Shuai Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Shuai Liu has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
Feng Yunli
2 shared publicationsFucheng Zhang
2 shared publicationsHuang Jiulong
2 shared publicationsLi Dongdong
2 shared publicationsLihe Qian
2 shared publicationsSun Weijie
2 shared publications
Latest Publications
- Open Access
- 29 August 2024
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 32, 3310-3317
Simultaneously enhancing the strength and ductility of Fe–Mn–C twinning-induced plasticity steel via Cr/N alloying
- 29 August 2024
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 32, 3310-3317
Open AccessSimultaneously enhancing the strength and ductility of Fe–Mn–C twinning-induced plasticity steel via Cr/N alloying
- Open Access
- 29 March 2024
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 30, 2086-2098
Effect of Al on the low cycle fatigue deformation behavior and microstructure evolution of Fe–22Mn-0.6C TWIP steel
- 29 March 2024
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 30, 2086-2098
Open AccessEffect of Al on the low cycle fatigue deformation behavior and microstructure evolution of Fe–22Mn-0.6C TWIP steel
- Open Access
Tensile Properties and Microstructure Evolutions of Low-Density Duplex Fe–12Mn–7Al–0.2C–0.6Si Steel
An austenite-ferrite duplex low-density steel (Fe–12Mn–7Al–0.2C–0.6Si, wt%) was designed and fabricated by cold rolling and annealing at different temperatures. The tensile properties, microstructure evolution, deformation mechanism and stacking fault energy (SFE) of the steel were systemically investigated at ambient temperature. Results show two phases of fine equiaxed austenite and coarse band-like δ-ferrite in the microstructure of the steel. With increasing annealing temperature, the yield and tensile strengths decrease while the total elongation increases. At initial strains, the deformation is mainly concentrated in the fine austenite and grain boundaries of the coarse δ-ferrite, and the interior of the coarse δ-ferrite gradually deforms with further increase in the strain to 0.3. No twinning-induced plasticity (TWIP) or transformation-induced plasticity (TRIP) occurred during the tensile deformation. Considering element segregation and two-phase proportion, the chemical composition of austenite was measured more precisely. The SFE of the austenite is 39.7 mJ/m2, and the critical stress required to produce deformation twins is significantly higher than the maximum flow stress of the steel.
Open AccessTensile Properties and Microstructure Evolutions of Low-Density Duplex Fe–12Mn–7Al–0.2C–0.6Si Steel
An austenite-ferrite duplex low-density steel (Fe–12Mn–7Al–0.2C–0.6Si, wt%) was designed and fabricated by cold rolling and annealing at different temperatures. The tensile properties, microstructure evolution, deformation mechanism and stacking fault energy (SFE) of the steel were systemically investigated at ambient temperature. Results show two phases of fine equiaxed austenite and coarse band-like δ-ferrite in the microstructure of the steel. With increasing annealing temperature, the yield and tensile strengths decrease while the total elongation increases. At initial strains, the deformation is mainly concentrated in the fine austenite and grain boundaries of the coarse δ-ferrite, and the interior of the coarse δ-ferrite gradually deforms with further increase in the strain to 0.3. No twinning-induced plasticity (TWIP) or transformation-induced plasticity (TRIP) occurred during the tensile deformation. Considering element segregation and two-phase proportion, the chemical composition of austenite was measured more precisely. The SFE of the austenite is 39.7 mJ/m2, and the critical stress required to produce deformation twins is significantly higher than the maximum flow stress of the steel.
- Open Access
- 1 November 2021
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 15, 6387-6394
Effect of grain size on dynamic strain aging behavior of C-bearing high Mn twinning-induced plasticity steel
- 1 November 2021
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 15, 6387-6394
Open AccessEffect of grain size on dynamic strain aging behavior of C-bearing high Mn twinning-induced plasticity steel
- 24 January 2020
- Published by Springer Nature
- p. 531-540
Effect of Intercritical Heat Treatment on Microstructure and Mechanical Properties of Sn Bearing 33MnCrB5 Steel
- 24 January 2020
- Published by Springer Nature
- p. 531-540
Effect of Intercritical Heat Treatment on Microstructure and Mechanical Properties of Sn Bearing 33MnCrB5 Steel