Brian E. O'ROurke
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Brian E. O'ROurke has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
- Nagayasu Oshima
National Institute of Advanced Industrial Science and Technology (AIST)
4 shared publications - Akira Ishida
Department of Physics Graduate School of Science The University of Tokyo 7-3-1 Hongo Bunkyo-ku 113-0033 Tokyo Japan
2 shared publications - Kenji Shu
Photon Science Centre, School of Engineering, The University of Tokyo, Yayoi, Bunkyo-ku, Tokyo, Japan
2 shared publications - Koichi Kino
Research Institute for Measurement and Analytical Instrumentation, National Institute of Advanced Industrial Science and Technology (AIST)
2 shared publications - Shoji Asai
University of Tokyo
2 shared publications - Takeshi Fujiwara
Non-Destructive Imaging Research Team, Integrated Research Center for Resilient Infrastructure, National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba, Japan
2 shared publications
Latest Publications
- 1 December 2025
- Published by Canadian Science Publishing in Canadian Journal of Physics
- Vol. 103 (12) , 1241-1247
Tracking the progression of nonuniform deterioration in a lithium-ion battery by Bragg-edge imaging using the AISTANS compact accelerator-driven neutron source
A commercial lithium-ion battery was studied nondestructively by neutron Bragg-edge imaging at the AISTANS compact accelerator-driven neutron source for the purpose of tracking the progression of nonuniform deterioration of the battery. Neutron transmission spectra with a pixel size of 5 × 5 mm 2 in a 55 × 50 mm 2 area on the battery were obtained. For the negative electrode, graphite, LiC 12 , and LiC 6 crystals were observed in the spectra. Column density (cm −2 ) images of these crystals at three different charge/discharge-cycle states (0, 92, and 200 cycles) were obtained. Obvious nonuniformity in the images were not recognized. However, slight shifts of average column densities of all pixels after 200 cycles, which might suggest power-storage degradation of the battery sample, were observed with the LiC 6 crystals.
- 1 December 2025
- Published by Canadian Science Publishing in Canadian Journal of Physics
- Vol. 103 (12) , 1241-1247
Tracking the progression of nonuniform deterioration in a lithium-ion battery by Bragg-edge imaging using the AISTANS compact accelerator-driven neutron source
A commercial lithium-ion battery was studied nondestructively by neutron Bragg-edge imaging at the AISTANS compact accelerator-driven neutron source for the purpose of tracking the progression of nonuniform deterioration of the battery. Neutron transmission spectra with a pixel size of 5 × 5 mm 2 in a 55 × 50 mm 2 area on the battery were obtained. For the negative electrode, graphite, LiC 12 , and LiC 6 crystals were observed in the spectra. Column density (cm −2 ) images of these crystals at three different charge/discharge-cycle states (0, 92, and 200 cycles) were obtained. Obvious nonuniformity in the images were not recognized. However, slight shifts of average column densities of all pixels after 200 cycles, which might suggest power-storage degradation of the battery sample, were observed with the LiC 6 crystals.
- 20 November 2022
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 137 (11) , 1-16
Pulsed neutron-beam flux with the supermirror neutron guide system at AISTANS
- 20 November 2022
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 137 (11) , 1-16
Pulsed neutron-beam flux with the supermirror neutron guide system at AISTANS
- 24 November 2021
- Published by American Physical Society (APS) in Physical Review A
- Vol. 104 (5) , L050801
Observation of orthopositronium thermalization in silica aerogel at cryogenic temperatures
We report orthopositronium thermalization observed in cryogenic silica aerogel cooled from room temperature to 25 K. It was observed that the thermalization rate gets slower as itself is colder than room temperature. This energy dependence can be explained based on a model where the efficiency of kinetic energy exchange between and silica is determined by the de Broglie wavelength of . The present measurement confirmed that a cooling method which utilizes the thermalization process at cryogenic temperatures followed by laser cooling is applicable for the efficient production of an Bose-Einstein condensate.- 24 November 2021
- Published by American Physical Society (APS) in Physical Review A
- Vol. 104 (5) , L050801
Observation of orthopositronium thermalization in silica aerogel at cryogenic temperatures
We report orthopositronium thermalization observed in cryogenic silica aerogel cooled from room temperature to 25 K. It was observed that the thermalization rate gets slower as itself is colder than room temperature. This energy dependence can be explained based on a model where the efficiency of kinetic energy exchange between and silica is determined by the de Broglie wavelength of . The present measurement confirmed that a cooling method which utilizes the thermalization process at cryogenic temperatures followed by laser cooling is applicable for the efficient production of an Bose-Einstein condensate.- Open Access
- 1 January 2018
- Published by The Japan Society of Applied Physics in Jjap Conference Proceedings
- Vol. 7, 011001
Study on positronium Bose–Einstein condensation
Realization of the Bose–Einstein condensation (BEC) of positronium is a long-standing challenge of positron physics. Since the positron is the antimatter of the electron, the positronium is the antimatter of itself, and its gravity interaction is a sum of matter and antimatter components. In this sense, it can be used to study antimatter gravity. It can also be used as a source of a γ-ray laser. We have proposed a new method to realize a positronium BEC: a combination of thermalization in a cold silica target and laser cooling using 1S-2P transitions. We have started some basic studies based on our new idea. Here we report a preliminary result of our positronium thermalization measurement in cryogenic environment and development status of a new laser system for positronium cooling.
- 1 January 2018
- Published by The Japan Society of Applied Physics in Jjap Conference Proceedings
- Vol. 7, 011001
Open AccessStudy on positronium Bose–Einstein condensation
Realization of the Bose–Einstein condensation (BEC) of positronium is a long-standing challenge of positron physics. Since the positron is the antimatter of the electron, the positronium is the antimatter of itself, and its gravity interaction is a sum of matter and antimatter components. In this sense, it can be used to study antimatter gravity. It can also be used as a source of a γ-ray laser. We have proposed a new method to realize a positronium BEC: a combination of thermalization in a cold silica target and laser cooling using 1S-2P transitions. We have started some basic studies based on our new idea. Here we report a preliminary result of our positronium thermalization measurement in cryogenic environment and development status of a new laser system for positronium cooling.
- 2 July 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 101 (1) , 014102
In-situ characterization of free-volume holes in polymer thin films under controlled humidity conditions with an atmospheric positron probe microanalyzer
A pulsed, slow positron beam, with a diameter of 200 μm, was extracted into air through a thin SiN window of an atmospheric positron probe microanalyzer (PPMA), and used to measure the ortho-positronium lifetimes τ in polyvinyl alcohol and polycaprolactam sub-μm-thick films. By measuring the variation of τ as a function of relative humidity, the effect of water molecules on the hole sizes, deduced from τ, was examined for the films with consideration to the chain mobility. The results demonstrate the usefulness of the atmospheric PPMA to the in-situ characterization of nanoscopic holes in thin films under practical conditions.
- 2 July 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 101 (1) , 014102
In-situ characterization of free-volume holes in polymer thin films under controlled humidity conditions with an atmospheric positron probe microanalyzer
A pulsed, slow positron beam, with a diameter of 200 μm, was extracted into air through a thin SiN window of an atmospheric positron probe microanalyzer (PPMA), and used to measure the ortho-positronium lifetimes τ in polyvinyl alcohol and polycaprolactam sub-μm-thick films. By measuring the variation of τ as a function of relative humidity, the effect of water molecules on the hole sizes, deduced from τ, was examined for the films with consideration to the chain mobility. The results demonstrate the usefulness of the atmospheric PPMA to the in-situ characterization of nanoscopic holes in thin films under practical conditions.
- 1 March 2009
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 169 (1) , 5-14
Polarization and angular correlation studies of X-rays emitted in relativistic ion-atom collisions
- 1 March 2009
- Published by Springer Nature in The European Physical Journal Special Topics
- Vol. 169 (1) , 5-14
Polarization and angular correlation studies of X-rays emitted in relativistic ion-atom collisions