Arezoo Mahmoudi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Arezoo Mahmoudi has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Seyyed Alireza Mousavi
Department of Environmental Health Engineering, School of Public Health, Kermanshah University of Medical Sciences, Kermanshah, Iran
4 shared publications - Parastoo Darvishi
Kermanshah Univ Med Sci, Sch Publ Hlth, Dept Environm Hlth Engn, Kermanshah, Iran
3 shared publications - Danial Nayeri
Department of Environmental Health Engineering, School of Public Health, Kermanshah University of Medical Sciences, Kermanshah, Iran
1 shared publication - Davood Shahbazi
Department of Environmental Health EngineeringAnd Research Center for Environmental Determinants of Health (RCEDH)School of Public HealthKermanshah University of Medical SciencesKermanshahIran
1 shared publication Elham Noori
Kermanshah Univ Med Sci, Sch Publ Hlth, Dept Environm Hlth Engn, Kermanshah, Iran
1 shared publication- Elham Noori
Department of Environmental Health, School of Public Health, and Research Center for Environmental Determinants of Health (RCEDH), Kermanshah University of Medical Sciences, Kermanshah, Iran
1 shared publication
Latest Publications
- Open Access
- 10 April 2022
- Published by Springer Nature in Applied Water Science
- Vol. 12 (5) , 1-11
Methylene blue removal using grape leaves waste: optimization and modeling
The present study focuses on the preparation of activated carbon (AC) from grape leaves as a low cost, non-toxic, efficient and available adsorbent for the removal of methylene blue (MB) from aqueous solution. The experimental design and data modeling have been carried out using response surface methodology (RSM) through DoE software version 8.0.0. The effect of independent variables including initial dye concentration (100–500 mg/L), pH (3–11), contact time (10–90 min) and adsorbent dosage (0.25–12.25 g/L) on dye removal was determined using the response surface methodology (RSM). The results of analysis of variance (ANOVA) displayed high R2 value of 0.91% for dye removal that shows the developed model has acceptable accuracy. The highest removal efficiency of MB (97.4%) was obtained at optimum condition (pH: 11, adsorbent dosage 12.5 g/L, MB concentration 100 mg/L and contact time 90 min). The results indicated that the initial dye concentration and adsorbent dosage play an important role in increasing the adsorbent efficiency for adsorption of MB. The equilibrium data onto the adsorption of MB were measured using Langmuir and Freundlich, isotherm models. The experimental data obtained follow the Langmuir model (R2 = 0.88). In addition, the second-order kinetic model is more consistent with the adsorption data.
- 10 April 2022
- Published by Springer Nature in Applied Water Science
- Vol. 12 (5) , 1-11
Open AccessMethylene blue removal using grape leaves waste: optimization and modeling
The present study focuses on the preparation of activated carbon (AC) from grape leaves as a low cost, non-toxic, efficient and available adsorbent for the removal of methylene blue (MB) from aqueous solution. The experimental design and data modeling have been carried out using response surface methodology (RSM) through DoE software version 8.0.0. The effect of independent variables including initial dye concentration (100–500 mg/L), pH (3–11), contact time (10–90 min) and adsorbent dosage (0.25–12.25 g/L) on dye removal was determined using the response surface methodology (RSM). The results of analysis of variance (ANOVA) displayed high R2 value of 0.91% for dye removal that shows the developed model has acceptable accuracy. The highest removal efficiency of MB (97.4%) was obtained at optimum condition (pH: 11, adsorbent dosage 12.5 g/L, MB concentration 100 mg/L and contact time 90 min). The results indicated that the initial dye concentration and adsorbent dosage play an important role in increasing the adsorbent efficiency for adsorption of MB. The equilibrium data onto the adsorption of MB were measured using Langmuir and Freundlich, isotherm models. The experimental data obtained follow the Langmuir model (R2 = 0.88). In addition, the second-order kinetic model is more consistent with the adsorption data.
- Open Access
- 1 January 2021
- Published by SAGE Publications in Adsorption Science & Technology
- Vol. 2021
Statistical Modeling and Kinetic Studies on the Adsorption of Reactive Red 2 by a Low-Cost Adsorbent: Grape Waste-Based Activated Carbon Using Sulfuric Acid Activator-Assisted Thermal Activation
The efficiency of activated carbon produced from grape waste as a low-cost, nontoxic, and available adsorbent to remove Reactive Red 2 from aqueous solution has been investigated. The prepared activated carbon has been characterized by FTIR, SEM, and BET. The results of characterization indicate the successful conversion of grape waste into mesoporous AC with desirable surface area consist of different functional groups. The results of statistical modeling displayed high value of 0.97% for dye removal that shows the developed model has acceptable accuracy. The effect of independent variables indicated that the highest adsorption (96.83%) obtained at pH 3, adsorbent dosage of 12.25 g/L, and initial dye concentration of 100 mg/L when the adsorption time was 90 min. The results of isotherms modeling showed that the data fit well with the Langmuir (type II). The kinetic studies using pseudofirst-order and pseudosecond-order models pointed out that the type (I) of pseudosecond-order kinetic model provided the best fit to the adsorption data. Parameters of thermodynamics including Gibbs energy () and were calculated. The values of indicated that the dye adsorption of RR2 is spontaneous. The agricultural wastes due to special points such as low-cost, availability, and high ability to produce an adsorbent with high efficiency to remove dye can be proposed for water and wastewater treatment.
- 1 January 2021
- Published by SAGE Publications in Adsorption Science & Technology
- Vol. 2021
Open AccessStatistical Modeling and Kinetic Studies on the Adsorption of Reactive Red 2 by a Low-Cost Adsorbent: Grape Waste-Based Activated Carbon Using Sulfuric Acid Activator-Assisted Thermal Activation
The efficiency of activated carbon produced from grape waste as a low-cost, nontoxic, and available adsorbent to remove Reactive Red 2 from aqueous solution has been investigated. The prepared activated carbon has been characterized by FTIR, SEM, and BET. The results of characterization indicate the successful conversion of grape waste into mesoporous AC with desirable surface area consist of different functional groups. The results of statistical modeling displayed high value of 0.97% for dye removal that shows the developed model has acceptable accuracy. The effect of independent variables indicated that the highest adsorption (96.83%) obtained at pH 3, adsorbent dosage of 12.25 g/L, and initial dye concentration of 100 mg/L when the adsorption time was 90 min. The results of isotherms modeling showed that the data fit well with the Langmuir (type II). The kinetic studies using pseudofirst-order and pseudosecond-order models pointed out that the type (I) of pseudosecond-order kinetic model provided the best fit to the adsorption data. Parameters of thermodynamics including Gibbs energy () and were calculated. The values of indicated that the dye adsorption of RR2 is spontaneous. The agricultural wastes due to special points such as low-cost, availability, and high ability to produce an adsorbent with high efficiency to remove dye can be proposed for water and wastewater treatment.
- 1 January 2021
- Published by Desalination Publications in Desalination and Water Treatment
- Vol. 211, 99-104
Bio-electrochemical treatment of wastewater with high ammonium concentration
- 1 January 2021
- Published by Desalination Publications in Desalination and Water Treatment
- Vol. 211, 99-104
Bio-electrochemical treatment of wastewater with high ammonium concentration
- Open Access
- 1 October 2019
- Published by Elsevier in Desalination and Water Treatment
- Vol. 166, 180-185
Evaluation of water quality and stability in the drinking water distribution network: A case study in the Kermanshah city, Iran
- 1 October 2019
- Published by Elsevier in Desalination and Water Treatment
- Vol. 166, 180-185
Open AccessEvaluation of water quality and stability in the drinking water distribution network: A case study in the Kermanshah city, Iran