Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Wajahat Ali has a total of 43 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Scalable VCSEL-Array Optical Wireless Transmitter With Experimental Multi-Beam Prototype

    by Yi Liu, Wajahat Ali, Rui Chen, Nikolaos Bamiedakis, Ian H. White, Harald Haas, Michael Crisp, Richard V. Penty

    A 5 × 5 VCSEL array-based optical wireless communication multi-beam transmitter is designed and simulated. Each element of the array addresses a separate spatial attocell. A microlens-array based homogenizer achieves uniform coverage at the receiver plane from each multi-mode VCSEL output. 1 m2 total coverage is achieved with each attocell covering an area of 400 cm2 at a range of 3 m. For a proof-of-concept demonstration a 1 × 3 channel VCSEL array-based transmitter prototype is experimentally tested. The performance is verified by demonstrating three channels achieving ∼0.12 mW/m2 uniform power with negligible optical interference to adjacent attocells (<−14 dB). With a simple receiver design using low cost, off-the-shelf components, each channel of the transmitter achieves ∼10 Gb/s throughput using OFDM within 7 cm lateral range and >4 Gb/s within 12 cm lateral range at 3 m. The transmitter meets eye-safety restrictions and could be scaled to 250 Gb/s aggregate data rate by employing all 25 VCSELs with independent OFDM modulation.

  • Linearization of Directly Modulated Lasers for Enhanced Optical Wireless Communication

    by Yee Hui Low, Wajahat Ali, Michael Crisp, Richard V. Penty

    The demand for high-speed optical wireless communication (OWC) has surged due to the growing number of high bandwidth applications. Directly modulated lasers (DMLs) are a necessary alternative to light-emitting diodes (LEDs) for achieving higher speeds. However, at high data rates, the intrinsic non-linearity of DMLs degrades signal quality, limiting achievable data rates. We demonstrate the application of the ABCD linearization technique to a 2.5 GHz blue laser employing non-return-to-zero (NRZ) and carrierless amplitude/ phase (CAP) modulation. Using a 3.5 GHz PIN photodetector and feed-forward equalizer (FFE), this method improves the achievable data rate by ~1.8 times for NRZ, from 3.8 Gb/s to 7 Gb/s, and by $2.3\times $ for CAP-16, achieving 9 Gb/s. These results validate the ABCD approximation method as a simple yet effective solution for mitigating laser non-linearity and enhancing data rates in high-speed OWC systems.


  • Open Access

    Indoor Laser-Based Wireless Communications

    by Ahmad Adnan Qidan, Mohammad Dehghani Soltani, Wajahat Ali, Rui Chen, Shenjie Huang, Barzan Yosuf, Sanaa Mohamed, Ravinder Singh, Yi Liu, Hossein Kazemi, et al.

    Optical wireless communication (OWC) is a strong candidate in the sixth generation (6G) of wireless communications as it can support data transmission at high communication speeds, low power consumption, high security, and high reliability. Near-infrared lasers, specifically vertical cavity surface emitting lasers (VCSELs), exhibit larger modulation bandwidth compared to light-emitting diodes (LEDs), and can provide aggregate data rates ranging up to Terabit per second (Tbps). This chapter proposes innovative optical transmitter and receiver designs for indoor laser-based wireless communications, aiming to provide seamless coverage in high-speed multi-user scenarios. The proposed optical transmitter is based on a 55 VCSEL array where each VCSEL can provide 10 Gigabit per second (Gbps) in a uniform coverage area of 20cm x 20cm, achieving a total of 250 Gbps in an area of 1 m2 at 3m transmission distance. Moreover, two wide-FOV receiver designs that employ photodetector (PD) arrays in along with imaging or non-imaging optics are introduced to support such an ultra-high-speed optical link. The new design of OWC requires potential techniques to address various networking challenges, including cell formation, interference management, resource allocation, and backhauling. To this end, potential solutions for these challenges are discussed to help establish an end-to-end OWC infrastructure for practical deployment.


  • Open Access

    Advances in Visible Light Communication

    by Cuiwei He, Wajahat Ali

    Visible light communications (VLC) have been a highly popular area of research in recent years


  • 8.2 Gbps Optical Wireless Link Using SiPM at NIR Wavelength

    by Wajahat Ali, Rui Chen, Michael Crisp, Richard V. Penty

    Silicon Photomultipliers (SiPMs) can provide optical wireless communication (OWC) receivers with better sensitivities than PIN photodiodes, thanks to their photon counting capabilities. The commercial availability of SiPM with fast output pulse width allows high-speed data transmission at low irradiance levels. This article investigates the use of a commercially available SiPM with an active area of 1 mm 2 and fast output pulse width of 0.6 ns in a Near-infrared (NIR) OWC link and compares the performance of a 3 mm x 3 mm SiPM with a fast output pulse width of 1.4 ns. Although both SiPMs have maximum detection efficiency at 450 nm, a wavelength of 850 nm is used owing to the availability of high-speed VCSELs, higher eye safety limit and ability to filter ambient light when using this wavelength. The OWC link is designed and tested at a 35 cm transmission distance using On-Off-Keying (OOK) and Decision Feedback Equalization (DFE), and a maximum data rate of 8.2 Gbps at a BER of 3.8 × 10 −3 was obtained with 15.34 W/m 2 irradiance at the SiPM. These results are achieved in the dark and under 500 lux of White Light Emitting Diode (WLED) ambient light. A long pass colour glass filter is used to reject light up to 700 nm wavelength, thus rejecting most of the interference from WLEDs, resulting in data rates similar to dark environments. This is the highest data rate achieved using SiPMs in an NIR link.


  • Open Access

    A Comparison of VLC Receivers That Incorporate Two Different SiPMs

    by Zubair Ahmed, Wajahat Ali, Grahame Faulkner, Steve Collins

    Previously, when selecting silicon photomultipliers (SiPMs) for use in visible light communications (VLC) systems the bandwidth of the SiPM has been a high priority. However, results of experiments on VLC receivers containing two different sizes of commercially available SiPMs show that, if equalization is used and the OOK bit time is less than one third of the duration of its output pulses, the SiPMs bandwidth doesn't significantly impact the receiver's performance. Consequently, for these data rates the criteria used to select which SiPM to incorporate in VLC receivers should put a higher priority on their area and photon detection efficiency than on their bandwidth. In addition, for these data rates, unless the SiPM becomes non-linear, the performance of a receiver containing a SiPM can be predicted based upon Poisson statistics


  • A Digital Pre-Equalizer For Optical Wireless Links

    by Atchutananda Surampudi, Ravinder Singh, Amna Riaz, Wajahat Ali, Grahame Faulkner, Dominic OaBrien, Steve Collins

    The range of transmitters, detectors and other components that can be used in optical wireless links means that they can have a wide variety of frequency responses. Both pre- and post- equalization have been used in optical wireless systems to increase data rates. Pre-equalization has the advantage that noise impairments due to equalization can be minimised. However, the variety of pre-equalizer transfer functions, which can be easily created using analog circuits, is limited by the frequency responses of these circuits. Consequently, it may not be possible to equalize some optical wireless links with analog circuit-based pre-equalizers. In this paper a flexible digital pre-equalization scheme that can equalize complex frequency responses is described. The flexibility and the applicability of the scheme is also demonstrated using two example systems, including one that incorporates a fluorescent optical fiber to create a wide-field-of-view receiver for handheld devices. In particular, the bandwidths of the two example systems have been increased to over 500 MHz and to 350 MHz, resulting in at least a three-fold increase in data rate without any post-equalization. The authors believe that this is the first time such significant improvements in on-off-keying data rates have been demonstrated in systems with a relatively complex frequency response and a limited dynamic range.


  • Open Access

    Giga-Bit Transmission Between an Eye-Safe Transmitter and Wide Field-of-View SiPM Receiver

    by Wajahat Ali, Grahame Faulkner, Zubair Ahmed, William Matthews, Steve Collins

    In this paper, the performance of a wide field of view VLC receiver that includes a silicon photomultiplier (SiPM) is reported. In particular, a receiver field of view of ±45° and On-Off keying data rates of 1.8 Gbps are demonstrated in 500 lux of ambient light. These results are achieved by combining optical absorption filters with a 6 mm by 6 mm SiPM. By absorbing ambient light between 450 nm and 750 nm these filters ensure that the SiPM is not saturated and reduces the transmitter power needed to support the required data rate. Unlike other optical filters the performance of absorption filters is not sensitive to angle of incidence. Consequently, the FOV is explained by a combination of the changes to the receiver’s projected area, the path length of light in the filters and reflections from the filter surfaces. In addition, the results of the calculations, described by the IEC 62471:2006 safety standard, needed to determine the eye safety of a transmitter are reported. These calculations and the resulting irradiance levels available in a representative office scenario are used to show that data rates of more than 1 Gbps could be achieved with eye safe transmitters.


  • The Impact of the Length of Fluorescent Fiber Concentrators on the Performance of VLC Receivers

    by W. Ali, Z. Ahmed, W. Matthews, S. Collins

    Fluorophore doped plastic optical fibers can be used to create optical concentrators in receivers for visible light communications, that also act as wide field of view filters. Increasing the length of these fibers allows them to collect more of the signal from the transmitter, however, it can also reduce the bandwidth of the fiber. Results are presented from 3 different lengths of fiber which show that the best length of a fluorescent fiber depends upon the data rate. However, a simple calculation results in a length that is a good choice for a range of OOK data rates.


  • A Gigabit VLC Receiver That Incorporates a Fluorescent Antenna and a SiPM

    by Wajahat Ali, Pavlos P. Manousiadis, Dominic C OaBrien, Graham A Turnbull, Ifor D. W. Samuel, Steve Collins

    In this paper we demonstrate a novel optical receiver for visible light communications that combines a fluorescent antenna and a silicon photomultiplier (SiPM). The fluorescent antenna is configured in a slab geometry to collect and absorb an incoming optical data signal, and to waveguide the resulting fluorescence to an edge where it is detected by the SiPM. The antenna incorporates the fluorophore, pentafluorene, selected for its very high bandwidth of 245 MHz, high photoluminescence quantum yield of 90%, and emission spectrum that matches the wavelengths most efficiently detected by the SiPM. The performance of a receiver, comprising the fluorescent antenna and a J-series 30020 SiPM manufactured by ON Semiconductor, was assessed in a 30 cm data link with a 405 nm GaN laser diode transmitter, both in the dark and under 500 lux of ambient white light. The fluorescent antenna successfully rejects ambient light by a factor of 20, limited by extrinsic scattering in the thin film. Using on-off-keying with decision feedback equalization, a maximum data rate of 1.4 Gbps was demonstrated in 500 lux of ambient light. Using the pentafluorene antenna plus a BG3 filter, provides a 200 fold suppression of ambient light, and can increase the data rate of the receiver at low signal powers by up to a factor of 2. When operating in ambient light the composite receiver requires only 2.5 times more signal power than when it operates in the dark, with this power penalty reducing to a factor of 1.2 at 1 Gbps.