10 mW, and a laser linewidth of ν = 259 KHz. The SOA provides an on-chip gain of 18 dB/mm. The total power consumption of the co-integrated devices remains below 0.5 W even for the most power demanding lasing wavelengths. Apart from the above-mentioned applications, the co-integration of compact widely tunable III-V/Si lasers with on-chip SOAs provides a step forward towards the development of highly efficient, portable, and low power systems for wavelength division multiplexed passive optical networks (WDM-PONs).
- 23 November 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (23) , 11096
Open AccessLow-Threshold, High-Power On-Chip Tunable III-V/Si Lasers with Integrated Semiconductor Optical Amplifiers
Heterogeneously integrated III-V/Si lasers and semiconductor optical amplifiers (SOAs) are key devices for integrated photonics applications requiring miniaturized on-chip light sources, such as in optical communications, sensing, or spectroscopy. In this work, we present a widely tunable laser co-integrated with a semiconductor optical amplifier in a heterogeneous platform that combines AlGaInAs multiple quantum wells (MQWs) and InP-based materials with silicon-on-insulator (SOI) wafers containing photonic integrated circuits. The co-integrated device is compact, has a total device footprint of 0.5 mm2, a lasing current threshold of 10 mA, a selectable wavelength tuning range of 50 nm centered at λ = 1549 nm, a fiber-coupled output power of 10 mW, and a laser linewidth of ν = 259 KHz. The SOA provides an on-chip gain of 18 dB/mm. The total power consumption of the co-integrated devices remains below 0.5 W even for the most power demanding lasing wavelengths. Apart from the above-mentioned applications, the co-integration of compact widely tunable III-V/Si lasers with on-chip SOAs provides a step forward towards the development of highly efficient, portable, and low power systems for wavelength division multiplexed passive optical networks (WDM-PONs).